Yamaha-RXV1900-avr-sm(1) 维修电路原理图.pdf
《Yamaha-RXV1900-avr-sm(1) 维修电路原理图.pdf》由会员分享,可在线阅读,更多相关《Yamaha-RXV1900-avr-sm(1) 维修电路原理图.pdf(198页珍藏版)》请在收音机爱好者资料库上搜索。
1、RX-V1900/HTR-6290/DSP-AX19001 0 111 3SERVICE MANUALIMPORTANT NOTICEThis manual has been provided for the use of authorized YAMAHA Retailers and their service personnel.It has been assumed that basic service procedures inherent to the industry, and more specifi cally YAMAHA Products, are already know
2、n and understood by the users, and have therefore not been restated.WARNING: Failure to follow appropriate service and safety procedures when servicing this product may result in personal injury, destruction of expensive components, and failure of the product to perform as specifi ed. For these reas
3、ons, we advise all YAMAHA product owners that any service required should be performed by an authorized YAMAHA Retailer or the appointed service representative.IMPORTANT: The presentation or sale of this manual to any individual or fi rm does not constitute authorization, certifi cation or recogniti
4、on of any applicable technical capabilities, or establish a principle-agent relationship of any form.The data provided is believed to be accurate and applicable to the unit(s) indicated on the cover. The research, engineering, and service departments of YAMAHA are continually striving to improve YAM
5、AHA products. Modifications are, therefore, inevitable and specifi cations are subject to change without notice or obligation to retrofi t. Should any discrepancy appear to exist, please contact the distributors Service Division.WARNING: Static discharges can destroy expensive components. Discharge
6、any static electricity your body may have accumulated by grounding yourself to the ground buss in the unit (heavy gauge black wires connect to this buss).IMPORTANT: Turn the unit OFF during disassembly and part replacement. Recheck all work before you apply power to the unit. CONTENTSTO SERVICE PERS
7、ONNEL .2FRONT PANELS .4REAR PANELS .69REMOTE CONTROL PANELS .10SPECIFICATIONS / 参考仕様 . 1116INTERNAL VIEW .17DISASSEMBLY PROCEDURES / 分解手順 .1826UPDATING FIRMWARE / 書込 .2733SELF-DIAGNOSTIC FUNCTION / (自己診断機能) .3469AMP ADJUSTMENT / 部調整 .70DISPLAY DATA .7172IC DATA .7383BLOCK DIAGRAMS .8487PRINTED CIRCU
8、IT BOARDS . 88119PIN CONNECTION DIAGRAMS .120122SCHEMATIC DIAGRAMS .123144REPLACEMENT PARTS LIST .145186REMOTE CONTROL .187190ADVANCED SETUP / 本機設定変更 .191197AV RECEIVER/AV AMPLIFIERRX-V1900/HTR-6290/DSP-AX1900animate 08.09P.O.Box 1, Hamamatsu, JapanCopyright 2008 All rights reserved.This manual is c
9、opyrighted by YAMAHA and may not be copied orredistributed either in print or electronically without permission.RadioFans.CN 收音机爱 好者资料库RX-V1900/HTR-6290/DSP-AX19002RX-V1900/HTR-6290/DSP-AX1900This product contains chemicals known to the State of California to cause cancer, or birth defects or other
10、reproductive harm.DO NOT PLACE SOLDER, ELECTRICAL/ELECTRONIC OR PLASTIC COMPONENTS IN YOUR MOUTH FOR ANY REASON WHATSOEVER!Avoid prolonged, unprotected contact between solder and your skin! When soldering, do not inhale solder fumes or expose eyes to solder/flux vapor!If you come in contact with sol
11、der or components located inside the enclosure of this product, wash your hands before handling food.1. Critical Components InformationComponents having special characteristics are marked and must be replaced with parts having specifications equal to those originally installed.2. Leakage Current Mea
12、surement (For 120V Models Only)When service has been completed, it is imperative to verify that all exposed conductive surfaces are properly insulated from supply circuits. Meter impedance should be equivalent to 1500 ohms shunted by 0.15 F.“CAUTION”“F1, F2: FOR CONTINUED PROTECTION AGAINST RISK OF
13、FIRE, REPLACE ONLY WITH SAME TYPE 10A, 125V FUSE.”CAUTIONF1, F2: REPLACE WITH SAME TYPE 10A, 125V FUSE.ATTENTIONF1, F2: UTILISER UN FUSIBLE DE RECHANGE DE MME TYPE DE 10A, 125V.本機搭載基板付接合部無鉛付。無鉛種類、修理時下記無鉛使用推奨。 Sn+Ag+Cu(錫 + 銀 + 銅) Sn+Cu(錫 + 銅) Sn+Zn+Bi(錫 + 亜鉛 + )注意:無鉛融点温度通常鉛入比 30 40程度高、 合使用。All of the
14、 P.C.B.s installed in this unit and solder joints are soldered using the lead free solder.Among some types of lead free solder currently available, it is recommended to use one of the following types for the repair work. Sn + Ag + Cu (tin + silver + copper) Sn + Cu (tin + copper) Sn + Zn + Bi (tin +
15、 zinc + bismuth)Caution:As the melting point temperature of the lead free solder is about 30C to 40C (50F to 70F) higher than that of the lead solder, be sure to use a soldering iron suitable to each solder. TO SERVICE PERSONNEL Leakage current must not exceed 0.5mA. Be sure to test for leakage with
16、 the AC plug in both polari-ties.WALLOUTLETEQUIPMENTUNDER TESTAC LEAKAGETESTER OREQUIVALENTINSULATINGTABLEWARNING: CHEMICAL CONTENT NOTICE!About lead free solder / 無鉛RadioFans.CN 收音机爱 好者资料库RX-V1900/HTR-6290/DSP-AX19003RX-V1900/HTR-6290/DSP-AX1900CAUTIONDanger of explosion if battery is incorrectly r
17、eplaced.Replace only with the same or equivalent type.WARNING: Lithium batteries注意正電池交換爆発起。同一型名同等品以外電池絶対交換。WARNING: Lithium batteries are dangerous because they can be exploded by improper handling. Observe the following precautions when handling or replacing lithium batteries. Leave lithium battery
18、 replacement to qualified service personnel. Always replace with batteries of the same type. When installing on the PC board by soldering, solder using the connection terminals provided on the battery cells. Never solder directly to the cells. Perform the soldering as quickly as possible. Never reve
19、rse the battery polarities when installing. Do not short the batteries. Do not attempt to recharge these batteries. Do not disassemble the batteries. Never heat batteries or throw them into fire.ADVARSEL!Lithiumbatteri Eksplosionsfare ved fejlagtig hndtering.Udskiftning m kun ske med batteri af samm
20、e fabrikat og type. Levr det brugte batteri tilbage til leverandren.VARNINGExplosionsfara vid felaktigt batteribyte. Anvnd samma batterityp eller an ekvivalent typ som rekommenderas av apparattillverkaren. Kassera anvnt batteri enligt fabrikan-tens instruktion.VAROITUSParisto voi rjht, jos se on vir
21、heellisesti asennettu.Vaihda paristo ainoastaan laitevalmistajan suosittelemaan tyyppiin. Hvit kytetty peristo valmistajan ohjeiden mu-kaisesti.RX-V1900/HTR-6290/DSP-AX190011RX-V1900/HTR-6290/DSP-AX1900 Audio Section / 部Minimum RMS Output Power (Power Amp. Section) / 定格出力 ( 部 ) (20 Hz to 20 kHz)FRON
22、T L/RU, C, R, T, K, A, B, G, E, L models (0.04 % THD, 8 ohms) .130 W + 130 WJ model (0.06 % THD, 6 ohms) .130 W + 130 WCENTERU, C, R, T, K, A, B, G, E, L models (0.04 % THD, 8 ohms) .130 WJ model (0.06 % THD, 6 ohms) .130 WSURROUND L/RU, C, R, T, K, A, B, G, E, L models (0.04 % THD, 8 ohms) .130 W +
23、 130 WJ model (0.06 % THD, 6 ohms) .130 W + 130 WSURROUND BACK L/RU, C, R, T, K, A, B, G, E, L models (0.04 % THD, 8 ohms) .130 W + 130 WJ model (0.06 % THD, 6 ohms) .130 W + 130 WMaximum Power / 実用最大出力 (JEITA, 1 kHz, 10 % THD) FRONT L/RR, T, K, L models (8 ohms) .175 W + 175 WJ model (6 ohms) .175
24、W + 175 WCENTERR, T, K, L models (8 ohms) .175 WJ model (6 ohms) .175 WSURROUND L/RR, T, K, L models (8 ohms) .175 W + 175 WJ model (6 ohms) .175 W + 175 WSURROUND BACK L/RR, T, K, L models (8 ohms) .175 W + 175 WJ model (6 ohms) .175 W + 175 WDynamic Power Per Channel (IHF) FRONT L/R (8/6/4/2 ohms)
25、U, C, R, T, K, A, L models .160/195/255/335 WMax. Power Per Channel (1 kHz, 0.7 % THD, 4 ohms)B, G, E modelsFRONT L/R .180 W + 180 WCENTER .180 WSURROUND L/R .180 W + 180 WSURROUND BACK L/R .180 W + 180 WDynamic Headroom U, C, R, T, K, A, L models8 ohms .0.9 dBIEC Power (1 kHz, 0.04 % THD, 8 ohms) B
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- Yamaha-RXV1900-avr-sm1 维修电路原理图 Yamaha RXV1900 avr sm 维修 电路 原理图