Teac-RW-H500-Service-Manual电路原理图.pdf
《Teac-RW-H500-Service-Manual电路原理图.pdf》由会员分享,可在线阅读,更多相关《Teac-RW-H500-Service-Manual电路原理图.pdf(26页珍藏版)》请在收音机爱好者资料库上搜索。
1、R RWW- -H H5 50 00 0 SERVICE MANUAL CD Rewritable Deck Effective : May, 2000S-0021A CONTENTS 1 SPECIFICATIONS 2 2 ADJUSTMENTS AND CHECKS 3 3 EXPLODED VIEWS AND PARTS LIST 5 4 PC BOARDS AND PARTS LIST 7 5 INCLUDED ACCESSORIES 13 目 次 1 仕 様 2 2 調整確認 3 3 分解図 5 4 基板図 7 5 付属品 13 NOTES PC boards shown are
2、viewed from parts side. Parts marked with * require longer delivery time. The parts with no reference number or no parts number in the exploded views are not supplied. As regards the resistors and capacitors, refer to the circuit diagrams contained in this manual. Parts marked with this sign are saf
3、ety critical components. They must be replaced with identical components - refer to the appropriate parts list and ensure exact replacement. Parts of mark can be used only with the version designated. J:JAPAN US:U.S.A. C:CANADA GE:GENERAL EXPORT E:EUROPE UK:U.K. A:AUSTRALIA 注意 基板図部品面示。 *印部品納期若干。 了承。
4、 分解図部番部品品番部品供給 。 標準抵抗、省略。 回路図参照。 印安全重要部品。 交換時必指定部品使用。 仕向先 J:JAPAN US:U.S.A. C:CANADA GE:GENERAL EXPORT E:EUROPE UK:U.K. A:AUSTRALIA RadioFans.CN 收音机爱 好者资料库 1 SPECIFICATIONS 2 仕様 記録 .音楽用CD-R/CD-RW 入力周波数.32kHz48kHz 録音周波数 .44.1kHz 周波数特性 .20Hz20kHz (再生時:0.5dB、記録時:1dB) S/N比 .93dB以上(再生時) 87dB以上(記録時) .93dB
5、以上(再生時) 87dB以上(記録時) 歪率.0.007以下(再生時) 0.009以下(記録時) .測定限界以下 入力端子.:1系統 :光1系統 出力端子.:1系統 :光1系統 入力 .入力:20k 規定入力:6dBV(0.5V) 最大入力:6dBV(2.0V) 出力.出力:1k 規定出力:6dBV(0.5V) 最大出力:6dBV(2.0V) 電源 .AC100V、50-60Hz 消費電力. 25W 外形寸法(幅高奥行).285129310mm 質量. 5.7kg 動作保証温度 .535 付属品 .(RC-754) 用乾電池(単3)2本 2本 1本 取扱説明書 保証書 仕様外観、改善予告変更
6、。 Media type .CD-RW and CD-R for Digital audio (record and playback), CD (playback only) Frequency converter input sampling frequency .32kHz48kHz Recording sampling frequency .44.1kHz Frequency response.20Hz20kHz (playback: 0.5dB, recording: 1dB) Signal to noise ratio .More than 93dB (playback) More
7、 than 87dB (recording) Dynamic range .More than 93dB (playback) More than 87dB (recording) Total Harmonic Distortion .Less than 0.007% (playback) Less than 0.009% (recording) Wow press the corresponding key. When the check result of the key is OK, the display shows another key name. When the result
8、is No Good, the display continues to show the same key name. 3. When all of the keys have been checked, the display shows vol50,dial50. Check the multi jog dial to confirm that the figure after dial increases when the dial is rotated clockwise and decreases when it is rotated counterclockwise. 4. Th
9、en check the rec level control to confirm that the figure after vol increases when the control is rotated clockwise and decreases when it is rotated counterclockwise. 5. Press the play key to exit from the front key check mode and return to the Version number display mode. 2-1-2 Display check 1. Pre
10、ss the display key to enter the display check mode. 2. Press display key a few times and ensure that each press lights the display blocks one after another. 3. When all the indicators are lit, press the display key to exit from the display check mode and return to the Version number display mode. 2-
11、1-3 EEPROM default setting 1. Press the erase key. This writes the default values in the EEPROM and checks the written data. When the default data is written correctly, the display shows “EEPROM OK !”. If not, it shows “EEPROM NG !”. 2. Press the erase key again to return to the Version number displ
12、ay mode. 2-1-4 Total recording time display 1. When the record key is pressed, the display shows the time in which the pickup outputs the recording power (in the unit of hour). 2. Press the record key again to return to the Version number display mode. 2-1 状態、stop play pause 5秒間押続、表示部機種名 Version No.
13、 表示入。 stop 押、終了 戻。 2-1-1 1. play 押、入。 2. 表示部名称表示、 押。 OK次名称表示、NG表示 変化。 3. 一 通 確 認 終 了 、 “vol50,dial50” 表示。multi jog 回、 “dial” 側数字右回増加、左回減少 確認。 4. 次 rec level 回、“vol” 側数字右回増加、左 回減少確認。 5. play 押、終了 Version No. 表示戻。 2-1-2 1. display 押、入。 2. display 押、表示部点灯 行確認。 3. 表示部全点灯状態 display 押、 終了 Version No. 表示戻。
14、 2-1-3 EEPROM 設定 1. erase 押。 EEPROM値書込、自動的書込 行。、正書込、表示部 “EEPROM OK !” 表示、不良場合 “EEPROM NG !” 表示。 2. 再度 erase 押、Version No. 表示戻。 2-1-4 記録積算時間表示 1. record 押、記録出力 時間表示。 (単位:hour) 2. 再度 record 押、Version No. 表示戻。 調整確認 4 ITEM 項目 TEST DISC PLAYBACK SIGNAL 再生信号 SPECIFICATIONS 規格 REMARKS 備考 1. Playback level
15、再生 MCD-111 Track 2 1kHz, 0dB2.00.4V 2. Playback frequency response 再生周波数特性 MCD-111 Track 36 20Hz20kHz, 0dB00.5dB Reference level: 1kHz 1kHz基準 3. Playback distortion 再生歪率 MCD-111 Track 2 1kHz, 0dB0.012% or less20kHz LPF in 4. Playback S/N ratio 再生S/N比 MCD-111 Track 7 dB88dB or better20kHz LPF in IEC-
16、A 5. Playback channel separation 再生 MCD-111 Track 8, 10 1kHz, 0dB80dB or betterIEC-A 2-2 Audio Check 系確認 2-2-1 Playback performance 再生系 Measurement point: LINE OUT Mode: play ITEM 項目 INPUT SIGNAL (LINE IN) 入力信号 SPECIFICATIONS 規格 REMARKS 備考 1. Specified input level 規定入力 1kHz, 6dBv6dBv2dB Turn rec lev
17、el to display VOLUME +1dB. Do not alter the value after setting. rec level 回、表示 “VOLUME +1dB” 設定。 調整後動。 2. Monitor frequency response 周波数特性 20Hz20kHz, 6dBv01dB Reference level: 1kHz 1kHz基準 3. Monitor S/N ratio S/N比 83dB or better Ratio between the output level and noise when the input level is +6 dB
18、v. 6dBv入力時出力比 20kHz LPF in IEC-A 4. Monitor channel separation L (R) ch: 1kHz, 6dBv R (L) ch: No signal 75dB or betterRatio between the L CH and R CH outputs. Lch出力Rch出力比。 IEC-A 5. Monitor distortion 歪率 1kHz, 5dBv0.015% or less20kHz LPF in 2-2-2 Monitor performance 系 Measurement point: LINE OUT Mode
19、: record monitor Lch: 10kHz, 6dBv Rch: No signal 55dB or better 3 EXPLODED VIEWS AND PARTS LIST 5 分解図 6 PARTS LIST REF.NO.PARTS NO.DESCRIPTION 1 * 3M0093800ABONNET 2 * 3M000880 BUSHING,#2271 3 * 3E009000 POWER CORD J * 3E009230 POWER CORD US,C,GE * 3E000340 POWER CORD E * 3E000350 POWER CORD UK * 3E
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- Teac RW H500 Service Manual 电路 原理图