NAD-S170I-int-si1 维修电路原理图.pdf
《NAD-S170I-int-si1 维修电路原理图.pdf》由会员分享,可在线阅读,更多相关《NAD-S170I-int-si1 维修电路原理图.pdf(2页珍藏版)》请在收音机爱好者资料库上搜索。
1、 Service Information S170 You may have a complaint about the S170 initialising. This maybe due to the power supply connector pins making poor contact.To improve contact between the power supply and the pc boardperform the following .From the connector marked X27 ,the wires will haveto be soldered di
2、rectly to the pins on the pc board . This is a 6 pin connectorwith only 5 wires used. Unplug the connector from the board and cut thewires from the connector. Strip and solder each power supply wire to itscorresponding pin labelled on the pc board. See diagram 1. Use heat shrinktubing to prevent sho
3、rting the wires when soldering to the pins on the pcboard . I f the unit is received for general service this procedure should becarried out.Diagram 1! THIS AREA OF THE CONNECTOR POWER SUPPLY DO NOT TOUCH.X27 MAIN Cut wires here PC BOARD Strip and solder to pc board connectorwwContact:NAD Electronic
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- NAD-S170I-int-si1 维修电路原理图 NAD S170I int si1 维修 电路 原理图