Yamaha-DM2000E-mix-sm 维修电路原理图.pdf
《Yamaha-DM2000E-mix-sm 维修电路原理图.pdf》由会员分享,可在线阅读,更多相关《Yamaha-DM2000E-mix-sm 维修电路原理图.pdf(405页珍藏版)》请在收音机爱好者资料库上搜索。
1、DM20001SERVICE MANUALPA0116241.302K-9377 Printed in Japan 02.03HAMAMATSU, JAPAN CONTENTSSPECIFICATIONS. 4DIMENSIONS. 19PANEL LAYOUT. 20CIRCUIT BOARD LAYOUT. 36DISASSEMBLY PROCEDURE. 41INSTALLING I/O CARDS. 58LSI PIN DESCRIPTION. 59IC BLOCK DIAGRAM. 69CIRCUIT BOARDS. 77INSPECTIONS.142/150SERVICE CHEC
2、K PROGRAM.159/170TEST PROGRAM.181/182USING BULK DUMP. 183SAVING DM2000 DATA TO SMARTMEDIA. 184CHECKING THE BATTERY. 187INITIALIZING THE DM2000. 187MIDI DATA FORMAT. 188MIDI IMPLEMENTATION CHART. 204PARTS LISTBLOCK DIAGRAMOVERALL CONNECTOR CIRCUIT DIAGRAMOVERALL CIRCUIT DIAGRAMThis document is printe
3、d on chlorine free (ECF) paper with soy ink.DIGITAL PRODUCTION CONSOLE/PEAK METER BRIDGE/WOODEN SIDE PANELS/MB2000/SP2000RadioFans.CN 收音机爱 好者资料库DM20002IMPORTANT NOTICEThis manual has been provided for the use of authorized Yamaha Retailers and their service personnel. It has been assumedthat basic s
4、ervice procedures inherent to the industry, and more specifically Yamaha Products, are already known and under-stood by the users, and have therefore not been restated.WARNING :Failure to follow appropriate service and safety procedures when servicing this product may result in per-sonal injury, des
5、truction of expensive components and failure of the product to perform as specified. Forthese reasons, we advise all Yamaha product owners that all service required should be performed by anauthorized Yamaha Retailer or the appointed service representative.IMPORTANT :This presentation or sale of thi
6、s manual to any individual or firm does not constitute authorization certifi-cation, recognition of any applicable technical capabilities, or establish a principal-agent relationship ofany form.The data provided is belived to be accurate and applicable to the unit(s) indicated on the cover. The rese
7、arch engineering, andservice departments of Yamaha are continually striving to improve Yamaha products. Modifications are, therefore, inevitableand changes in specification are subject to change without notice or obligation to retrofit. Should any discrepancy appear toexist, please contact the distr
8、ibutors Service Division.WARNING :Static discharges can destroy expensive components. Discharge any static electricity your body may haveaccumulated by grounding yourself to the ground bus in the unit (heavy gauge black wires connect tothis bus.)IMPORTANT :Turn the unit OFF during disassembly and pa
9、rts replacement. Recheck all work before you apply powerto the unit.WARNING: CHEMICAL CONTENT NOTICE!The solder used in the production of this product contains LEAD. In addition, other electrical/electronic and/or plastic (Whereapplicable) components may also contain traces of chemicals found by the
10、 California Health and Welfare Agency (and possiblyother entities) to cause cancer and/or birth defects or other reproductive harm.DO NOT PLACE SOLDER, ELECTRICAL/ELECTRONIC OR PLASTIC COMPONENTS IN YOUR MOUTH FOR ANY REASON WHATSO EVER!Avoid prolonged, unprotected contact between solder and your sk
11、in! When soldering, do not inhale solder fumes or exposeeyes to solder/flux vapor!If you come in contact with solder or components located inside the enclosure of this product, wash your hands before handlingfood.WARNINGComponents having special characteristics are marked and must be replaced with p
12、arts having specification equal to thoseoriginally installed.WARNING: THIS APPARATUS MUST BE EARTHEDIMPORTANTTHE WIRES IN THIS MAINS LEAD ARE COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE: GREEN-AND-YELLOW : EARTH BLUE : NEUTRAL BROWN : LIVEAs the colours of the wires in the mains lead of this appa
13、ratus may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:The wire which is coloured GREEN and YELLOW must be connected to the terminal in the plug which is marked by the letter E or by the safety earth symbol or coloured GREEN and YELLOW.The wire
14、 which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK.The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured RED.* This applies only to products distributed by YAMAHA KEMBLE MUSIC (U.K.)
15、 LTD.RadioFans.CN 收音机爱 好者资料库DM20003LITHIUM BATTERY HANDLINGThis product uses a lithium battery for memory back-up.WARNING :Lithium batteries are dangerous because they can be exploded by improper handling. Observe the following pre-cautions when handling or replacing lithium batteries.Leave lithium
16、battery replacement to qualified service personnel.Always replace with batteries of the same type.When installing on the PC board by soldering, solder using the connection terminals provided on the battery cells.Never solder directly to the cells. Perform the soldering as quickly as possible.Never r
17、everse the battery polarities when installing.Do not short the batteries.Do not attempt to recharge these batteries.Do not disasemble the batteries.Never heat batteries or throw them into fire.ADVARSEL!Lithiumbatteri-Eksplosionsfare ved fejlagtig handtering. Udskiftning ma kun ske med batteri af sam
18、me fabrikat og type. lever det brugtebatteri tilbage til leverandren.VARNINGExplosionsfara vid felaktigt batteribyte.Anvand samma batterityp eller en ekvivalent typ som rekommenderas av apparattillverkaren.Kassera anvant batteri enligt fabrikantens instruktion.VAROITUSParisto voi rajahtaa, jos se on
19、 virheellisesti asennettu.Vaihda paristo ainoastaan laitevalmistajan suosittelemaan tyyppiiin.Havita kaytetty paristo valmistajan ohjeiden mukaisesti.The following information complies with Dutch official Gazette 1995. 45; ESSENTIALS OF ORDER ON THE COLLECTION OF BATTERIES. Please refer to the diass
20、embly procedure for the removal of Back-up Battery. Leest u voor het verwijderen van de backup batterij deze beschrijving.Take care not to trap your fingers.DM20004SPECIFICATIONSNumber of scene memories99Sampling FrequencyInternal44.1 kHz, 48 kHz, 88.2 kHz, 96 kHzExternalNormal rate: 44.1 kHz10% to
21、48 kHz+6%Double rate: 88.2 kHz10% to 96 kHz+6%Signal DelayLess than 2.3 ms CH INPUT to STEREO OUT (fs=48 kHz)Less than 1.2 ms CH INPUT to STEREO OUT (fs=96 kHz)Fader100 mm motorized with touch sense X 25Fader Resolution+10 to 96, dB (256 steps/100 mm) input faders0 to 130, dB (256 steps/100 mm) mast
22、er faders, stereo faderTotal Harmonic Distortion*1(CH INPUT to STEREO OUT)(Input Gain=Min.)fs=48 kHzLess than 0.05% 20 Hz to 20 kHz +14 dB into 600 Less than 0.01% 1 kHz +18 dB into 600 (fs=48 kHz)fs=96 kHzLess than 0.05% 20 Hz to 40 kHz +14 dB into 600 Less than 0.01% 1 kHz +18 dB into 600 Frequenc
23、y Response(CH INPUT to STEREO OUT) 20 Hz20 kHz, 0.5, 1.5 dB +4 dB into 600 (fs=48 kHz) 20 Hz40 kHz, 0.5, 1.5 dB +4 dB into 600 (fs=96 kHz)Dynamic Range (maximum level to noise level)110 dB typ. DA Converter (STEREO OUT)108 dB typ. AD+DA (to STEREO OUT) fs=48 kHz106 dB typ. AD+DA (to STEREO OUT) fs=9
24、6 kHzHum & Noise*2(20 Hz20 kHz)Rs=150 Input Gain=Max.Input Pad =0 dB128 dB Equivalent Input Noise92 dB residual output noise. STEREO OUT (STEREO OUT off)92 dB (96 dB S/N) STEREO OUT (STEREO fader at nominal level and all CH INPUT faders at minimum level)64 dB (68 dB S/N) STEREO OUTPUT (STEREO fader
25、at nominal level and one CH INPUT fader at nominal level)Maximum Voltage Gain74 dB CH INPUT (CH124) to STEREO OUT/OMNI (BUS) OUT74 dB CH INPUT (CH124) to OMNI (AUX) OUT (via pre input fader)74 dB CH INPUT (CH124) to CONTROL ROOM MONITOR OUT (via STEREO bus)Crosstalk ( 1 kHz)Input Gain=Min.80 dB adja
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- Yamaha-DM2000E-mix-sm 维修电路原理图 Yamaha DM2000E mix sm 维修 电路 原理图