McIntosh-MX135-av-sm维修电路原理图.pdf
《McIntosh-MX135-av-sm维修电路原理图.pdf》由会员分享,可在线阅读,更多相关《McIntosh-MX135-av-sm维修电路原理图.pdf(44页珍藏版)》请在收音机爱好者资料库上搜索。
1、SERVICE MANUAL Performance Specifications . 2 - 3 Notes . 3 Rear Panel . 3 Section Location . 4 Block Diagram . 5 - 8 Interconnection Diagram . 9 - 11 Display Schematic and PCB . 12 - 19 Surround Schematic and PCB . 19 - 34 Data Schematic and PCB. 37 - 41 S-Video Schematic and PCB. 42 - 47 Video Sch
2、ematic and PCB. 48 - 50 Input Schematic and PCB . 51 - 56 Component Video Schematic and PCB . 57 - 60 Tuner AM/FM Alignment Procedure. 61 - 62 Tuner/RAA1 Schematic and PCB . 63 - 66 Balanced Schematic and PCB . 67 - 70 Parts List . 71 - 90 Exploded Views and Parts Lists . 91 - 94 Repacking Instructi
3、on . 95 CONTENTS A/V CONTROL CENTER Serial Number VJ1001 And Above SERIAL NO. VJ1001 And Above RadioFans.CN 收音机爱 好者资料库 PERFORMANCE SPECIFICATIONS Audio Frequency Response Stereo: Left and Right Small speakers: 80Hz-20,000Hz Subwoofer: 20Hz-80Hz Left and Right Large speakers: 20Hz-20,000Hz Subwoofer:
4、 OFF Pro-Logic IIx: (Movie Processing Mode) Left, Center, Right, Small speakers: 80Hz-20,000Hz Surround Small speakers: 80Hz-20kHz Subwoofer: 20Hz-80Hz (Music Processing Mode) Left, Center, Right, Large speakers: 20Hz-20,000Hz Surround Large speakers: 20Hz-20,000Hz Subwoofer: OFF Dolby Digital and D
5、TS: Left, Center, Right, Small speakers: 80Hz-20,000Hz Surround Small speakers: 80Hz-20,000Hz Subwoofer: 20Hz-80Hz Left, Center, Right Large speakers: 20Hz-20,000Hz Surround Large speakers: 20Hz-20,000Hz Subwoofer: 20Hz-80Hz External Input Left, Center, Right, Left Surround, Right Surround: 20Hz-20,
6、000Hz Subwoofer: 20Hz-20kHz (no LP filtering) Rated Output All Modes: 2.0Vrms for full bit digital input Input Impedance 22k ohms Output Impedance 47 ohms at all outputs Maximum Output Voltage 9.5 Vrms Total Harmonic Distortion 0.005% at all outputs Sensitivity Analog Input: 400mV for 2.0V output Si
7、gnal To Noise Ratio All Outputs Greater than 90dB un-weighted. Greater than 100dB A weighted. Greater than 98dB CCIR. Maximum Input Signal Analog Input: 6Vrms Voltage Gain Analog Input to Output: 14dB Frequency Response +0, -0.5dB from 20Hz to 20,000Hz Tone Controls +12dB, -12dB from flat setting FM
8、 Tuner (TM1 option) Useable Sensitivity 14dBF which is 1.4uV across 75 ohms 50dB Quieting Sensitivity Mono: 19dBF which is 2.4uV across 75 ohms Stereo: 35dBF which is 15uV across 75 ohms Signal To Noise Ratio Mono: 75dB Stereo: 70dB Frequency Response Mono: +0, -1dB from 20 to 15,000Hz Stereo: +0, -
9、1dB from 20 to 15,000Hz Harmonic Distortion Mono: 0.3% at 100Hz, 0.3% at 1,000Hz, 0.3% at 10,000Hz Stereo: 0.45% at 100Hz, 0.45% at 1,000Hz, 0.65% at 10,000Hz Intermodulaton Distortion Mono: 0.25% Stereo: 0.45% Capture Ratio 1.2dB Alternate Channel Selectivity 75dB Spurious Response 100dB Image Resp
10、onse 75dB RF Intermodulation 65dB Stereo Separation 45dB at 100Hz, 45dB at 1,000Hz, 35dB at 10,000Hz SCA Rejection 65dB 2 RadioFans.CN 收音机爱 好者资料库 General Specifications Power Requirements 100 Volts, 50/60Hz at 65 watts 110 Volts, 50/60Hz at 65 watts 120 Volts, 50/60Hz at 65 watts 220 Volts, 50/60Hz
11、at 65 watts 230 Volts, 50/60Hz at 65 watts 240 Volts, 50/60Hz at 65 watts NOTE: Refer to the rear panel of the MX135 for the correct voltage. Overall Dimensions Front Panel: 17-1/2 inches (44.5cm) wide, 9-7/16 inches (23.97cm) high. Depth behind front mounting panel is 19 inches (48.26cm) including
12、clearance for connectors. Panel clearance required in front of mounting panel is 1-1/8 inches (2.9cm). Weight 31.5 pounds (14.3kg) net, 55 pounds (25kg) shipping weight PERFORMANCE SPECIFICATIONS cont MX135 AM Tuner (TM1 option) Sensitivity 20uV external antenna input Signal To Noise Ratio 48dB at 3
13、0% modulation 58dB at 100% modulation Harmonic Distortion 0.5% maximum at 50% modulation Frequency Response 50Hz to 6kHz NRSC Adjacent Channel Selectivity 45dB minimum IHF Image Rejection 65dB minimum from 540 to 1600kHz IF Rejection 80dB minimum 1. The heavy lines on the schematic denote the primar
14、y signal path. 2. Unless otherwise noted, all voltages indicated on the schematics are measured under the following conditions: a. AC input at 120 volts, 50/60Hz. b. All voltages are +/-10% with respect to ground. A high impedance (10 megaohm) voltmeter must be used. 3. On PC board drawings, Square
15、pad indicates: a. Polarized Capacitors - Positive b. Diodes - Cathode c. Others - Pin 1 4. WARNING Parts marked with the symbol have critical characteristics. Use only replacement parts recom- mended by the manufacturer. NOTES REAR PANEL 3 RadioFans.CN 收音机爱 好者资料库 4 SECTION LOCATIONS BOTTOM VIEW WITH
16、 COVER REMOVED TOP VIEW WITH COVER REMOVED RadioFans.CN 收音机爱 好者资料库 56 MX135 BLOCK DIAGRAM RadioFans.CN 收音机爱 好者资料库 78 BLOCK DIAGRAM cont RadioFans.CN 收音机爱 好者资料库 91110 INTERCONNECT MX135 1 RadioFans.CN 收音机爱 好者资料库 121413 DISPLAY 050036 SH 1 OF 22A BC RadioFans.CN 收音机爱 好者资料库 151716 DISPLAY 050036 SH 2 0
17、F 2 MX135 2A BC RadioFans.CN 收音机爱 好者资料库 182019 2ASURROUND 050037 SH 1 OF 63 KEYBOARD SECTION 050053 2C LED SECTION 050054 2B DISPLAY CONTROL SECTION 050036 RadioFans.CN 收音机爱 好者资料库 SURROUND 050037 SH 2 OF 63 212322 MX135 RadioFans.CN 收音机爱 好者资料库 242625 3 SURROUND 050037 SH 3 OF 6 RadioFans.CN 收音机爱 好者资
18、料库 2728 SURROUND 050037 SECTION 4 OF 63 MX135 RadioFans.CN 收音机爱 好者资料库 2930 SURROUND 050037 SH 5 OF 63 RadioFans.CN 收音机爱 好者资料库 SURROUND 050037 SH 6 OF 63 3132 MX135 RadioFans.CN 收音机爱 好者资料库 SURROUND 0500373 3334 RadioFans.CN 收音机爱 好者资料库 NOTES 3536 MX135 RadioFans.CN 收音机爱 好者资料库 DATA 050033 SH 1 OF 24 37
19、38 RadioFans.CN 收音机爱 好者资料库 394140 DATA 050033 SH 2 OF 24 MX135 RadioFans.CN 收音机爱 好者资料库 S-VIDEO 050035 SH 1 OF 25 424443 RadioFans.CN 收音机爱 好者资料库 454746 S-VIDEO 050035 SH 2 OF 25 MX135 RadioFans.CN 收音机爱 好者资料库 485049 VIDEO 0500346 RadioFans.CN 收音机爱 好者资料库 515352 INPUT 050032 SH 1 OF 27 MX135 RadioFans.C
20、N 收音机爱 好者资料库 545655 INPUT 050032 SH 2 OF 27INPUT 0501637 RadioFans.CN 收音机爱 好者资料库 COMPONENT VIDEO 0500398 MX135 575958 RadioFans.CN 收音机爱 好者资料库 TUNER ALIGNMENT PROCEDURE AM ALIGNMENT PROCEDURE 1.Connect an AM Signal Generator to the RAA1 ”EXT ANT” pin of the 5 pin connector. (Refer to Page 66.) Connec
21、t a Distortion Analyzer to the MX135 rear panel TUNER IN/OUT RCA jacks. 2.Tune to bottom of band, and adjust T11 (AM OSC Coil) for 3.0VDC at R46. 3.Tune to top of band and adjust C64 (AM OSC Trimmer Capacitor) for 26.0VDC at Connector R46. 4.Repeat steps 4 and 5 as necessary for a Tuning Voltage Ran
22、ge of 3.0 to 26.0VDC. 5.Tune the Generator and Tuner to 600kHz, then adjust Coils: T101 (AM ANT) and T12 (AM RF) for best sensitiv- ity. Note: Coil T101 (AM ANT) is located on the RAA1. It is labeled “L1”. 6.Tune the Generator and Tuner to 1400kHz, then adjust Trimmer Capacitors: C106 (AM ANT) and C
23、61 (AM RF) for best sensitivity. Note: Trimmer Capacitor C106 (AM AMT) is located on the RAA1. It is labeled “C1”. 7.Repeat 8 and 9 until no improvement in sensitivity is noted. Figure 1 Note: Refer to Figure 1 while reading the below procedure. FM ALIGNMENT PROCEDURE 1.Connect an FM Signal Generato
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- McIntosh MX135 av sm 维修 电路 原理图