LCAudio-TheEndMillennium-pwr-sm 维修电路原理图.pdf
《LCAudio-TheEndMillennium-pwr-sm 维修电路原理图.pdf》由会员分享,可在线阅读,更多相关《LCAudio-TheEndMillennium-pwr-sm 维修电路原理图.pdf(20页珍藏版)》请在收音机爱好者资料库上搜索。
1、The EndMillenniumThe End Millennium is a high quality Power Amplifier, in power sizes of 99 to 300 Watts (8 Ohms).While running in Class A/B the high sound quality is reached through a number of advanceddesign strategies. First of all no feedback loops is found in the circuit, as any error that migh
2、t be corrected by the feedback loop, cannot be corrected before it is factual, and then - obviously - it is too late. A simple circuit topology with a minimum of high quality components ensures short signal path. Polyprop Capacitors, Vertical bipolar multi emitter transistors, glass substrate resist
3、ors to mention some of the high-tech components used.The higher frequencies are played with simplicity through the ultra fast amplifier (linear to 500.000Hz)and the four stage output power tunnel gives a firm and fast bass reproduction. The total soundstage is well controlled and well defined, with
4、precise space and nerve visuality.Audio Power Amplifier.Cook Book.RadioFans.CN 收音机爱 好者资料库The End MillenniumL C Audio Technology2Copying and distribution of this material is allowed, but any commercial use is strictly prohibited without the written permission of L C Audio Technology.Further informati
5、on: Adjustment procedureAssembly InstructionsCabinet descriptionConnection of inputsConnection of the outputsConnections to the ext. BoardsHigh Power Systems based on MillenniumNonfeedback = Musicality!Parts ListPCB SketchPower Supply ConsiderationsPrinciple behind the MillenniumSchematicUse of the
6、DC ServoContent.1712201415165411973818RadioFans.CN 收音机爱 好者资料库Principle behind The End Millennium.The principle schematic shows how simple the fundamental circuit of Millennium really is. There are no feedback loops (100% non-feedback), there are no capacitors or other sound depriving components near
7、 the signal path. The frequency responce is linear from DC to extreme hights: 500.000 Hz. This is probably the fastest amplifier You ever heard! Any part of the music from the deepest bass to the teeniest transient is reproduced with ease by the Millennium!The Millennium module also contains extra f
8、unctions such as DC servo and an effective short circuit protection. The protection will monitor if any overload is evident, and then shut down for a couple of seconds. No current limiters or signal limiters are used at all. Should an overload occur, the anp will automatically shut down, and wait fo
9、r things to normalize again. Then it will turn on and play normally. This system is so effective, that short circuit is allowed at full power for days!Owing to the new amplifier topology, which in several aspects is path breaking in modern audio technology, it has been possible to make available an
10、amplifier with a well controlled sound picture, a liquid flowing soundstage and extreme precision, at a very affordable price.The low price is primarily possible because You do the assembly work Yourself.(Hand built ready versions are available at a higher price).The four stage output power tunnel l
11、ets the speaker membranes draw all the current required, directly from the power reservoir. Not only to start the motion, but also to stop at the right microsecond.The End MillenniumL C Audio Technology3Copying and distribution of this material is allowed, but any commercial use is strictly prohibit
12、ed without the written permission of L C Audio Technology.100% Non-Feedback = 100% musicality!The warm - almost tube like - sound is mostly owing to the amplifier structure not containing the usual feedback loop. This principle is normally called non-feedback, and is also used in other brands of (co
13、stly) high-end amplifiers.In a normal amplifier (with feedback loop) a typical approach is to use a high-gain (up to 100.000 times) / high-distorsion circuit to perform the voltage amplification. By comparing the output signal on the speaker terminals to the input signal fed to the amplifier, it is
14、possible to send a correction signal to eliminate any error and thus reducing the measured harmonic distortion. However an error cannot be corrected before it is encountered, and then it is in fact too late, because the speakers are also connected to the erractic signal.In fact the error signal is c
15、omparable to eliminating waves in one end of a swimming pool by sending opposite waves from the other end. Not practical, unless the waves have a very low frequency, compared to the time it takes the correcting waves to reach the other end of the basin.Another problem occurs when You are trying to l
16、inearize a signal, that have been amplified by an unlinear (distorting) element. Then You will inevitable see modulation formerly known as TIM (Transient Inter Modulation). This is annoying is there is say two vocalists in a piece, but You actually hear a third un-harmonic tone. In better cases a lo
17、ss of audible details is found, but less annoying. Another way to detect modulation is when an amplifier changes sound when the volume is raised or lowered. In The End Millennium the sound is exactly the same no matter what playing level is required. It uses a quite different technique to eliminate
18、distortion. In a non-feedback topology there is no possibility to remove distortion once it is evident, so every method has to be enforced to avoid distortion. Ultra Linear Semiconductors, Highly Stable Resistors, no capacitors, and rounded PCB traces for all audio signals. All components used are b
19、rand-name highest graded stuff, that is only found in other amplifiers at a far higher price level.The result is uncomplicated, and extremely clear audio quality with absolutely no modulation, but instead streams of details and musical dynamics.The british made Z-Transistor is a vertical bipolar tra
20、nsistor built a way normally associated withMOSFETs . However the Z-transistor has much less Re (or Rs) than any FET or MOSFET, and therefore it produces less distortion in an audio circuit.The capacitance is negligible (6 pF) and very low noise is also a useful property.The End MillenniumL C Audio
21、Technology4High Power Millennium Systems.A basic Millennium amplifer is designed to run on a 33-0-33 V transformer and put out 120 Watts in 8 Ohms / 240 Watts in 4 Ohms. By adding an extra set of power transistors on an ext. Module, You may use the Millennium at higher power levels or lower impedanc
22、es (right down to 1 Ohm). One extra set of output devices will let the unit run on a 40-0-40 V transformer and provide 180 Watts in 8 Ohms / Two extra output modules will give You 350Watts in 4 Ohms. 3 Extra sets will give 250 Watts in 8 Ohms / 500 Watts in 4 Ohms with a 50-0-50 V transformer.The ex
23、tra output devices are placed on an ext. Module that also contains emitter resistors and appropriate bypassing caps to secure stability.Instead of higher voltages the impedance with the latter system may be sustained at 33-0-33 V (AC) and more than 800 Watts are available in 1 Ohm loads.Due to the r
24、isk of sound quality deprivation we do not recommend parallelling output devices that are goind to reproduce treble / midrange frequencies. Parallel devices have small differences that will result in high order (very audible) distortions, heard as aggressive sound at high volume levels. The solution
25、 is to have separate outputs for bass and treble/mid. However this requires the speakers to be bi-wirable. Most speakers have this feature today. One set of output devices drive the treble/mid output, while a number of additional sets enforces high current output in the bass output where high-order
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- LCAudio-TheEndMillennium-pwr-sm 维修电路原理图 LCAudio TheEndMillennium pwr sm 维修 电路 原理图