Integra-CDC3_4-cd-sm 维修电路原理图.pdf
《Integra-CDC3_4-cd-sm 维修电路原理图.pdf》由会员分享,可在线阅读,更多相关《Integra-CDC3_4-cd-sm 维修电路原理图.pdf(64页珍藏版)》请在收音机爱好者资料库上搜索。
1、CDC-3.4SERVICE MANUALSERVICE MANUALCOMPACT DISC CHANGERBlack modelMODEL CDC-3.4120V AC, 60HzBMDDRef. No. 3783Oct, 2003RC-553CSAFETY-RELATED COMPONENT WARNING!COMPONENTS IDENTIFIED BY MARK ON THESCHEMATIC DIAGRAM AND IN THE PARTS LIST ARECRITICAL FOR RISK OF FIRE AND ELECTRIC SHOCK.REPLACE THESE COMP
2、ONENTS WITH ONKYOPARTS WHOSE PART NUMBERS APPEAR AS SHOWNIN THIS MANUAL.MAKE LEAKAGE-CURRENT OR RESISTANCEMEASUREMENTS TO DETERMINE THAT EXPOSEDPARTS ARE ACCEPTABLY INSULATED FROM THESUPPLY CIRCUIT BEFORE RETURNING THEAPPLIANCE TO THE CUSTOMER.RadioFans.CN 收音机爱 好者资料库CDC-3.4SPECIFICATIONCDC-3.4 (Comp
3、act Disc Changer)Signal readout system.Optical non-contactFrequency response.5 Hz-20 kHzSN ratio.98 dBAudio Dynamic range.96 dBTHD (Total harmonic distortion).0.005% (at 1 kHz)Audio output (Digital/Optical).-22.5 dBmAudio output/Impedance (Digital/Coaxial).0.5 V (p-p) / 75 ohm Audio output/Impedance
4、 (Analog).2.0 V (rms) / 470 ohmPower supply rating.AC 120 V 60 HzPower consumption.10 WStandby power consumption.4 WDimensions (WxHxD).17-1/8 x 5-3/16 x 17-3/16(435 x 131 x 436 mm)Weight.15.0 lbs. (6.8 kg)Operating conditions Temperature/Humidity.41-95 F (5 -35 C) / 25-80%Disc compatibilityCD, CD-R,
5、 CD-RWRC-553C (Remote Controller)Transmitter.InfraredSignal range.Approx. 16 ft., 5 metersPower supply.Two (AA/R6) batteries (1.5 V x 2)Specifications and features are subject to change without notice.RadioFans.CN 收音机爱 好者资料库CDC-3.4SERVICE PROCEDURESPROTECTION OF EYES FROM LASER BEAM DURING SERVICING
6、This set employs a laser. Therefore, be sure to follow carefully the instructions below when servicing.WARNING!SERVICE WARNING : DO NOT APPROACH THELASER EXIT WITH THE EYE TOO CLOSELY.IN CASE IT IS NECESSARY TO CONFIRM LASERBEAM EMISSION, BE SURE TO OBSERVE FROMA DISTANCE OF MORE THAN 30cm FROM THES
7、URFACE OF THE OBJECTIVE LENS ON THEOPTICAL PICKUP BLOCK.Laser Diode PropertiesMaterial: GaAS/GaAlAsWavelength: 780nmLaser output: max. 0.5mW*Emission Duration: continuous*This output is the value measured at a distance about 1.8mm from the objective lens surface on the Optical Pickup Block.LASER WAR
8、NING LABELThe labels shown below are affixed.DANGER:INVISIBLE LASER RADIATION WHEN OPEN AND INTERLOCK FAILED OR DEFEATED. AVOID DIRECT EXPOSURE TO BEAM.CAUTION:HAZARDOUS LASER AND ELECTROMAGNETIC RADIATION WHEN OPEN AND INTERLOCK DEFEATED.ATTENTION:RAYONNEMENT LASER ET ELECTROMAGNETIQUE DANGEREUX SI
9、 OUVERT AVEC LECLENCHEMENT DE SECURITE ANNULE.Safety check outAfter correcting the original service problem perform the following safety check before releasing the set to the customer.Connect the insulating-resistance tester between theplug of power supply cord and terminal GND on the back panel.Spe
10、cifications: More than 10 M ohm at 500V.(Only U.S.A. model)Warning labelInitializing the unitPress STOP key and STANDBY key at same time.Displayed INITIALIZE on the FL display.CDC-3.4PANEL VIEW-1Standby/On buttonThis button is used to set the CDC-3.4 to On or Standby. Standby indicatorThis indicator
11、 lights up when the CDC-3.4 is in Standby mode.Repeat buttonThis button is used with the Repeat function.Random buttonThis button is used with the Random function.Dimmer buttonThis button is used to adjust the display brightness.Display buttonThis button is used to display elapsed, remaining, and to
12、tal time information about the current disc or track and various information about MP3 tracks.Remote control sensorThis sensor receives control signals from the remote controller .Open/Close buttonThis button is used to open and close the disc tray.Disc Select buttonsThese buttons are used to select
13、 discs. Playback starts automatically when a disc is selected with one of these buttons.Play/pause buttonThis button is used to start and pause playback.Stop buttonThis button is used to stop playback./ & Folder / buttonsThese buttons are used to select the previous and next tracks and to navigate f
14、olders on MP3 discs./ & Folder / buttonsThese buttons are used for fast reverse and fast forward and to navigate folders on MP3 discs.Disc Skip buttonThis button is used to turn the disc tray when loading or removing discs and to select discs for play-back.Disc tray lightThis light illuminates the d
15、isc tray. It comes on when the CDC-3.4 is turned on and gets brighter when the disc tray is open.DisplayDisc trayFRONT PANEL123456789101112131415123456789101112131415RANDOM indicatorMEMORY indicatorREPEAT indicatorDISC indicatorThe number of the current disc appears here.FLDR (FOLDER) indicatorWhile
16、 stopped, the total number of folders on the current MP3 disc are displayed. During playback, the number of the current folder is displayed.NEXT indicatorThis indicator appears when using the Next Selection function.TRACK indicatorWhile stopped, the total number of tracks on the current disc are dis
17、played. During playback, the number of the current track is displayed.NAME indicatorThis indicator appears when the current disc is an MP3 disc and a name (disc, folder, track) is being displayed.TOTAL indicatorThis indicator appears when the total remain time is displayed. REMAIN indicatorPlay / Pa
18、use indicatorMP3 indicatorDisc indicators 1-6TRACKNEXTTOTALDISCMP3362514FLDRREPEATMEMORYRANDOMREMAINNAME1234567891011121312345678910111213FL DISPLAYANALOG AUDIO OUTPUTThese RCA/phono connectors can be connected to the analog audio inputs on a hi- amp or AV receiver.COAXIAL & OPTICAL DIGITAL AUDIO OU
19、TPUTThese connectors can be used to connect a CD-R, MiniDisc, DAT recorder, digital amp, or other equipment with digital inputs. REMOTE CONTROLThese (Remote Interactive) connectors can be connected to the connectors on your other Integra/Onkyo AV components for interactive control.To use you must al
20、so make analog audio con-nections (RCA/phono) between the CDC-3.4 and your other Integra/Onkyo equipment.AC INLETThe supplied power cord is connected here. The other end of the power cord should be connected to a suitable wall outlet.RS 232This RS-232 port can be connected to an external controller.
21、IR IN/OUTThe IR IN connector can be used to connect a com-mercially available IR receiver, which can be used to pickup signals from the remote controller when the CDC-3.4 is located in another room, installed in a rack, or is out of range of the remote controller.The IR OUT connector can be used to
22、connect a commercially available IR emitter, which can be used to pass remote controller signals received by the IR IN along to other AV components.IROUTINMODEL NO. CDC-3.42-1, NISSHIN-CHO, NEYAGAWA-SHI, OSAKA,JAPAN MADE IN CHINACOMPACT DISC CHANGERIntegra Division ofONKYO CORPORATIONRATING:AC 120 V
23、 60 Hz 10 WRS 232AC INLET123456123456REAR PANELCDC-3.4PANEL VIEW-2On buttonThis button is used to turn on the CDC-3.4.Standby buttonThis button is used to set the CDC-3.4 to Standby.Number buttonsThese buttons are used to enter track and MP3 folder numbers.Search (10) buttonThis button is used to en
24、ter track numbers above 10 and to select MP3 folders.Operation buttonsPause buttonThis button is used to pause playback.Stop buttonThis button is used to stop playback.Play buttonThis button is used to start playback./ & Folder / buttonsThese buttons are used for fast reverse and fast forward, and t
25、o navigate folders on MP3 discs.Next Selection buttonThis button is used with the Next Selection function for cuing up the next track.Disc Select buttonsThese buttons are used to select discs. Playback starts automatically when a disc is selected with one of these buttons.Open/Close buttonThis butto
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- Integra-CDC3_4-cd-sm 维修电路原理图 Integra CDC3_4 cd sm 维修 电路 原理图