Yamaha-RXV-650-Service-Manual电路原理图.pdf
《Yamaha-RXV-650-Service-Manual电路原理图.pdf》由会员分享,可在线阅读,更多相关《Yamaha-RXV-650-Service-Manual电路原理图.pdf(128页珍藏版)》请在收音机爱好者资料库上搜索。
1、This manual has been provided for the use of authorized YAMAHA Retailers and their service personnel. It has been assumed that basic service procedures inherent to the industry, and more specifically YAMAHA Products, are already known and understood by the users, and have therefore not been restated
2、. WARNING:Failure to follow appropriate service and safety procedures when servicing this product may result in personal injury, destruction of expensive components, and failure of the product to perform as specified. For these reasons, we advise all YAMAHA product owners that any service required s
3、hould be performed by an authorized YAMAHA Retailer or the appointed service representative. IMPORTANT:The presentation or sale of this manual to any individual or firm does not constitute authorization, certification or recognition of any applicable technical capabilities, or establish a principle-
4、agent relationship of any form. The data provided is believed to be accurate and applicable to the unit(s) indicated on the cover. The research, engineering, and service departments of YAMAHA are continually striving to improve YAMAHA products. Modifications are, therefore, inevitable and specificat
5、ions are subject to change without notice or obligation to retrofit. Should any discrepancy appear to exist, please contact the distributors Service Division. WARNING:Static discharges can destroy expensive components. Discharge any static electricity your body may have accumulated by grounding your
6、self to the ground buss in the unit (heavy gauge black wires connect to this buss). IMPORTANT:Turn the unit OFF during disassembly and part replacement. Recheck all work before you apply power to the unit. IMPORTANT NOTICE 100885 SERVICE MANUAL RX-V750/DSP-AX750/DSP-AX750SE RX-V650/HTR-5760 AV RECEI
7、VER/AV AMPLIFIER AMP CHECK / . . . . . . . . . . . . . . . . . . . .47 DISPLAY DATA . . . . . . . . . . . . . . . . . . . . . . . . . . 4849 IC DATA . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5060 BLOCK DIAGRAM . . . . . . . . . . . . . . . . . . . . . . . . 6162 PRINTED CIRCUIT
8、 BOARD . . . . . . . . . . . . . . . . 6377 PIN CONNECTION DIAGRAM . . . . . . . . . . . . . . . . . 78 SCHEMATIC DIAGRAM . . . . . . . . . . . . . . . . . . . 7988 PARTS LIST . . . . . . . . . . . . . . . . . . . . . . . . . . . . 89125 REMOTE CONTROL RAV270, RAV271 . . . . 126127 REMOTE CONTROL RA
9、V248, RAV249 . . . . . . . . 128 CONTENTS TO SERVICE PERSONNEL . . . . . . . . . . . . . . . . . . . . 2 IMPEDANCE SELECTOR . . . . . . . . . . . . . . . . . . . . . . 3 FRONT PANELS . . . . . . . . . . . . . . . . . . . . . . . . . . . 45 REMOTE CONTROL PANELS . . . . . . . . . . . . . . . . . . 6
10、REAR PANELS . . . . . . . . . . . . . . . . . . . . . . . . . . . 713 SPECIFICATIONS / 参考仕様 . . . . . . . . . . . . . . . . .1418 INTERNAL VIEW . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19 DISASSEMBLY PROCEDURES / 分解手順 . . . . .2024 SELF DIAGNOSIS FUNCTION (DIAG) / 自己診断機能() . . . . . .
11、 . . . . . . . . . . . . . . 2546 RX-V750/DSP-AX750/DSP-AX750SE RX-V650/HTR-5760 RX-V750/DSP-AX750/DSP-AX750SE RX-V650/HTR-5760 2 RX-V750/DSP-AX750/DSP-AX750SE RX-V650/HTR-5760 TO SERVICE PERSONNEL 1. Critical Components Information Components having special characteristics are marked Z and must be
12、replaced with parts having specifications equal to those originally installed. 2. Leakage Current Measurement (For 120V Models Only) When service has been completed, it is imperative to verify that all exposed conductive surfaces are properly insulated from supply circuits. Meter impedance should be
13、 equivalent to 1500 ohm shunted by 0.15F. AC LEAKAGE TESTER OR EQUIVALENT EQUIPMENT UNDER TEST INSULATING TABLE WALL OUTLET Leakage current must not exceed 0.5mA. Be sure to test for leakage with the AC plug in both polarities. WARNING: CHEMICAL CONTENT NOTICE! The solder used in the production of t
14、his product contains LEAD. In addition, other electrical/electronic and/or plastic (where applicable) components may also contain traces of chemicals found by the California Health and Welfare Agency (and possibly other entities) to cause cancer and/or birth defects or other reproductive harm. DO NO
15、T PLACE SOLDER, ELECTRICAL/ELECTRONIC OR PLASTIC COMPONENTS IN YOUR MOUTH FOR ANY REASON WHATSOEVER! Avoid prolonged, unprotected contact between solder and your skin! When soldering, do not inhale solder fumes or expose eyes to solder/flux vapor! If you come in contact with solder or components loc
16、ated inside the enclosure of this product, wash your hands before handling food. About Lead Free Solder / 無鉛 The P.C.B.s installed in this unit are soldered using the fol- lowing solder. 本機搭載基板付使用 下記通。 無鉛種類、修理時 下記無鉛使用推奨。 Sn+Ag+Cu (錫 + 銀 +銅) Sn+Cu (錫 + 銅) Sn+Zn+Bi (錫 + 亜鉛 +) Among some types of lead
17、free solder currently available, it is recommended to use one of the following types for the repair work. Sn + Ag + Cu (tin + silver + copper) Sn + Cu (tin + copper) Sn + Zn + Bi (tin + zinc + bismuth) “CAUTION” “F1, F2 : FOR CONTINUED PROTECTION AGAINST RISK OF FIRE, REPLACE ONLY WITH SAME TYPE 10A
18、, 125V FUSE.” CAUTION F1, F2 : REPLACE WITH SAME TYPE 10A, 125V FUSE. ATTENTION F1, F2 : UTILISER UN FUSIBLE DE RECHANGE DE MEME TYPE DE 10A, 125V. AV Component Side / 部品面Foil Side / 面 DSP P.C.B.Lead Solder / 鉛入Lead Free Solder / 無鉛 FUNCTION P.C.B.Lead Free Solder / 無鉛 OPERATION P.C.B.Lead Free Sold
19、er / 無鉛 MAIN P.C.B.Lead Free Solder / 無鉛 POWER P.C.B.Lead Free Solder / 無鉛 SUB TRANS P.C.B.Lead Free Solder / 無鉛 CONVERSION P.C.B.Lead Solder / 鉛入Lead Free Solder / 無鉛 RX-V750/DSP-AX750/DSP-AX750SE RX-V650/HTR-5760 RX-V750/DSP-AX750/DSP-AX750SE RX-V650/HTR-5760 3 Caution: 1. As the melting point tem
20、perature of the lead free solder is about 30C to 40C (50F to 70F) higher than that of the lead solder, be sure to use a soldering iron suitable to each solder. 2. If lead solder must be used, be sure to remove lead-free solder from each terminal section of the parts to be re- placed and from the are
21、a around it completely before sol- dering, or make sure that the lead free solder and lead solder melt together fully. 注意: 1. 無鉛融点温度通常鉛入比30 40 程度高、 合使用。 2. 鉛入使得場合、 交 換部品端子部周辺部無鉛取 除、 無鉛鉛入十分 溶状態付。 IMPEDANCE SELECTOR WARNING: Do not change the setting of the IMPEDANCE SELECTOR switch when the unit powe
22、r is switched on, as doing so may damage the unit. IMPEDANCE SELECTOR switch RX-V750/DSP-AX750/DSP-AX750SE RX-V650/HTR-5760 4 RX-V750/DSP-AX750/DSP-AX750SE RX-V650/HTR-5760 DSP-AX750SE (B model) RX-V750 (U, C, R, T, K, A, G, L models) FRONT PANELS DSP-AX750 (J model) RX-V750/DSP-AX750/DSP-AX750SE RX
23、-V650/HTR-5760 RX-V750/DSP-AX750/DSP-AX750SE RX-V650/HTR-5760 5 RX-V650 (U, C, R, T, K, A, B, G, L, E models) HTR-5760 (U, C, T, K, A models) RX-V750/DSP-AX750/DSP-AX750SE RX-V650/HTR-5760 6 RX-V750/DSP-AX750/DSP-AX750SE RX-V650/HTR-5760 REMOTE CONTROL PANELS TRANSM TRE NAME INPUT MODESTANDBY SYSTEM
24、 POWER ABPHONO CDMD/CD RTUNERV AUX DVD AMP POWERPOWER REC AUDIO MUTE MENUTITLE CHCH VOL DISC SKIP SET MENULEVEL A/B/C/D/ETV INPUT TV VOL PRESET TESTON SCREENSTRAIGHT ROCKJAZZHALLSTEREO 4321 8 10 7 09 65 ENTER MOVIETV THTRMUSICENTERTAIN EX/ESNIGHTV/DTSPURE DIRECT EFFECT CHP INDEX DISPLAYRETURN PRESET
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- Yamaha RXV 650 Service Manual 电路 原理图