McIntosh-MX136-av-sm维修电路原理图.pdf
《McIntosh-MX136-av-sm维修电路原理图.pdf》由会员分享,可在线阅读,更多相关《McIntosh-MX136-av-sm维修电路原理图.pdf(55页珍藏版)》请在收音机爱好者资料库上搜索。
1、Performance Specifications . 2 - 3 Notes . 3 Rear Panel . 3 Section Location . 4 Block Diagram . 5 - 8 Interconnection Diagram . 9 - 11 Display Schematic and PCB . 12 - 19 Surround Schematic and PCB . 19 - 34 Data Schematic and PCB. 37 - 41 S-Video Schematic and PCB. 42 - 47 Video Schematic and PCB.
2、 48 - 50 Input Schematic and PCB . 51 - 56 Component Video Schematic and PCB . 57 - 60 Tuner AM/FM Alignment Procedure. 61 - 62 Tuner/RAA1 Schematic and PCB . 63 - 66 Balanced Schematic and PCB . 67 - 70 HDMI Module . 71 HDMI Power Supply . 72 Parts List . 73 - 90 Exploded Views and Parts Lists . 91
3、 - 94 CONTENTS SERVICE MANUAL Serial Number XM1001 And Above SERIAL NO. XM1001 And Above MX136 A/V CONTROL CENTER RadioFans.CN 收音机爱 好者资料库 PERFORMANCE SPECIFICATIONS 2 Audio Specifications Frequency Response Left, Center, Right, Left Surround, Right Surround, Left Back, Right Back: 0.5dB from 20Hz-20
4、,000Hz Subwoofer1: 0.5dB from 20Hz-140Hz Total Harmonic Distortion 0.005% maximum from 20Hz to 20,000Hz at rated output Signal To Noise Ratio Phono:86dB below 10mV input (A Weighted) High Level:96dB below rated output (A Weighted) Rated Output Voltage 2.5V Unbalanced Outputs (Main) 5.0V Balanced Out
5、puts (Main) Maximum Voltage Output 9.5V Unbalanced 19V Balanced Output Impedance 100 ohms Unbalanced 200 ohms Balanced Input Impedance Phono:47k Ohms, 65pf High Level:22k Ohms Unbalanced 50k Ohms Balanced Sensitivity for Rated Output Phono:5mV High Level:500mV Unbalanced 1V Balanced Maximum Input Si
6、gnal Phono:50mV High Level:5V Unbalanced 10V Balanced Voltage Gain Phono to Tape/VCR Out:40dB Phono to Output (Main):54dB High Level to Tape/VCR Out:0dB High Level to Output (Main):14dB Tone Controls Bass Control:12dB at 30Hz Treble Control:12dB at 10,000Hz General Specifications Power Requirements
7、100 Volts, 50/60Hz at 65 watts 110 Volts, 50/60Hz at 65 watts 120 Volts, 50/60Hz at 65 watts 220 Volts, 50/60Hz at 65 watts 230 Volts, 50/60Hz at 65 watts 240 Volts, 50/60Hz at 65 watts Note: Refer to the rear panel of the MX136 for the correct voltage. Overall Dimensions Width is 17-3/4 inches (45.
8、09cm) Height is 9-7/16 inches (23.97cm) including feet Depth is 18-3/4 inches (47.63cm) including the Front Panel and Knobs Weight 31 pounds (14.06Kg) net, 55 pounds (24.95Kg) shipping Shipping Carton Dimensions Width is 25 inches (63.5cm) Depth is 28 inches (71.12cm) Height is 18-3/8 inches (46.67c
9、m) FM Tuner Specifications Useable Sensitivity 14dBf which is 1.4uV across 75 ohms 50dB Quieting Sensitivity Mono:19dBf which is 2.4uV across 75 ohms Stereo:35dBf which is 15uV across 75 ohms Signal To Noise Ratio Mono:75dB Stereo:70dB Frequency Response Mono:+ 0, - 1dB from 20 to 15,000Hz Stereo:+
10、0, - 1dB from 20 to 15,000Hz Harmonic Distortion Mono:0.3% at 100Hz 0.3% at 1,000Hz 0.3% at 10,000Hz Stereo:0.45% at 100Hz 0.45% at 1,000Hz 0.65% at 10,000Hz Intermodulation Distortion Mono0.25% Stereo0.45% RadioFans.CN 收音机爱 好者资料库 PERFORMANCE SPECIFICATIONS cont MX136 1. The heavy lines on the schem
11、atic denote the primary signal path. 2. Unless otherwise noted, all voltages indicated on the schematics are measured under the following conditions: a. AC input at 120 volts, 50/60Hz. b. All voltages are +/-10% with respect to ground. A high impedance (10 megaohm) voltmeter must be used. 3. On PC b
12、oard drawings, Square pad indicates: a. Polarized Capacitors - Positive b. Diodes - Cathode c. Others - Pin 1 4. WARNING Parts marked with the symbol have critical characteristics. Use only replacement parts recom- mended by the manufacturer. NOTES REAR PANEL 3 Capture Ratio 1.2dB Alternate Channel
13、Selectivity 75dB Spurious Response 100dB Image Response 75dB RF Intermodulation 65dB Stereo Separation 45dB at 100Hz 45dB at 1,000Hz 35dB at 10,000Hz SCA Rejection 65dB AM Tuner Specifications Sensitivity 20uV External Antenna Input Signal To Noise Ratio 48dB at 30% modulation 58dB at 100% modulatio
14、n Harmonic Distortion 0.5% maximum at 50% modulation Frequency Response 50Hz to 6kHz NRSC Adjacent Channel Selectivity 45dB minimum IHF Image Rejection 65dB minimum from 540 to 1600kHz IF Rejection 80dB minimum RadioFans.CN 收音机爱 好者资料库 4 SECTION LOCATIONS BOTTOM VIEW WITH COVER REMOVED TOP VIEW WITH
15、COVER REMOVED RadioFans.CN 收音机爱 好者资料库 MX136 56 BLOCK DIAGRAM RadioFans.CN 收音机爱 好者资料库 78 BLOCK DIAGRAM cont RadioFans.CN 收音机爱 好者资料库 91110 INTERCONNECT MX136 1 RadioFans.CN 收音机爱 好者资料库 121413 DISPLAY 750565 SH 1 OF 22A BC RadioFans.CN 收音机爱 好者资料库 151716 DISPLAY 750565 SH 2 0F 2 MX136 2A BC RadioFans.CN
16、收音机爱 好者资料库 182019 2ASURROUND 750570 SH 1 OF 63 KEYBOARD SECTION 750568 2C LED SECTION 750569 2B DISPLAY CONTROL SECTION 750565 RadioFans.CN 收音机爱 好者资料库 SURROUND 750570 SH 2 OF 63 212322 MX136 RadioFans.CN 收音机爱 好者资料库 242625 3 SURROUND 750570 SH 3 OF 6 RadioFans.CN 收音机爱 好者资料库 MX136 2728 SURROUND 750570
17、 SCH 4 OF 63 RadioFans.CN 收音机爱 好者资料库 2930 SURROUND 750570 SCH 5 OF 63 RadioFans.CN 收音机爱 好者资料库 MX136 SURROUND 750570 SCH 6 OF 63 3132 RadioFans.CN 收音机爱 好者资料库 SURROUND 750570 PCB3 3334 RadioFans.CN 收音机爱 好者资料库 SURROUND 750570 PCB3 3334 RadioFans.CN 收音机爱 好者资料库 MX136 3536 NOTES RadioFans.CN 收音机爱 好者资料库 37
18、38 DATA 750562 SCH 1 OF 24 RadioFans.CN 收音机爱 好者资料库 394140 DATA 750562 SH 2 OF 24 MX136 RadioFans.CN 收音机爱 好者资料库 S-VIDEO 750564 SH 1 OF 25 424443 RadioFans.CN 收音机爱 好者资料库 454746 S-VIDEO 750564 SH 2 OF 25 MX136 RadioFans.CN 收音机爱 好者资料库 485049 VIDEO 7505636 RadioFans.CN 收音机爱 好者资料库 515352 INPUT 750561 SH 1
19、 OF 27 MX136 RadioFans.CN 收音机爱 好者资料库 545655 INPUT 750561 SH 2 OF 27INPUT 7505617 RadioFans.CN 收音机爱 好者资料库 COMPONENT VIDEO 7505668 575958 MX136 RadioFans.CN 收音机爱 好者资料库 TUNER ALIGNMENT PROCEDURE AM ALIGNMENT PROCEDURE 1.Connect an AM Signal Generator to the RAA1 ”EXT ANT” pin of the 5 pin connector. (R
20、efer to Page 66.) Connect a Distortion Analyzer to the MX135 rear panel TUNER IN/OUT RCA jacks. 2.Tune to bottom of band, and adjust T11 (AM OSC Coil) for 3.0VDC at R46. 3.Tune to top of band and adjust C64 (AM OSC Trimmer Capacitor) for 26.0VDC at Connector R46. 4.Repeat steps 4 and 5 as necessary
21、for a Tuning Voltage Range of 3.0 to 26.0VDC. 5.Tune the Generator and Tuner to 600kHz, then adjust Coils: T101 (AM ANT) and T12 (AM RF) for best sensitiv- ity. Note: Coil T101 (AM ANT) is located on the RAA1. It is labeled “L1”. 6.Tune the Generator and Tuner to 1400kHz, then adjust Trimmer Capacit
22、ors: C106 (AM ANT) and C61 (AM RF) for best sensitivity. Note: Trimmer Capacitor C106 (AM AMT) is located on the RAA1. It is labeled “C1”. 7.Repeat 8 and 9 until no improvement in sensitivity is noted. Figure 1 Note: Refer to Figure 1 while reading the below procedure. FM ALIGNMENT PROCEDURE 1.Conne
23、ct an FM Signal Generator to Antenna Input. 2.Connect Distortion Analyzer to the TUNER IN/OUT RCA jacks. 3.Remove Top Cover and AM/FM TUNER Cover. Turn On the AC rocker switch. Press the red Standby button to turn the unit On. 4.Select Tuner with the Zone A selector knob. Put Tuner into FM mode and
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- McIntosh MX136 av sm 维修 电路 原理图