sony_icf-703l_sm 电路图 维修原理图.pdf
《sony_icf-703l_sm 电路图 维修原理图.pdf》由会员分享,可在线阅读,更多相关《sony_icf-703l_sm 电路图 维修原理图.pdf(12页珍藏版)》请在收音机爱好者资料库上搜索。
1、 1 SERVICE MANUALAEP Model ICF-703/703L UK Model ICF-703L ICF-703/703L FM/AM RADIO ICF-703 FM/MW/LW 3 BAND RADIO ICF-703L (Photo: ICF-703L (BLACK) SPECIFICATIONS Frequency range: Italy BandICF-703ICF-703L FM87.5 - 108.0 MHz AM526.5 - 1606.5 kHz Other countries BandICF-703ICF-703L FM87.5 - 108.0 MHz8
2、7.5 - 108.0 MHz SW AM (MW)530 - 1605 kHz530 - 1605 kHz LW 153 - 255 kHz Speaker Approx. 10.2 cm (4 1/8 inches) dia. 8 ohms Power output 430 mW (at 10 % harmonic distortion) Output v jack ( 3.5 mm minijack) Power requirements With the supplied AC power cord: 220 - 230 V AC, 50 Hz With four R6 (size A
3、A) batteries: 6V DC Dimensions Approx. 265 137 69 mm (w/h/d) (10 1/2 5 1/2 2 3/4 inches) incl. projecting parts and control with carrying handle pushed in. Mass Approx. 1019 g (2 lb 4 oz) incl. batteries Supplied accessory AC power cord (1) Design and specifications are subject to change without not
4、ice. Ver 1.0 2000. 03 RadioFans.CN 2 mark Center Frequency red10.70 MHz blue10.67 MHz orange10.73 MHz black10.64 MHz white10.76 MHz white/white10.75 MHz yellow10.79 MHz HOW TO CHANGE THE CERAMIC FILTERS This model is used two ceramic filters of CF2, CF3 and CF4. You must use same type of color marke
5、d ceramic filters in order to meet same specifications. Therefore, the ceramic filter must change two pieces together since its supply two pieces in one package as a spare parts. markmark white/white only CF2 CF3 CF4 markmark CF3 CF2 CF4 Notes on Chip Component Replacement Never reuse a disconnected
6、 chip component. Notice that the minus side of a tantalum capacitor may be damaged by heat. SAFETY-RELATED COMPONENT WARNING! COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE WITH MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN THE PARTS LIST ARE CRITICAL TO SAFE OPERATION. REPLACE THESE COMPONENTS WITH SONY
7、PARTS WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS PUBLISHED BY SONY. RadioFans.CN 3 SECTION 1 GENERALThis section is extracted from instruction manual. A B C OPERATION ($ON/4STANDBY) Insert the # side of the battery first. Insrez le ct # de la pile en premier. Batterie mit de
8、r # Seite zuerst einlegen. Inserte en primer lugar el lado # de las pilas Inserire prima il lato # della pila. R6 (size AA) battery x 4 pile R6 (format AA) x 4 Mignonzelle (R6/AA) x 4 pila R6 (tomao AA) x 4 pila R6 (formato AA) x 4 ICF-703 ICF-703S ICF-703L Choosing Power Sources Batteries (See Fig.
9、 A) 1Open the lid of the battery case. Slide fully in the direction of the arrow (B) on the lid and lift it. Do not force to open it. Doing so may damage the unit. 2Insert four R6 (sizeAA) batteries (not supplied) with correct polarity. 3Close the lid. Battery life Using Sony LR6(size AA) alkaline b
10、atteries: Approx. 100 hours Using Sony R6 (size AA) batteries: Approx. 35 hours Replacing batteries When the sound becomes weak or distorted, replace all the batteries with new ones. Notes on batteries Insert the batteries with correct polarity. Do not charge the dry batteries. Do not use different
11、types of batteries at the same time. When you replace the batteries, replace all with new ones. When the unit is not being used for a long period of time, remove the batteries to avoid damage from battery leakage and corrosion. If a battery leakage occurs, wipe the battery compartment with a soft cl
12、oth before inserting new ones. House Current (See Fig. B) 1Connect the AC power cord supplied to the AC IN jack of the radio. 2Plug into a wall outlet. Operating the Radio 1Press OPERATION ($) to turn on the radio. 2Select a desired band, and tune in a station using TUNING. TUNE (tuning) indicator l
13、ights up when a station is tuned in. 3Adjust the volume using VOL. 4Adjust the tone to your preference using TONE. To obtain clear treble, turn to “HIGH”. To reinforce bass, set to “LOW”. To turn off the radio, press OPERATION (4). To listen with an earphone connect the earphone to the v (earphone)
14、jack. The spearker is deactivated when an earphone is connected. To improve Receiving condition (See Fig. C) FM: Extend the telescopic antenna and adjust the length and angle for the best reception. SW: Extend the telescopic antenna vertically. AM(MW)/LW : Since the reception is affected by the dire
15、ction of the radio, rotate the unit horizontally for optimum reception. Telescopic antenna Antenne tlescopique Teleskopantenne Antena telescpica Antenna telescopica TUNE indicator Indicateur TUNE TUNE-Anzeige Indicador de sintonia (TUNE) Indicatore TUNE AC power cord (supplied) Cordon dalimentation
16、secteur Netzkabel (mitgeliefert) Cable de alimentacin de CA (suministrado) Cavo di alimentazione CA in dotazione Carrying handle Poign de transport Tragegriff Asa de transporte Maniglia di trasporto v jack Prise v v-Buchse Toma v Presa v AM (MW)/LW AM (PO)/GO FM UKW SW OC KW AC IN 1 2 3 4 RadioFans.
17、CN 4 Note : Follow the disassembly procedure in the numerical order given. 2-1. CABINET (REAR) 2-2. POWER BOARD SECTION 2 DISASSEMBLY 1 lid, battery case 2 BTP 3x16 3 BTP 3x16 4 BTP 3x16 5 cabinet (rear) 1 BTP 3x10 5 button (power) 4 Removal the solders. CN401 BLU BLK PNK 6 POWER board 3 CN401 2 Rad
18、ioFans.CN 5 2-3. MAIN BOARD, LED BOARD 2-4. SETTING THE POINTER 1 knob (control) 8 BTP 3x10 9 BTP 3x10 7 claws qa MAIN board 5 BTP 2.6x5 6 LED board 2 knob (band) 3 chassis 0 4 Removal the solder. 1 rack (pointer) rack (pointer) 2 pointer Setting the Pointer A 1. Turn the Knob (Tuning) in the direct
19、ion of A until it is stopped. 2.Place the rack as shown in the figure. 3.Mount the pointer. RadioFans.CN 6 Put the lead-wire antenna close to the set. AM RF signal generator 400Hz, 30% AM modulation Output level: as low as possible Repeat the procedures in each adjustment several times, and the freq
20、uency coverage and tracking adjustments should be finally done by the trimmer capacitors. ICF-703: FM FREQUENCY COVERAGE ADJUSTMENT Adjust for a maximum reading on level meter L486.5 (87.35) MHz CT1-3109.5 (108.25) MHz FM TRACKING ADJUSTMENT Adjust for a maximum reading on level meter L6, L786.5 (87
21、.35) MHz CT1-4109.5 (108.25) MHz NOTE : ( ) : Italian model ICF-703L: FM FREQUENCY COVERAGE ADJUSTMENT Adjust for a maximum reading on level meter L486.5 MHz CT1-3109.5 MHz FM TRACKING ADJUSTMENT Adjust for a maximum reading on level meter L6, L786.5 MHz CT1-4109.5 MHz SECTION 3 ELECTRICAL ADJUSTMEN
22、TS FM SECTION BAND switch : FM telescopic antenna terminal 0.01F FM RF signal generator 400Hz, 30% FM modulation frequency deviation 22.5kHz Output level: as low as possible set 16 set earphone jack (EPJ1) level meter Repeat the procedures in each adjustment several times, and the frequency coverage
23、 and tracking adjustments should be finally done by the trimmer capacitors. AM/MW FREQUENCY COVERAGE ADJUSTMENT Adjust for a maximum reading on level meter L5520 (516.5) kHz CT1-21,650 (1,631.5) kHz AM/MW TRACKING ADJUSTMENT Adjust for a maximum reading on level meter L1-1600 (620) kHz CT1-11,400 kH
24、z NOTE : ( ) : Italian model AM/MW IF ADJUSTMENT Adjust for a maximum reading on level meter T1 455 kHz AM (703)/MW (703L) SECTION BAND switch : AM 16 set earphone jack (EPJ1) level meter RadioFans.CN Put the lead-wire antenna close to the set. AM RF signal generator 400Hz, 30% AM modulation Output
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- sony_icf-703l_sm 电路图 维修原理图 sony_icf 703 l_sm 维修 原理图