《HarmanKardon-HKTS2-htss-sm维修电路原理图.pdf》由会员分享,可在线阅读,更多相关《HarmanKardon-HKTS2-htss-sm维修电路原理图.pdf(23页珍藏版)》请在收音机爱好者资料库上搜索。
1、Harman/Kardon Incorporated 250 Crossways Park Dr. Woodbury, New York 11797 Rev5 12/2004 HKTS 2 Home Theater Speaker System SERVICE MANUAL RadioFans.CN TABLE OF CONTENTS BASIC SYSTEM SPECIFICATIONS . . . . . . . . . . . . . . . . . . . . . . .3 DETAILED HKTS 2 SPECIFICATIONS . . . . . . .4 CONNECTION
2、S . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 OPERATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8 TROUBLESHOOTING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9 MECHANICAL/PACKAGING PARTS LIST . . . .
3、 . . . . . . . . . . . . . .10 EXPLODED VIEW . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .11 TEST SET UP and PROCEDURE . . . . . . . . . . . . . . . . . . . . . . . . .12 PACKAGING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .13 ELECT
4、RICAL PARTS LIST . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .14 INTEGRATED CIRCUIT DIAGRAMS . . . . . . .17 PRINTED CIRCUIT BOARDS . . . . . . . . . . . . . . . . . . . . . . . . . . . .18 SCHEMATIC . . . . . . . . . . . . .22 HKTS 2 2 RadioFans.CN HKTS 2 3 HKTS 2 SYSTEM Frequency Res
5、ponse35Hz - 20kHz (-6dB) Satellites Recommended Power10 - 50 watts Impedance8 ohms nominal Sensitivity86dB 1 watt/1 meter TweeterOne 1/2 titanium-laminate dome, video-shielded MidrangeOne 3 driver, video-shielded Dimensions (H x W x D)4-5/8 x 3-1/8 x 3-3/4 117mm x 79mm x 93mm Weight1.1lb/0.5kg Cente
6、r Channel Recommended Power10 - 50 watts Impedance8 ohms nominal Sensitivity86dB 1 watt/1 meter TweeterOne 1/2 titanium-laminate dome, video-shielded MidrangeDual 3 drivers, video-shielded Dimensions (H x W x D)3-1/2 x 7-5/8 x 3-3/4 89mm x 194mm x 95mm Weight1.89 lb/0.86kg SUB-TS 2 Subwoofer100 watt
7、s RMS 10 woofer, bass-reflex enclosure Dimensions (H x W x D)18 1/4 x 15 3/4 x 16 3/4 464mm x 400mm x 425mm Weight35.8 lb/16.2kg Refinements may be made on occasion to existing products without notice, but will always meet or exceed original specifications unless otherwise stated. Specifications Rad
8、ioFans.CN HKTS 2 4 SUB-TS2 Detailed Specifications HKTS 2 5 Connections HKTS 2 6 Connections (Cont.) HKTS 2 7 Connections (Cont.) HKTS 2 8 Operation HKTS 2 9 Troubleshooting HKTS 2 10 Mechanical/Packaging Parts List SUB-TS-2 Amplifier assemblyN/A 10 4 ohm woofer 25MF10DZB-DW01 Cushion for Foot (4)WI
9、5307 Plastic Foot (4)WI5321 Plastic baseX105000 SAT-TS2 Satellite, CompleteHKTS2/SAT WooferN68A45PF-02DW GrilleG255002 Grille LogoSZ5322 Rear footWI0782 Wall bracketWI0408 Support muralWI0409 CEN-TS2 Center Channel, CompleteHKTS2/CENTER Woofer22PF45NA-HW01 GrilleG255003 Grille LogoSZ5371 Packaging O
10、wners manualAI5083 Warranty cardAT5073 Outer cartonWB5710 Subwoofer styrofoamWP5120 Styrofoam Set for SatellitesWP5119 20 Wire set (Sub in/out)SAL063-1 40 Wire set (surround) SAL5009 15 Wire set (sats the wire terminals are similar in size, but there are plus turn the power switch ON. LED should be
11、Red. Turn LEVEL control full clockwise (MAX) 5) LED should now be Green; immediate bass response should be heard and felt from port tube opening. 6) Turn off generator, turn VOLUME control fully counterclockwise, disconnect RCA cable. 7) Connect one pair of speaker cables to Speaker Level input term
12、inal (IN) on UUT. Cables should be connected to an integrated amplifier fed by the signal generator. 8) Turn on generator and adjust so that speaker level input at the amplifier is 2.0V, 50 Hz. Turn LEVEL control full clockwise. 9) Green LED should light, immediate bass response should be heard and
13、felt from the port tube opening. Sweep Function 1) Follow steps 7-9 above, using a sweep generator as a signal source. 2) Sweep generator from 20Hz to 300Hz. Listen to the cabinet and drivers for any rattles, clicks, buzzes or any other noises. If any unusual noises are heard, remove woofers and tes
14、t. Driver Function 1) Remove woofer from cabinet; detach + and - wire clips. 2) Check DC resistance of woofer; it should be 3.4 ohms 10% 3) Connect a pair of speaker cables to driver terminals. Cables should be connected to an integrated amplifier fed by a signal generator. Turn on generator and adj
15、ust so that speaker level output is 5.0V. 4) Sweep generator from 20Hz to 1kHz. Listen to driver for any rubbing, buzzing, or other unusual noises. HKTS 2 13 Packaging OWNERS MANUAL AI5083 SURVEY CARD WIRE SET (SURROUND) SAL5009 WIRE SET (2) (SUB IN/OUT) SAL063-1 SUBWOOFER STYROFOAM WP5120 WARRANTY
16、CARD AT5073 HKTS 2/SAT STYROFOAM (2) WP5119 WIRE SETS (SATS & CENTER) SAL5020 WALL BRACKET (4) WI0408 SUPPORT MURAL (4) WI0409 OUTER CARTON WB5710 00352 HKTS 2 14 Electrical Parts List PartDescriptionQtyReference No.Designator SEMICONDUCTORS 197131n4148DIODE 1N4148 26mm TAP9D101, 103, 105, 108, 201,
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- HarmanKardon HKTS2 htss sm 维修 电路 原理图