Amc-XT-tun-sm维修电路原理图.pdf
《Amc-XT-tun-sm维修电路原理图.pdf》由会员分享,可在线阅读,更多相关《Amc-XT-tun-sm维修电路原理图.pdf(8页珍藏版)》请在收音机爱好者资料库上搜索。
1、STEREO TUNERRadioFans.CN 收音机爱 好者资料库TUNER ALIGNMENT PROCEDURE FM SECTION A. PREPARATION 1. Set stereo modulator to mono mode with 1KHz modulating signal unless otherwise state. 2. Set signal generator to FM mode with 75KHz deviation. 3. Store the following frequencies: 87.5MHz, 90.1MHz, 98.1MHz, 106.
2、1MHz and 107.9MHz. 4. RF levels are open circuit voltages of signal generator with 75 ohms output impedance. B. OSCILLATOR TUNING VOLTAGE 1. Connect DVM between FE1 No. 5 PIN and ground. 2. Tune to 87.5MHz and check DVM for reading of 3Vdc +/-0.5Vdc 3. Tune to 107.9MHz and check DVM for reading of 2
3、0.5Vdc +/-0.5Vdc. If either of the above is out of tolerance, adjust FE1 (oscillator coil L101) until both readings are within tolerance. C. I.F. 1. Connect DVM between TP2 and TP3. 2. Apply 98.1MHz (60dBu) to FM antenna input and tune to 98.1MHz. 3. Adjust IFT1 (FM IF) for 0Vdc +/-50mV reading on D
4、VM. 4. Adjust IFT2 (FM IF) until minimum THD is achieved at audio output. 5. Repeat (3) and (4) until no further improvement can be made. D. FRONT-END I.F. 1. Apply 98.1MHz (12dBu) to antenna input and tune to 98.1MHz. 2. Carefully adjust FE1 IFT until minimum THD is achieved at audio output. E. R.F
5、. 1. Apply 98.1MHz (7dBu) to antenna input and tune to 98.1MHz. 2. Check if THD is better than 3%. If not, proceed to (3). 3. Adjust FRONT-END COILS (L102 - L104) by squeezing or stretching using a non-metallic tool until THD is better than 3%. 4. Check THD at 90.1MHz and 106.1MHz with 8dBu input. I
6、f THD is more than 3% for both frequencies, re-adjust until required THD is met. F. AUTOSEARCH AND FM STEREO LEVEL 1. Turn VR2 fully clockwise. 2. Set stereo modulator to L=R mode and 98.1MHz (32dB) to antenna input. 3. Adjust VR2 clockwise until “S” light up in the LCD. RadioFans.CN 收音机爱 好者资料库4. Ch
7、eck if auto-search operation is working properly at antenna input level of 28dB. G. CENTER TUNER LED 1. Turn VR1 fully clockwise. 2. Set stereo modulator to MONO mode and 98.1MHz (26dB) to antenna input. 3. Adjust VR2 clockwise until “I” display in the LCD. H. STEREO SEPARATION AND PILOT SUPPRESSION
8、 1. Modulate L- only at 98.1MHz (68dBu) and adjust VR3 for minimum output on right channel. 2. Modulate R- only and adjust VR3 for minimum output on left channel. 3. Repeat (1) and (2) until readings are the same and within specification (45dB). 4. Turn off modulating signal but leave pilot tone. 5.
9、 Adjust FL6 and FL7 for minimum output on left and right channels, respectively. AM SECTION A. PREPARATION 1. Set signal generator to AM mode with 1KHz at 30% modulation. 2. Connect 22pF ceramic capacitor between signal generator and AM antenna input terminal input; the capacitor should be as close
10、as possible to antenna input terminal. 3. Store the following frequencies: 600KHz, 1000KHz and 1400KHz. B. OSCILLATOR TUNING VOLTAGE 1. Connect DVM between TP4 and TP5 (Ground). 2. Tune to 600KHz and adjust L4 (AM OSC) for 1.75Vdc +/-50mV reading on DVM. C. I.F. 1. Apply 1000KHz (45dBu) to antenna i
11、nput. 2. Tune to 1000KHz and adjust IFT3 (AM IFT) for maximum reading on audio output. D. R.F. 1. Apply 600KHz (45dBu) to antenna input. 2. Tune to 600KHz and adjust L3 (AM ANT) for maximum reading on audio output. 3. Apply 1400KHz (45dBu) to antenna input. 4. Tune to 1400KHz and adjust C26 (VC TRIM
12、) for maximum reading on audio output. 5. Repeat (1) to (4) until no further improvement can be made. ITEM PART NUMBERLOCATIONQTY1 90-1742-2MODULE, TUNER MAIN PCBXT12 29R-1236-220L5.6.INDUCTOR 22uH 10% SMD 121023 29R-1236-2R2L1.INDUCTOR 2u2H 10% SMD 121014 29R-1236-680L2.INDUCTOR 68uH 10% SMD 121015
13、 30R-LC72131MIC4.IC FREQ SYNTHESIZER LC72131MMFP20 RoHS SANYO16 30R-MMBD4148D5.6.8.12.13.14DIODE SWITCHING MMBD4148/914DIODE 0.2A/75V SOT-2367 30R-MMBT4401LT1Q1.10.11.12.14.15.19.20.26.TR NPN MMBT4401LT1ON 0.6A/40V SOT-2398 30R-MMBT4403LT1Q9.13.25TR PNP MMBT4403LT1ON 0.6A/40V SOT-2339 30R-M4D9.10.11
14、RECTIFIER DIODE M41A 400V SMA WILLAS310 30R-AT32L-8AUIC9.IC ATMEGA32L-8AU 8-BIT AVR8K FLASH TQFP 44A 111 30R-2SC1815GRQ2.3.TR NPN 2SC1815GR TAP TOSHIBA212 30R-2SC829CQ4.5.6.7.8.TR NPN 2SC829C TO-92 TAP513 30R-J112Q16.17.18.TR JFET N-ch J112 35V 350mWXT TO-92 ON/FAIRCHILD314 17R-2019C26.VC TRIM 30PF
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- Amc XT tun sm 维修 电路 原理图