McIntosh-MVP831-cd-sm 维修电路原理图.pdf
《McIntosh-MVP831-cd-sm 维修电路原理图.pdf》由会员分享,可在线阅读,更多相关《McIntosh-MVP831-cd-sm 维修电路原理图.pdf(13页珍藏版)》请在收音机爱好者资料库上搜索。
1、SERVICE MANUALCOMPACT DISC TRANSPORTPerformance Specifications . 2Notes . 2Safety Information. 2Rear Panel. 3Section Location . 3Block Diagram . 4Interconnection Diagram . 5 - 6Main . 7 - 8A/V Power Supply Schematic and PCB . 9 - 12Display Schematic and PCB . 13 - 16Parts List. 15 - 16Exploded View
2、and Parts List. 17 - 18Repacking Instructions . 19CONTENTSRadioFans.CN 收音机爱 好者资料库General SpecificationsVideo SpecificationsDigital OutputOptical: -15dbm to -21dbmCoaxial: 0.5V p-p/75 ohmDigital Signal FormatSampling Frequency:44.1kHz & 48kHzTransportLaser Beam Wavelength:655nmLaser PowerCLASS IIPowe
3、r Requirements100 Volts, 50/60Hz at 28 watts110 Volts, 50/60Hz at 28 watts120 Volts, 50/60Hz at 28 watts220 Volts, 50/60Hz at 28 watts230 Volts, 50/60Hz at 28 watts240 Volts, 50/60Hz at 28 wattsNote: Refer to the rear panel of the MVP831 for the correctvoltage.DimensionsFront Panel:17-1/2 inches (44
4、.5cm) wide, 5-3/8inches (13.7cm) high, depth behind front mountingpanel is 15 inches (38.1cm) including clearance forconnectors. Panel clearance required in front ofmounting panel is 3/4 inch (1.9cm).Note: When the DVD/CD tray is opened, the panel clearancerequired in front of mounting panel is 6-3/
5、4 inches (17.2cm).Weight20 pounds (9.0Kg) net, 34 pounds (15.4Kg) inshipping cartonSignal SystemNTSCS-Video Y Output Level1Vp-p (75 OHM)S-Video C Output Level0.286Vp-p (75 OHM) (NTSC)Video Output Level1Vp-p (75 OHM)Audio SpecificationsNumber of Channels2Output level2.2VrmsDVD Frequency Response4-22K
6、Hz (48KHz Sampling, Linear Audio)4-44KHz (96KHz Sampling, Linear Audio)CD Frequency Response4-20KHzCD Signal to Noise RatioBetter than 110dB (A-weighted)DVD Dynamic RangeBetter than 100dB (Linear Audio)CD Dynamic RangeBetter than 98dBHarmonic Distortion0.003% (1KHz)Channel SeparationBetter than 110d
7、B (1KHz)RadioFans.CN 收音机爱 好者资料库PERFORMANCE SPECIFICATIONS2VIDEO SPECIFICATIONSSignal System:NTSCS-Video Y Output Level:1Vp-p (75 ohm)S-Video C Output Level:0.286Vp-p (75 ohm) (NTSC)Video Output Level:1Vp-p (75 ohm)AUDIO SPECIFICATIONSNumber Of Channels:2Output Level:2.2VrmsDVD Frequency Response4-22
8、kHz (48kHz Sampling, LinearAudio)4-44kHz (96kHz Sampling, LinearAudio)CD Frequency Response:4-20kHzCD Signal To Noise Ratio:Better than 110dB (A-weighted)DVD Dynamic Range:Better than 100dB (Linear Audio)CD Dynamic Range:Better than 98dBHarmonic Distortion:0.003% (1kHz)Channel Separation:Better than
9、 110dB (1kHz)GENERAL SPECIFICATIONSDigital OutputOptical:-15dbm to -21dbmCoaxial:0.5V p-p/75 ohmTransportLaser Power:CLASS IILaser Beam Wavelength:655nmDigital Signal FormatSampling Frequency:44.1kHz and 48kHzPower Requirements100 Volts, 50/60Hz at 30 watts110 Volts, 50/60Hz at 30 watts120 Volts, 50
10、/60Hz at 30 watts220 Volts, 50/60Hz at 30 watts230 Volts, 50/60Hz at 30 watts240 Volts, 50/60Hz at 30 wattsNote: Refer to the rear panel of the MVP831 for the correct voltage.DimensionsFront Panel:17-1/2 inches (44.5cm) wide, 5-3/8 inches(13.7cm) high, depth behind front mounting panel is 15 inches(
11、38.1cm) including clearance for connectors. Panel clearancerequired in front of mounting panel is 3/4 inch (1.9cm).Note: When the DVD/CD tray is opened, the panel clearance requiredin front of mounting panel is 6-3/4 inches (17.2cm).1. The heavy notes on the schematic denote the primarysignal path.2
12、. Unless otherwise noted, all voltages indicated on theschematics are measured under the following conditions:a. AC input at 120 volts, 50/60Hz.b. All voltages are +/-10% with respect to ground. Ahigh impedance (10 megaohm) voltmeter must be used.3. Unless otherwise specified:a. Resistor values are
13、in ohms.b. Capacitor values are microfarads (uF).c. Inductor values are in microhenries (uH).4.On PC board drawings, Square pad indicates:a. Polarized Capacitors - Positiveb. Diodes - Cathodec. Others - Pin 15.WARNINGParts marked with the symbol have criticalcharacteristics. Use only replacement par
14、ts recom-mended by the manufacturer.SAFETY INFORMATIONNOTESCAUTION: The use of optical instruments with thisproduct will increase eye hazard.This product utilizes a class 1 laser. Invisible laserradiation is emitted from the optical pickup lens when theunit is turned on.1. Do not look directly into
15、the pickup lens.2. Do not use optical instruments to look at the pickuplens.3. Do not adjust the preset variable resistor on theoptical pickup.4. Do not disassemble the optical pickup unit.5. Use of controls or adjustment or performance ofprocedures other than those specified herein mayresult in haz
16、ardous radiation exposure.6. Replace optical pickup only with manufacturersspecified type.LUOKAN 1 LASERLAITEKLASS 1 LASER APPARATVAROITUS! Laitteen kayttaminen muulla kuin tassakayttoohjeessa mainitulla tavalla saattaa altistaakayttajan turvallisuusluokan 1 ylittavallenakymattomalle lasersateiiylle
17、.VARNING! Om apparaten anvands pa annat satt an idenna bruksanvisning specificerats, kan anvandarenutsattas for osynbg laserstraining, som overskridergransen for laserklass 1.Laser output:0.65mWWavelength:665nmThis product utilizes an embedded class 2 laser (IEC825).MVP8313REAR PANELSECTION LOCATION
18、STOP VIEW WITH COVER REMOVED4BLOCK DIAGRAM56MVP831INTERCONNECTMAIN 320092782AUDIO/VIDEO POWER SUPPLY049277910MVP8313AUDIO/VIDEO POWER SUPPLY 04927711123DISPLAY 0492784MVP8311314PARTS LIST4DISPLAY 049278PART NODESCRIPTIONREFERENCE NO049278 AUDIO VIDEO POWER SUPPLY058145FIBER OPTIC TRANSMITTEROPT 1061
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- McIntosh-MVP831-cd-sm 维修电路原理图 McIntosh MVP831 cd sm 维修 电路 原理图