Jvc-XVN-650-BAG-Service-Manual电路原理图.pdf
《Jvc-XVN-650-BAG-Service-Manual电路原理图.pdf》由会员分享,可在线阅读,更多相关《Jvc-XVN-650-BAG-Service-Manual电路原理图.pdf(16页珍藏版)》请在收音机爱好者资料库上搜索。
1、SCHEMATIC DIAGRAMSDVD PLAYERNo.YD121SCH2007/7COPYRIGHT 2007 Victor Company of Japan, LimitedCD-ROM No.SML200707XV-N650BAG,XV-N652SAG,XV-N652SAS,XV-N652SAAXV-N650BAG,XV-N652SAG,XV-N652SAS,XV-N652SAA D7P3Area SuffixAG - Universal AsiaAS - Saudi ArabiaAA - AustraliaThis service manual is a service manu
2、al of a model in which destination added to the issued servicemanual XV-N650B, XV-N652S (issue number: YD119 2007/4).This service manual consists of only “Parts List,“ “Standard Schematic Diagrams,“ “Printed Circuit Boards,“Block Diagrams,“ and “Instruction Book.“ Regarding service information other
3、 than these sections,refer to the service manual XV-N650B, XV-N652S (issue number: YD119 2007/4).!CHARTS AND DIAGRAMSNOTES OF SCHEMATIC DIAGRAMSafety precautionsThe Components indentified by the symbol arecritical for safety. For continued safety, replace safetycritical components only with manufact
4、urers recom-mended parts.1. Units of components on the schematic diagramUnless otherwise specified.1) All resistance values are in ohm. 1/6 W, 1/8 W (refer toparts list).Chip resistors are 1/16 W.K: K(1000), M: M (1000K)2) All capacitance values are in F, (P: PF).3) All inductance values are in H, (
5、m: mH).4) All diodes are 1SS133, MA165 or 1N4148M (refer to partslist).2. Indications of control voltageAUX : Active at high.AUX or AUX(L) : Active at low.3. Interpreting Connector indicationsNote: If the voltages are not indicated on the schematicdiagram, refer to the voltage charts.12 32.5(5.0)1.8
6、PB and REC modes(Voltage of PB and REC modesare the same)PB modeREC mode4. Voltage measurement1) Regulator (DC/DC CONV) circuitsREC : Colour bar signal.PB : Alignment tape (Colour bar). : Unmeasurable or unnecessary to measure.2) Indication on schematic diagramVoltage indications for REC and PB mode
7、 on the sche-matic diagram are as shown below.6. Indication of the parts for adjustmentsThe parts for the adjustments are surrounded with the circleas shown below.7. Indication of the parts not mounted on the circuit board“OPEN” is indicated by the parts not mounted on the circuitboard.R216OPEN12312
8、31231423Removable connectorWire soldered directly on boardNon-removable Board connectorBoard to BoardConnected pattern on boardThe arrows indicate signal pathNote: The Parts Number, value and rated voltage etc. in the Schematic Diagram are for references only. When replacing the parts, refer to the
9、Parts List.CIRCUIT BOARD NOTES1. Foil and Component sides1) Foil side (B side) :Parts on the foil side seen from foil face (pattern face)are indicated.2) Component side (A side) :Parts on the component side seen from component face(parts face) indicated.2. Parts location guidesParts location are ind
10、icated by guide scale on the circuit board.Parts location are indicated by guide scale on the circuit board.LOCATIONREF No.IC101 B C 6 AIC Category : ICHorizontal “A” zoneVertical “6” zoneB : Foil side(A : Component side)C : Chip componentD : Discrete component)2-1 2-2A12345BCDEFGBlock diagramsMMDIS
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- JvcXVN650BAGServiceManual 电路 原理图