Yamaha-DVDS-80-Service-Manual电路原理图.pdf
《Yamaha-DVDS-80-Service-Manual电路原理图.pdf》由会员分享,可在线阅读,更多相关《Yamaha-DVDS-80-Service-Manual电路原理图.pdf(28页珍藏版)》请在收音机爱好者资料库上搜索。
1、DVD-S80 corrected version CORRECTED VERSION / 訂正版 June 2003 I CONTENTS CURRENT VERSIONCORRECTED VERSION OPTICAL PICKUP SELF-DIAGNOSIS AND REPLACEMENTP14, 15, 16, 17P14, 15, 16, 17 PROCEDURE / 光故障診断交換手順 SELF-DIAGNOSIS FUNCTION AND SERVICE MODES /P18, 19, 20, 21P18, 19, 20, 21 自己診断機能 ADJUSTMENT / 調整P4
2、2P42 SCHEMATIC DIAGRAMMODULE P.C.B.1/6 6/61/5 5/5 P68, 69, 70, 71, 72, 73P68, 69, 70, 71, 72 MOTHER P.C.B.1/4 4/41/4 4/4 P74, 75, 76, 77, 78P74, 75, 76, 77, 78 PARTS LISTELECTRICAL PARTSP86, 87, 88, 89, 90, 91, 92P86, 87, 88, 89, 90, 91 MECHANICAL PARTSP93, 94P93, 94 This corrected version is issued
3、 to replace the following pages of the current version (#100812). For other pages, refer to the current version. 訂正版現行版 (#100812) 下記差替発行。 他、現行版参照。 100862 P.O.Box 1, Hamamatsu, Japan SERVICE MANUAL DVD PLAYER DVD-S80 RadioFans.CN 收音机爱 好者资料库 DVD-S80 corrected version DVD-S80 corrected version 14The co
4、rrected parts are shaded. I OPTICAL PICKUP SELF-DIAGNOSIS AND REPLACEMENT PROCEDURE 1. Self-diagnosis An optical pickup self-diagnosis function and tilt adjustment check function have been included in this unit. When repairing, use the following procedure for effective Self-diagnosis and tilt adjust
5、ment. Be sure to use the self-diagnosis function before replacing the optical pickup when NO DISC is displayed. As a guideline, you should replace the optical pickup when the value of the CD laser drive current is more than 55 (70 for DVD). Note: Press the STANDBY/ON button to turn on the power. Che
6、ck the value within three minutes before the unit warms up. (Otherwise, the result will be incorrect.) RadioFans.CN 收音机爱 好者资料库 DVD-S80 corrected version DVD-S80 corrected version 訂正箇所。15 NO DISC表示出 再生等 駆動電流確認 光交換 交換後 駆動電流確認 現在値60 (DVD場合) 、 45 (CD場合) 以下 本体書込 現在値60 (DVD場合) 、 45 (CD場合) 越 場合、新光 取替。 (原因)
7、 交換時静電気 与 光調整 調整確認 機能使 現在値 70 (DVD場合) 、 55 (CD場合) 越 現在値 70 (DVD場合) 、 55 (CD場合) 以下 初期化 直場合、 P.C.B.。 確認方法無状態 (DVD) (CD)押 送信 表示内容 LDD (DVD) LDC (CD) 光故障診断機能使 工場出荷値 現在値 書込方法 押 送信 確認方法無状態 (DVD) (CD)押 送信 光故障診断交換手順 1. 故障診断 本機、 光故障診断機能 調整確認機能 内蔵。修理時、次手法用効率的 故障診断、調整実施。 NO DISC 表示出場合光交換前 故障診断 行。CD用駆動電流現在値 55
8、越 場合 (DVD70) 光交換目安。 注意 電源入3 分以内診断。 (温正確診断。) DVD-S80 corrected version DVD-S80 corrected version 16The corrected parts are shaded. 2.Cautions to Be Used Before Replacing the Optical Pickup Unit and Spindle Motor Assembly Before replacing the optical pickup unit and spindle motor assembly, check the t
9、otal usage hours for each of them. The checking method is as follows: Note: Each of these procedures should start with the unit stopped. Cautions to be taken when replacing the optical pickup The optical pickup may become damaged due to static electricity from the human body. Take proper protection
10、measures against static electricity before repairing the parts around the optical pickup. (See the page describing the PREVENTION OF ELECTRO STATIC DISCHARGE.) 1. Do not touch the areas around the laser diode and actuator. 2. Do not judge the laser diode with a tester. (The tester will damage the di
11、ode.) 3. It is recommended to use a anti-static soldering iron for soldering or desoldering on the pickup. (Recommended soldering iron) HAKKO ESD Product 4. Solder the land of the flexible cable in the optical pickup. Note: When using a soldering iron which is not anti-static, short-circuit the term
12、inal face of the flexible cable with a clip. After that, short-circuit the land. After the repairing work is completed, remove the solder according to the correct procedure shown in this service manual. Optical pickup unit Flexible cable Ground with a clip. DVD-S80 corrected version DVD-S80 correcte
13、d version 訂正箇所。17 光交換時願 光体帯電静電気等破壊 場合。光周辺修理場合静 電気保護対策行上実施。 (静電気 保護対策参照。) 1. 周辺周辺 。 2. 等良否判定 。 (簡単破壊。) 3. 除去使用半田 静電対策推奨。 (推奨半田) HAKKO ESD対策品 2. 光、交換時注意 光、交換場合、交換前使用累積時間確認 。 確認方法下記操作行。 4. 光 半田付。 注意 静電対策半田使用時、 端子面等 、。 上記修理完了後、 本文説明順従正手順取除 。 使用時間 SP使用時間 CDDVD使用時間 (同時) SP使用時間 動作条件操作 状態、本体 押 状態、本体 押 状態、本体
14、 押 状態、本体 押 表示 T1_xxxx_yyyy xxxx:DVD使用時間 yyyy:CD使用時間 時間単位10時間4桁表示。 T2_xxxx xxxx=時間単位10時間4桁表示。 T1_0000_0000 T2_0000 DVD-S80 corrected version DVD-S80 corrected version 18The corrected parts are shaded. I SELF-DIAGNOSIS FUNCTION AND SERVICE MODES 1. Service mode table Pressing various button combinatio
15、ns on the player and remote control unit can activate the service modes. Note: For jitter check, load the DVD test disc or the CD test disc. (See page 42) DVD-S80 corrected version DVD-S80 corrected version 訂正箇所。19 自己診断機能 1. 一覧 本体組合活用。 注) 、DVDCD使用。 (42参照) DVD-S80 corrected version DVD-S80 corrected
16、version 20The corrected parts are shaded. Use of operation time display function When repairing a trouble, check these figures and use them for reference. When performing replacement, be sure to check the total operation time and reset the time after replacement. DVD-S80 corrected version DVD-S80 co
17、rrected version 訂正箇所。21 使用時間表示機能活用 故障修理時、時間確認故障診断参考。 修理交換時、必使用時間確認、交換後使用時間。 DVD-S80 corrected version 42The corrected parts are shaded.訂正箇所。 ApplicationNameNumber 用途品名品番 Tilt adjustment DVD test discDVDT-S15 (AAX07320) or DVDT-S01 (TX946080) 調整DVD DVDT-S15 (AAX07320) DVDT-S01 Hex wrenchJZS0100 (TX94
18、6380) 六角 InspectionExtension cable 14P (module P.C.B. to mother P.C.B.)VUC8026 (AAX16590) 点検用延長 (P.C.B.P.C.B.) Extension cable 22P (module P.C.B. to mother P.C.B.)JGS0116 (AAX16610) 延長 (P.C.B.P.C.B.) OthersScrew lockRZZ0L01 (TX946400) 他 GreaseRFKXGAK152 (AAX27800) RFKXPG641 (AAX46440) OilRFKXGA1280
19、(AAX27790) ConfirmationCD test discPVCD-K06 (TX946090) or any other commercially 確認CD available disc PVCD-K06 (TX946090) 他一般市販 VCD test discPVCD-K06 (TX946090) or any other commercially available disc VCD PVCD-K06 (TX946090) 他一般市販 Recovery discRFKZD5TR006 (AAX42050) I ADJUSTMENT / 調整 1. Service Tool
20、s and Equipment1. 調整必要機器 2. Important points in adjustment Before starting optical pickup tilt adjustment, be sure to take anti-static measures. Optical pickup tilt adjustment is needed after replacement of the following components. 1. Optical pickup unit 2. Spindle motor unit 3. Optical pickup peri
21、pheral parts (such as the rail) Notes Adjustment is generally unnecessary after replacing other parts of the traverse unit. However, make adjustment if there is a noticeable degradation in picture quality. Optical adjustments cannot be made inside the optical pickup. Adjustment is generally unnecess
22、ary after replacing the traverse unit. 2. 調整 光学系調整始前静電気保護対策実施 。 次部品交換時光学調整 光調整 必要 。 1. 光 2. 3. 光周辺 (等) 備考 他内部品交換後基本的調整不 要画質劣化見場合調整。 光内光学調整。 交換場合基本的調整不要。 DVD-S80 corrected version I SCHEMATIC DIAGRAM 1. MODULE 1/5 (NODC SECTION) 68 DVD-S80 corrected version I SCHEMATIC DIAGRAM 2. MODULE 2/5 (AVDEC SE
23、CTION) 69 DVD-S80 corrected version G, B models only I SCHEMATIC DIAGRAM 3. MODULE 3/5 (VIDEO-DAC SECTION) 70 DVD-S80 corrected version I SCHEMATIC DIAGRAM 4. MODULE 4/5 (AUDIO-DAC SECTION) 71 DVD-S80 corrected version I SCHEMATIC DIAGRAM 5. MODULE 5/5 (CPU SECTION) 72 DVD-S80 corrected version I SC
24、HEMATIC DIAGRAM 7. MOTHER 1/4 (POWER SECTION) B, G, J models 74 DVD-S80 corrected version I SCHEMATIC DIAGRAM 8. MOTHER 1/4 (POWER SECTION) R, T, K, A models 75 DVD-S80 corrected version G, B models only J model only I SCHEMATIC DIAGRAM 9. MOTHER 2/4 (VIDEO-OUT SECTION) 76 DVD-S80 corrected version
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- Yamaha DVDS 80 Service Manual 电路 原理图