《Onkyo-SR600-av-sm维修电路原理图.pdf》由会员分享,可在线阅读,更多相关《Onkyo-SR600-av-sm维修电路原理图.pdf(63页珍藏版)》请在收音机爱好者资料库上搜索。
1、BMDD,BMDC120V AC, 60Hz BMPP,BMPA,SMPP,GMPA230240V AC, 50Hz BMWT,GMWT,GMWR,GMWQ120/220230V AC, 50/60Hz GMGK220V AC, 50Hz 0 TX-SR600/E SERVICE MANUALSERVICE MANUAL AV RECEIVER Black, Golden and Silver models MODEL TX-SR600/E Ref. No. 3730 052002 RC-480M SAFETY-RELATED COMPONENT WARNING! COMPONENTS IDE
2、NTIFIED BY MARK ON THE SCHEMATIC DIAGRAM AND IN THE PARTS LIST ARE CRITICAL FOR RISK OF FIRE AND ELECTRIC SHOCK. REPLACE THESE COMPONENTS WITH ONKYO PARTS WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL. MAKE LEAKAGE-CURRENT OR RESISTANCE MEASUREMENTS TO DETERMINE THAT EXPOSED PARTS ARE ACCEPTABLY
3、 INSULATED FROM THE SUPPLY CIRCUIT BEFORE RETURNING THE APPLIANCE TO THE CUSTOMER. RadioFans.CN 收音机爱 好者资料库 AMPLIFIER SECTION Continuous average power output (FTC) All channels:80 W per channel min. RMS at 8 ohm, 2 channels driven from 20 Hz to 20 kHz with no more than 0.08% total harmonic distortion
4、. 105 W min. RMS at 6 ohm, 2 channels driven from 1 kHz with no more than 0.1% total harmonic distortion. Continuous power output (DIN)115 W at 6 ohm Maximum power output (EIAJ)145 W at 6 ohm Dynamic power output (stereo)2 215 W at 3 ohm 2 160 W at 4 ohm 2 95 W at 8 ohm Total harmonic distortion:0.0
5、8% at rated power 0.08% at 1 W output IM distortion:0.08% at rated power 0.08% at 1 W output Damping factor:60 at 8 ohm Input sensitivity and impedance LINE (CD, TAPE, DVD, VIDEO 1-4):200 mV, 47 k ohm MULTICHANNEL INPUT (FRONT L/C/R, SURROUND L/R):200 mV, 47 k ohm (SUBWOOFER):36 mV, 47 k ohm COAXIAL
6、 (DIGITAL):0.5 Vp-p, 75 ohm DVD, VIDEO 1, 2, 3, 4:1 Vp-p, 75 ohm 1 Vp-p, 75 ohm (Y) 0.28 Vp-p, 75 ohm (C) COMPONENT VIDEO 1, 2:1 Vp-p, 75 ohm (Y) 0.7 Vp-p, 75 ohm (PB, PR) Output level and impedance Rec out (TAPE, VIDEO 1):200 mV, 470 ohm Pre out:1 V, 470 ohm VIDEO (VIDEO 1, MONITOR OUT):1 Vp-p, 75
7、ohm 1 Vp-p, 75 ohm (Y) 0.28 p-p, 75 ohm (C) COMPONENT VIDEO OUT:1 Vp-p, 75 ohm (Y) 0.7 Vp-p, 75 ohm (PB, PR) Frequency response:10 Hz to 100 kHz:+1/-3 dB (CD in Direct mode) Tone control Bass:12 dB at 50 Hz Treble:12 dB at 20,000 Hz Signal-to-noise ratio (stereo) CD/Tape:100 dB (IHF A, 0.5 V input)
8、Muting:-50 dB TUNER SECTION FM Tuning range:87.5 -108.0 MHz (50-kHz steps) Usable sensitivity Mono:11.2 dBf, 1.0 V (75 ohm IHF) 0.9 V (75 ohm DIN) Stereo:17.2 dBf, 2.0 V (75 ohm IHF) 23 V (75 ohm DIN) 50 dB quieting sensitivity Mono:17.2 dBf, 2.0 V (75 ohm ) Stereo:37.2 dBf, 20 V (75 ohm ) Capture r
9、atio:2.0 dB Image rejection ratio USA & Canadian models:40 dB Other area models:85 dB IF rejection ratio:90 dB Signal-to-noise ratio Mono:76 dB Stereo:70 dB Alternate channel attenuation:55 dB Selectivity:50 dB (DIN) AM suppression ratio:50 dB Total harmonic distortion Mono:0.2% Stereo:0.3% Frequenc
10、y response:30 Hz -15 kHz, 1.0 dB Stereo separation:45 dB at 1 kHz 30 dB at 100 Hz - 10 kHz AM Tuning range USA & Canadian models:530 to 1,710 kHz (10-kHz steps) European & Australian models:522 to 1,611 kHz (9-kHz steps) Worldwide models:531 to 1,602 kHz (9-kHz steps) 530 to 1,710 kHz (10-kHz steps)
11、 Usable sensitivity:30 V Image rejection ratio:40 dB IF rejection ratio:40 dB Signal-to-noise ratio:40 dB Total harmonic distortion:0.7% GENERAL Power supply USA & Canadian models:AC 120 V, 60 Hz European & Australian models: AC 230 -240 V, 50 Hz Some Asian models:AC 220 -230 V, 50/60 Hz Worldwide m
12、odels:AC 220 -230 and 120 V switchable, 50/60 Hz Power consumption USA & Canadian models:5.5 A Other models:450 W Dimensions (W H D):435 175 431.5 mm 17-1/8 6-7/8 16-15/16 Weight USA & Canadian models:24.5 lbs. Other models:12.1 kg REMOTE CONTROLLER Transmitter:Infrared Signal range:Approx. 16 ft.,
13、5 meters Power supply:Two AA batteries (1.5 V 2) Specifications and features are subject to change without notice. RIAA deviation:20 Hz to 20 kHz:0.8 dB TX-SR600/E SPECIFICATIONS RadioFans.CN 收音机爱 好者资料库 L 27122965 REMOTE CONTROL CAUTION: SPEAKER IMPEDANCE 6 OHMS MIN. /SPEAKER ANTENNA FM 75 AM COAXIA
14、LOPTICAL1 2 ININININFRONTSURRCENTER SUB WOOFERVIDEO 2VIDEO 1 OUT DIGITAL INPUTDVDMONITOR OUT DVD TAPECD SUBWOOFER PRE OUT L R FRONT SPEAKERS SURROUND SPEAKERS CENTER SPEAKER R L R L R VIDEO 3 VIDEO 2VIDEO 3VIDEO 1 VIDEO OPTICAL ININININ DIGITAL OUTPUT IN INPUT 1INPUT 2OUTPUT COMPONENT VIDEO PR PB Y
15、OUT OUT AB SURROUND BACK SPEAKER DIGITAL INPUT L R R L S VIDEO AC OUTLETS AV RECEIVER MODEL NO. TX-SR600E SWITCHED TOTAL 100W MAX. AC 230-240 V 50 Hz 4. Memory Preservation This unit does not require memory preserv ation batteries. A built-in memory power back-up system preserves the contents of the
16、 memory during power f ailures and e ven when the unit is unplugged. The unit must be plugged in order to charge the back-up system. The memory preserv ation period after the unit has been unplugged varies depending on climate and placement of the unit. On the average, memory contents are protected
17、over a period of a few weeks after the last time the unit has been unplugged. This period is shorter when the unit is exposed to a highly humid climate. 2. To initialize the unit This device employs a microprocessor to perform various functions and operations. If interference generated by an externa
18、l power supply, radio wave, or other electrical source results in accident which causes the specified operations and functions to operate abnormally. To perform a result, please follow the procedure below. 1.Press and hold down the VIDEO-1 button, then press the STANDBY/ON button. 2.After clear is d
19、isplayed, the preset memory and each mode stored in the memory, such as surround, are initialized and will return to the factory setting. 3. Safety-check out (Only U.S.A. model) After correcting the original service problem, perform the following safety check before releasing the set to the customer
20、. Connect the insulating-resistance tester between the plug of power supply cord and screw on the back panel. Specifications: 3.3Mohm+/-10% at 500V. 1. Replacing the fuses This symbol located near the fuses indicates that the fuse used is fast operating type. For continued protection against fire ha
21、zard, replace with same type fuse. For fuse rating refer to the marking adjacent to the symbol. Ce symbole indique que le fusible utlise est a rapide. Pour une protection permanente, nuntiliser que fusibles de meme type. Ce darnier est la qu le present symbol est appse. CIRCUIT NO. PART NO. DESCRIPT
22、ION Note: :120V model only : Other models except 120V model : Asian model only for 230V : Chinese model only 5.Setting the voltage selector (Worldwide models only) Worldwide models are equipped with a voltage selector to conform with local power supplies. Be sure to set this switch to match the volt
23、age of the power supply in your area before plugging in the unit. Determine the proper voltage for your area: 220-230 V or 120 V. If the preset voltage is not correct for your area, insert a screwdriver into the groove in the switch. Slide the switch all the way to the upper (120 V) or to the lower
24、(220-230 V), whichever is appropriate. 6.Setting the AM tuning step frequency (Worldwide models only) F6901,F6902 F901 F902 F903 F9501 ONTSURRCENTER SUB WOOFERVIDEO 1 DVD L R SURROUND BACK R L PRE OUT OUT S IR IN AV RECEIVER MODEL NO. TX-SR700E 120 V 220-230 V 120 V VOLTAGE SELECTOR 220-230 V 1.Pres
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- Onkyo SR600 av sm 维修 电路 原理图