Yamaha-RXV861-avr-sm(1) 维修电路原理图.pdf
《Yamaha-RXV861-avr-sm(1) 维修电路原理图.pdf》由会员分享,可在线阅读,更多相关《Yamaha-RXV861-avr-sm(1) 维修电路原理图.pdf(143页珍藏版)》请在收音机爱好者资料库上搜索。
1、SERVICE MANUAL101043IMPORTANT NOTICEThis manual has been provided for the use of authorized YAMAHA Retailers and their service personnel.It has been assumed that basic service procedures inherent to the industry, and more specifically YAMAHA Products, are alreadyknown and understood by the users, an
2、d have therefore not been restated.WARNING:Failure to follow appropriate service and safety procedures when servicing this product may result in personalinjury, destruction of expensive components, and failure of the product to perform as specified. For these reasons,we advise all YAMAHA product own
3、ers that any service required should be performed by an authorizedYAMAHA Retailer or the appointed service representative.IMPORTANT:The presentation or sale of this manual to any individual or firm does not constitute authorization, certification orrecognition of any applicable technical capabilitie
4、s, or establish a principle-agent relationship of any form.The data provided is believed to be accurate and applicable to the unit(s) indicated on the cover. The research, engineering, andservice departments of YAMAHA are continually striving to improve YAMAHA products. Modifications are, therefore,
5、 inevitableand specifications are subject to change without notice or obligation to retrofit. Should any discrepancy appear to exist, pleasecontact the distributors Service Division.WARNING:Static discharges can destroy expensive components. Discharge any static electricity your body may haveaccumul
6、ated by grounding yourself to the ground buss in the unit (heavy gauge black wires connect to this buss).IMPORTANT:Turn the unit OFF during disassembly and part replacement. Recheck all work before you apply power to the unit.I CONTENTSTO SERVICE PERSONNEL . 2FRONT PANELS. 34REAR PANELS . 58REMOTE C
7、ONTROL PANELS. 9SPECIFICATIONS / 参考仕様 . 1012INTERNAL VIEW . 13DISASSEMBLY PROCEDURES / 分解手順. 1419UPDATING FIRMWARE /書込. 2027SELF DIAGNOSIS FUNCTION (DIAG) /自己診断機能(). 2855CONFIRMATION OF IDLING CURRENT OF AMP UNIT /電流確認 . 56DISPLAY DATA . 57IC DATA . 5871PIN CONNECTION DIAGRAMS. 7275BLOCK DIAGRAMS .
8、7679PRINTED CIRCUIT BOARDS. 8095SCHEMATIC DIAGRAMS. 97107REPLACEMENT PARTS LIST . 109135REMOTE CONTROL. 136139ADVANCED SETUP / 本機設定変更. 140142SCENE CONTROL. 143AV RECEIVER/AV AMPLIFIERRX-V861/HTR-6080/DSP-AX861SE/DSP-AX861P.O.Box 1, Hamamatsu, JapanRX-V861/HTR-6080/DSP-AX861SE/DSP-AX861 2007 All righ
9、ts reserved.This manual is copyrighted by YAMAHA and may not be copied orredistributed either in print or electronically without permission. 07.04RadioFans.CN 收音机爱 好者资料库RX-V861/HTR-6080/DSP-AX861SE/DSP-AX8612RX-V861/HTR-6080/DSP-AX861SE/DSP-AX861WALLOUTLETEQUIPMENTUNDER TESTAC LEAKAGETESTER OREQUIVA
10、LENTINSULATINGTABLEWARNING: CHEMICAL CONTENT NOTICE!The solder used in the production of this product contains LEAD. In addition, other electrical/electronic and/or plastic (whereapplicable) components may also contain traces of chemicals found by the California Health and Welfare Agency (andpossibl
11、y other entities) to cause cancer and/or birth defects or other reproductive harm.DO NOT PLACE SOLDER, ELECTRICAL/ELECTRONIC OR PLASTIC COMPONENTS IN YOUR MOUTH FOR ANY REA-SON WHATSOEVER!Avoid prolonged, unprotected contact between solder and your skin! When soldering, do not inhale solder fumes or
12、 exposeeyes to solder/flux vapor!If you come in contact with solder or components located inside the enclosure of this product, wash your hands beforehandling food.1. Critical Components InformationComponents having special characteristics are marked sand must be replaced with parts having specifica
13、tions equalto those originally installed.2. Leakage Current Measurement (For 120V Models Only)When service has been completed, it is imperative to verifythat all exposed conductive surfaces are properly insulatedfrom supply circuits.GMeter impedance should be equivalent to 1500 ohms shuntedby 0.15F.
14、For U model“CAUTION”“F251, F252:FOR CONTINUED PROTECTION AGAINST RISK OF FIRE, REPLACE ONLY WITH SAMETYPE 10A, 125V FUSE.”For C modelCAUTIONF251, F252:REPLACE WITH SAME TYPE 10A, 125V FUSE.ATTENTIONF251, F252:UTILISER UN FUSIBLE DE RECHANGE DE MME TYPE DE 10A, 125V.GLeakage current must not exceed 0
15、.5mA.GBe sure to test for leakage with the AC plug in both polarities.本機搭載基板付接合部無鉛付。無鉛種類、修理時下記無鉛使用推奨。Sn+Ag+Cu (錫+銀+銅)Sn+Cu (錫+銅)Sn+Zn+Bi (錫+亜鉛+)注意:無鉛融点温度通常鉛入比3040程度高、合使用。All of the P.C.B.s installed in this unit and solder joints aresoldered using the lead free solder.Among some types of lead free s
16、older currently available,it is recommended to use one of the following types for therepair work. Sn + Ag + Cu (tin + silver + copper) Sn + Cu (tin + copper) Sn + Zn + Bi (tin + zinc + bismuth)Caution:As the melting point temperature of the lead free solder isabout 30C to 40C (50F to 70F) higher tha
17、n that of the leadsolder, be sure to use a soldering iron suitable to each solder.About lead free solder / 無鉛I TO SERVICE PERSONNELRadioFans.CN 收音机爱 好者资料库RX-V861/HTR-6080/DSP-AX861SE/DSP-AX8613RX-V861/HTR-6080/DSP-AX861SE/DSP-AX861I FRONT PANELSRX-V861 (U, C models)HTR-6080 (U, C models)RX-V861 (R,
18、T, K, A, G, E, L models)RX-V861/HTR-6080/DSP-AX861SE/DSP-AX8614RX-V861/HTR-6080/DSP-AX861SE/DSP-AX861HTR-6080 (G model)DSP-AX861SE (B model)DSP-AX861 (J model)RX-V861/HTR-6080/DSP-AX861SE/DSP-AX8615RX-V861/HTR-6080/DSP-AX861SE/DSP-AX861I REAR PANELSRX-V861 (U, C models)RX-V861 (R model)RX-V861 (T mo
19、del)RX-V861/HTR-6080/DSP-AX861SE/DSP-AX8616RX-V861/HTR-6080/DSP-AX861SE/DSP-AX861RX-V861 (K model)RX-V861 (A model)RX-V861 (G, E models)RX-V861/HTR-6080/DSP-AX861SE/DSP-AX8617RX-V861/HTR-6080/DSP-AX861SE/DSP-AX861RX-V861 (L model)HTR-6080 (U, C models)HTR-6080 (G model)RX-V861/HTR-6080/DSP-AX861SE/D
20、SP-AX8618RX-V861/HTR-6080/DSP-AX861SE/DSP-AX861DSP-AX861SE (B model)DSP-AX861 (J model)RX-V861/HTR-6080/DSP-AX861SE/DSP-AX8619RX-V861/HTR-6080/DSP-AX861SE/DSP-AX861I REMOTE CONTROL PANELSRAV326RX-V861 (U, C models)HTR-6080 (U, C models)RAV364RX-V861 (K, G, E models)HTR-6080 (G model)DSP-AX861SE (B m
21、odel)RAV327RX-V861 (R, T, A, L models)DSP-AX861 (J model)RX-V861/HTR-6080/DSP-AX861SE/DSP-AX86110RX-V861/HTR-6080/DSP-AX861SE/DSP-AX861I SPECIFICATIONS / 参考仕様I Audio Section / 部Minimum RMS Output Power (Power Amp. Section) /定格出力 (部)RX-V861/DSP-AX861SE/DSP-AX861 (20 Hz to 20 kHz)U, C, R, T, K, A, B,
22、G, E, L models (0.06 % THD, 8 ohms)J model (0.09 % THD, 6 ohms)FRONT L/R. 105 W + 105 WCENTER . 105 WSURROUND L/R . 105 W + 105 WSURROUND BACK L/R .105 W + 105 WHTR-6080 (1 kHz, 0.7 % THD, 8 ohms)FRONT L/R. 120 W + 120 WCENTER . 120 WSURROUND L/R . 120 W + 120 WSURROUND BACK L/R .120 W + 120 WMaximu
23、m Power / 実用最大出力 (JEITA, 1 kHz, 10 % THD)FRONT L/RR, T, K, L models (8 ohms). 145 W + 145 WJ model (6 ohms) . 145 W + 145 WCENTERR, T, K, L models (8 ohms). 145 WJ model (6 ohms) . 145 WSURROUND L/RR, T, K, L models (8 ohms). 145 W + 145 WJ model (6 ohms) . 145 W + 145 WSURROUND BACK L/RR, T, K, L m
24、odels (8 ohms). 145 W + 145 WJ model (6 ohms) . 145 W + 145 WMax. Power Per Channel / Max.(SP impedance set: 8 ohms minimum, 1 kHz, 0.7 % THD, 4 ohms)B, G, E, L modelsFRONT L/R . 155 W + 155 WCENTER. 155 WSURROUND L/R . 155 W + 155 WSURROUND BACK L/R .155 W + 155 WIEC Power / IEC (1 kHz, 0.06 % THD,
25、 8 ohms)B, G, E, L modelsFRONT L/R . 115 W + 115 WDynamic Power Per Channel / (IHF)FRONT L/RU, C, R, T, K, A, B, G, E, L models(8/6/4/2 ohms) . 140/175/205/250 WJ model (6/4/2 ohms) . 145/175/220 WDynamic Headroom / U, C models (8 ohms). 1.25 dBDamping Factor / FRONT L/R (20 Hz to 20 kHz, SPEAKER-A,
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- Yamaha-RXV861-avr-sm1 维修电路原理图 Yamaha RXV861 avr sm 维修 电路 原理图