Kenwood-KRC-17-G-Service-Manual电路原理图.pdf
《Kenwood-KRC-17-G-Service-Manual电路原理图.pdf》由会员分享,可在线阅读,更多相关《Kenwood-KRC-17-G-Service-Manual电路原理图.pdf(24页珍藏版)》请在收音机爱好者资料库上搜索。
1、 2002-10 PRINTED IN JAPANB51-7981-00 (N)2139CASSETTE RECEIVERKRC-17G/YA/YGKRC-194A/G/YA/YGKRC-266LA/LG/RGKRC-27YA/YGKRC-2904YA/YGKRC-294A/G/YA/YGSERVICE MANUALKRC-266RGKRC-17G/YA/YG, KRC-194A/G/YA/YG (E) KRC-2904YA/YG (E)KRC-266RG (M)Escutcheon(B07-2188-02)45W x 4KRC-266L45W x 4AUTO AMEKRC-29445W x
2、4KRC-2745W x 4KRC-290445W x 4T.CALLKRC-17KRC-19445W x 4T.CALLKRC-27YA/YG (E) KRC-294A/G/YA/YG (E)KRC-266LA/LG (M)Mounting hardware assy(J21-9701-03)Plastic cabinet assy(A02-1486-13)Screw set(N99-1610-15)Lever(D10-3031-04) x2Antenna adaptor(T90-0523-05)or(T90-0534-05)WIDE BANDDC cord(E30-4790-05)or(E
3、30-6134-05)Screw set(N99-1719-05)AUTO AMEPanel assy (A64-2924-02):KRC-194A/G/YA/YG (A64-2925-02):KRC-17G/YA/YGPanel assy (A64-2927-02)Panel assy (A64-2933-02) Panel assy (A64-2923-02)Panel assy (A64-2917-02)Panel assy (A64-2916-02)Depends on model. Refer to the parts listKRC-17G/YA/YG,194A/G/YA/YG,2
4、66LA/LG/RGKRC-27YA/YG,2904YA/YG,294A/G/YA/YG2BLOCK DIAGRAMIC1KEYPAN 5VMUTEB.U. DET. B.U.ACCP-CONT.MUTEPREPOWER ICEQ. AMP.CH ISO AMPNC,MPXE-VOL.CD/MDCHANGERFRONT LchFRONT RchREAR LchREAR RchJ2LCD DRIVERLCDCME1MAINTAPE MECHA.IC5LchRchPRE OUTIC2IC4IC3SP OUTREARJ4PAN IN SWACC DET.P-CONT.J2J5IC1F/EJ1FM+B
5、Q201AM+BQ203AM BPFFM BPFC154,R206C153,R207Q320Q450,451Q49Q50Q350,351,370Q53SW 5VQ54-578VQ58-61ILLUMI.B.U. 5VQ51,52SYSTEM u-COMS1S2S3RST SWQ301D1-15PL1,2ANT.TEL MUTEDECODERRDSIC7Q501,502MP SWRST ICRSTIC6ED1FM ANTAM ANTRF GNDFM+BAM+BOSC GNDOSC GNDOSC GNDVTPLL +BIFC OUTSDASCLDIG GNDIF1+BIF1 GNDS-METERI
6、F2 GNDSDFM+BP. O NACC DETB.U. DETSCLMUTESDAP CONPANELRESETL CLKLDATASLDATALFWD/REVMOTORCH CONDATAHDATACREQ HREQ CCH CLKRchCOMLchMP INAMMPXOUT RROUT LROUT RFRchLEVELSCLSDAOUT LFRchSTBYMUTERchLchT-MUTEFWDREVB.U.5V8VB.U.CH RSTS MUTE8510B.U.5VAM+BVDD 5VPACK INL RESPHONECHMUTEBEEPSVRAMP. STBYSVRAC GND (B
7、EEP)Lch LchRchLch1200mVTAPE :1681mVCD/MD-CH :3529mVAM :772mVFM :1339mV8VRF GNDOSC GNDIF2 +BAUDIO OUT8VS-METERSDPLL-SCLPLL-SDACM1PLAYHEADL/R55.6mVB.U.5VSW 5V8VB.U.5VAM: 170mVFM: 213mVTAPEPACK IN(FF/REW)AMP. MUTEFF/REWB.U.5VR QUALIF COUNTR CLKR DATASW 5VMP OUTQUALAFCNOISEB.U.5VILLL CE(X16)A1TEL DETD38
8、05VR205MKRC-17G/YA/YG, 194A/G/YA/YG, 266LA/LG/RGKRC-27YA/YG, 2904YA/YG, 294A/G/YA/YG3a71 SYNTHESIZER UNIT (X14-687x-xx)COMPONENTS DESCRIPTIONRef.No. Application/Function Operation/Condition/CompatibilityIC1 SYSTEM -COM Controls the unit.IC2 E-VOLUME Controls the volume and selects source.IC3 MUTE LO
9、GIC Controls the mute output.IC4 POWER AMPLIFIER For the speaker output.IC5 EQUALIZER AMPLIFIER For the cassette tapes signal.IC6 RESET Resets the power.IC7 RDS DECODER Decodes the radio data.Q49 ACC DETECTION SW Outputs “H“ during the ACC off.Q50 BACK-UP DETECTION SW Outputs “H“ when the back-up vo
10、ltage is under 9.2V.Q51,52 BACK-UP 5V DRIVER Works when back-up current exists.Q53 P.ON 5V SW Works during the power on.Q54,55 8V SW Works during the power on.Q56,57 8V DRIVER Works during the power on.Q58,59 ILLUMI +B SW Works during the power on.Q60,61 ILLUMI +B DRIVER Works during the power on.Q1
11、50 E-VOL MUTE SWWorks when the back-up current is detected or the changer mute works or system -com mute works.Q151 SVR FORCED DISCHARGE SW Works when the amplifier mute works.Q153 PRE OUT MUTE SWWorks when the back-up current is detected or the changer mute works or system -com mute works.Q201 FM +
12、B SW Works during FM mode.Q203 AM +B SW Works during AM mode.Q260 MOTOR +B SW Works during the tape mode.Q261 MOTOR +B DRIVER Works when Q206 works.Q301 CD-CH RESET SW Works when the power is reset and the reset SW works.Q320 PANEL 5V SW Works when the back-up current exists and the panel is attache
13、d on the unit.Q350 P.CON DRIVER SW Does not work during the power off and the ALL OFF.Q351 P.CON PROTECTION SW Works when the P.CON is short-circuited on the GND.Q352 P.CON PROTECTION INHIBIT SW Inhibits the protection SW in a moment during the P.CON on.Q353 P.CON DRIVER SW Does not work during the
14、power off and the ALL OFF.Q450,451 PRE OUT MUTE SWWorks when the back-up current is detected or the changer mute works or system -com mute works.Q500 AUDIO OUTPUT BUFFER For RDS decoder.Q501,502 AFC TIME CONSTANT SW Works during receiving FM signal.Q503 NOISE BUFFER For noise level detection.KRC-17G
15、/YA/YG, 194A/G/YA/YG, 266LA/LG/RGKRC-27YA/YG, 2904YA/YG, 294A/G/YA/YG4a71 SYSTEM MICROCOMPUTER UPD780058GC (IC1 : X14)Pin No. Pin Name I/O Function Operating Condition1 PANEL I Panel detection. “L“ : Panel exists.2 L CE O LCD driver chip enable. -3 L RES O LCD driver reset. -4 AVSS - GND. -5 R DATA
16、I RDS data. -6 R QUAL I RDS receiving. -7 AVREF 1 - Reference voltage. -8 IC2 SEL 1 I Selector. “L“ : Normally.9 IC2 SEL 0 I Selector. “L“ : Normally.10 - - - -11 L DATA L I LCD driver communication data. -12 L DATA S O LCD driver communication data. -13 L CLK O LCD driver communication clock. -14,1
17、5 - - - -16 DATA C I Changer communication data. -17 DATA H O Changer communication data. -18 CH CLK I Changer communication clock. -19-26 - - - -27 MOTOR O Cassette tape motor SW. -28 FF/REW I Cassette tape FF/REW detection. “L“ : FF or REW works.29-31 - - - -32 SD I Signal detection.“H“ : Signal e
18、xists.“L“ : Signal does not exist.33 VSS 1 - GND. -34 - - - -35 PLL CLK O Front-end communication clock. -36 PLL DATA I/O Front-end communication data. -37 AM +B O AM power supply SW. -38 FM +B O FM power supply SW. -39 IC2 DATA I/O E-volume communication data. -40 IC2 CLK O E-volume communication c
19、lock. -41 AFC O FM noise detection / Time constant SW. -42 MUTE O Mute control. -43 AMP MUTE O Power amplifier mute. -44 - - - -45 CH CNT O Changer control. -Pin No. Pin Name I/O Function Operating Condition46 REQ H O Changer request. -47 - - - -48 SVR O SVR control. -49 AMP STBY O Power amplifier s
20、tand-by. -50 BEEP O Buzzer signal output.51,52 - - - -53 P.CONT O Power control SW. -54 ACC DET I ACC detection. -55 B.U. DET I Back-up detection. -56 P.ON O Power SW. -57 ILLUMI O Illumination SW. -58 FWD/REV I Cassette mechanism FWD/REV detection. -59 - - - -60 RESET I System reset signal input. -
21、61 SEL 1 I Destination SW. -62 R CLK I RDS clock. -63 REQ C I Changer request. -64 PACK IN I Cassette tape pack-in detection. -65 KEY-REQ I Key signal input detection. -66 SEL 0 I Destination SW. -67 VSS 0 - GND. -68 VDD 1 - 5V power supply. -69 X2 - Main system clock. -70 X1 I Main system clock. -7
22、1 IC - GND. -72 - - - -73 XT1 - 5V power supply. -74 VDD 0 - 5V power supply. -75 AVREF 0 I A/D converter reference voltage. -76 S METER I S-meter detection.“H“ : S-meter exists.“L“ : S-meter does not exist.77 PHONE I -Navigation mute : 2.5V or more.Telephone mute : 1V or less.78 NOISE I FM noise de
23、tection. -79 AV CONT O A/D converter reference voltage. -80 - - - -MICROCOMPUTERS TERMINAL DESCRIPTIONKRC-17G/YA/YG, 194A/G/YA/YG, 266LA/LG/RGKRC-27YA/YG, 2904YA/YG, 294A/G/YA/YG5ADJUSTMENT(2-LINE TAPE)BABA(FWD)(RVS)HEIGHT(FWD)HEIGHT/AZIMUTH(FWD)HEIGHT/AZIMUTH(RVS)TAPE SPEEDHEIGHT(RVS)F FRRNo ITEM I
24、NPUT SETTINGSRECEIVERSETTINGSALIGNMENTPOINTSALIGN FORSDSDHEADHEIGHTHEADAZIMUTHTEST MODE : ON While holding the “FM“ key and preset “6“ key, reset the unit.TEST MODE : OFF Reset the unit.98.1MHz0 dev35dB(ANT input)990 kHz0% mod35dB(ANT input)SCC-1659TCC-15310kHzTEST MODE: ONFM 98.1MHzTEST MODE: ONAM
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- KenwoodKRC17GServiceManual 电路 原理图