《Kenwood-TK-260-G-Schematic电路原理图.pdf》由会员分享,可在线阅读,更多相关《Kenwood-TK-260-G-Schematic电路原理图.pdf(22页珍藏版)》请在收音机爱好者资料库上搜索。
1、B62-1129-10(K)(MC)09 08 07 06 05 04 03 02 01 00VHF FM TRANSCEIVER/UHF FM TRANSCEIVERINSTRUCTION MANUALMANUAL DE INSTRUCCIONESTRANSCEPTOR DE FM VHF/TRANSCEPTOR DE FM UHFKENWOOD CORPORATIONTK-260G/TK-360GENGLISHVHF FM TRANSCEIVER/UHF FM TRANSCEIVERINSTRUCTION MANUALTK-260G/TK-360GOne or more of the fo
2、llowing statements may beapplicable:FCC WARNINGThis equipment generates or uses radio frequency energy. Changesor modifications to this equipment may cause harmful interferenceunless the modifications are expressly approved in the instructionmanual. The user could lose the authority to operate this
3、equipment ifan unauthorized change or modification is made.INFORMATION TO THE DIGITAL DEVICE USER REQUIRED BYTHE FCCThis equipment has been tested and found to comply with the limitsfor a Class B digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable pro
4、tection againstharmful interference in a residential installation.This equipment generates, uses and can generate radio frequencyenergy and, if not installed and used in accordance with the instructions,may cause harmful interference to radio communications. However,there is no guarantee that the in
5、terference will not occur in a particularinstallation. If this equipment does cause harmful interference to radioor television reception, which can be determined by turning theequipment off and on, the user is encouraged to try to correct theinterference by one or more of the following measures: Reo
6、rient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment to an outlet on a circuit different from thatto which the receiver is connected. Consult the dealer for technical assistance.ATTENTION (U.S.A. Only):The RBRC Recycle seal found
7、on KENWOODnickel-cadmium (Ni-Cd) battery packs indicatesKENWOODs voluntary participation in an industryprogram to collect and recycle Ni-Cd batteries aftertheir operating life has expired. The RBRC programis an alternative to disposing Ni-Cd batteries withyour regular refuse or in municipal waste st
8、reams,which is illegal in some areas.For information on Ni-Cd battery recycling in your area, call (toll free)1-800-8-BATTERY (1-800-822-8837).KENWOODs involvement in this program is part of our commitmentto preserve our environment and conserve our natural resources.iMODELS COVERED BY THIS MANUAL T
9、K-260G: VHF FM Transceiver TK-360G: UHF FM TransceiverNOTICES TO THE USERWARNING:GOVERNMENT LAW PROHIBITS THE OPERATION OF UNLICENSEDRADIO TRANSMITTERS WITHIN THE TERRITORIES UNDERGOVERNMENT CONTROL.ILLEGAL OPERATION IS PUNISHABLE BY FINE OR IMPRISONMENTOR BOTH.REFER SERVICE TO A QUALIFIED LICENSED
10、OR CERTIFIEDTECHNICIAN ONLY.SAFETY: It is important that the operator is aware of andunderstands hazards common to the operation of anytransceiver.WARNING:EXPLOSIVE ATMOSPHERES (GASES, DUST, FUMES, etc.)Turn off and do not operate your transceiver while taking on fuel, orwhile parked in gasoline ser
11、vice stations.iiPRECAUTIONSPlease observe the following precautions to prevent fire,personal injury, and transceiver damage: Do not modify this transceiver for any reason. Do not expose the transceiver to long periods of directsunlight, nor place the transceiver close to heatingappliances. Do not pl
12、ace the transceiver in excessively dusty areas,humid areas, nor on unstable surfaces. If an abnormal odor or smoke is detected coming fromthe transceiver, switch OFF the power immediately andremove the optional battery pack from the transceiver.Contact your KENWOOD dealer.iiiCONTENTSFCC WARNINGS/BAT
13、TERY ADVISORY . Inside Front CoverMODELS COVERED BY THIS MANUAL .iNOTICES TO THE USER .iPRECAUTIONS . iiTHANK YOU! . 1UNPACKING AND CHECKING EQUIPMENT . 1Supplied Accessories . 2PREPARATION . 3Installing/Removing the Optional Battery Pack . 3Installing the Antenna . 5Installing the Cap over the Spea
14、ker-Mic Jacks . 6Installing the Speaker-Microphone . 6Installing the Belt Hook . 7GETTING ACQUAINTED . 8RECEIVING .11CALLING . 12Time-Out Timer (TOT). 13Busy Channel Lockout . 13Battery Voltage Level . 14CHANNEL CHART . 151THANK YOU!We are grateful you chose KENWOOD for your landmobile applications.
15、 We believe this easy-to-usetransceiver will provide dependable communications tokeep personnel operating at peak efficiency.KENWOOD transceivers incorporate the latest inadvanced technology. As a result, we feel strongly thatyou will be pleased with this products quality and features.UNPACKING AND
16、CHECKING EQUIPMENTNote: The following instructions are for use by your KENWOOD dealer,an authorized KENWOOD service facility, or the factory.Carefully unpack the transceiver. We recommend that youidentify the items listed on the following page beforediscarding the packing material. If any damage has
17、occurred during shipment, file a claim with the carrierimmediately.2n Supplied AccessoriesLocking bracketSpeaker-mic jacks capScrew setBelt hookItem Part Number Qty.111111Belt hookScrew setSpeaker-mic jacks capLocking bracket(for speaker-mic)Warranty cardInstruction manualJ29-0624-XXN99-2012 -XXB09-
18、0351-XXJ21-4493-XXB62-1129-XX3PREPARATIONn Installing/Removing the Optional Battery PackThe optional KNB-14 or KNB-15A battery pack is notcharged at the factory. Charge the pack before use. Ifafter purchase or extended storage (greater than2 months), battery capacity is found to be low, thebattery p
19、ack needs recharging. Repeating the charge/discharge cycles two or three times will restore thebattery to its normal capacity.1 Position the four grooves on the inside edges of thebattery pack over the corresponding guides on theback of the transceiver.42 Slide the battery pack along the back of thetransceiver until the release catch on the base ofthe transceiver locks the battery pack in place.3 To remove the battery pack, grasp the pack nearits tabs, pull back on the release catch, thenslide the pack away from the transceiver.