Onkyo-DRS2.2-rec-sm维修电路原理图.pdf
《Onkyo-DRS2.2-rec-sm维修电路原理图.pdf》由会员分享,可在线阅读,更多相关《Onkyo-DRS2.2-rec-sm维修电路原理图.pdf(88页珍藏版)》请在收音机爱好者资料库上搜索。
1、DR-S2.2 SERVICE MANUALSERVICE MANUAL DVD RECEIVER Titanium color model MODELDR-S2.2 120V AC, 60Hz 220-230V AC, 50/60Hz 230-240V AC, 50/60Hz UDD1N, UDT3P, UDS4P UGK3P, UGR6P UPP2P, UPA4P Ref. No. 3721 42002 RC-484M SAFETY-RELATED COMPONENT WARNING! COMPONENTS IDENTIFIED BY MARK ON THE SCHEMATIC DIAGR
2、AM AND IN THE PARTS LIST ARE CRITICAL FOR RISK OF FIRE AND ELECTRIC SHOCK. REPLACE THESE COMPONENTS WITH ONKYO PARTS WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL. MAKE LEAKAGE-CURRENT OR RESISTANCE MEASUREMENTS TO DETERMINE THAT EXPOSED PARTS ARE ACCEPTABLY INSULATED FROM THE SUPPLY CIRCUIT BEF
3、ORE RETURNING THE APPLIANCE TO THE CUSTOMER. Page 1 RadioFans.CN 收音机爱 好者资料库 DR-S2.2 SPECIFICATIONS AMPLIFIER SECTION (FTC)All channels 40 watts per channel min. RMS. into 6 ohms two channel driven, 1,000 Hz with no more than 5 % total harmonic distortion. Continuous power output (DIN) All channels 3
4、0 watts per channel min. RMS. into 6 ohms two channel driven, 1,000 Hz Continuous Power output (EIAJ) All channel 45 watts per channel min. RMS. into 6 ohms two channel driven, 1,000 Hz Dynamic Power6 ohms: 42 W (L/R) 8 ohms: 35 W (L/R) Total Harmonic Distortion5 % at rated power 0.2 % at 1 watt out
5、put IM Distortion5 % at rated power 0.2 % at 1 watt output Damping Factor40 at 8 ohms Input Sensitivity and Impedance VIDEO 1 DIGITAL INPUT (OPT)21 to 15 dBm VIDEO 2 DIGITAL INPUT (COAX)0.5 Vp-p, 75 ohms TUNER SECTION Tuning RangeFM:87.50 to 108.00 MHz (50 kHz steps) AM: (North American and South Am
6、erican models) 530 to 1710 kHz (10 kHz steps) Usable SensitivityFM:Mono11.2 dBf,1.0 V (75 ohms IHF) 0.9 V (75 ohms DIN) Stereo17.2 dBf,2.0 V (75 ohms IHF) 23 V (75 ohms DIN) AM: 30 V 50 dB Quieting SensitivityFM:Mono17.2 dBf,2.0 V (75 ohms) Stereo37.2 dBf,20.0 V (75 ohms) Capture RatioFM:2.0 dB Imag
7、e Rejection RatioFM:(North American and South American models) 40 dB AM: 40 dB DVD SECTION Signal readout systemOptical non-contact Linear velocity3.49 m/s (Single Layer) 3.84 m/s (Dual Layer) Error correction systemReed Solomon Product Code Signal systemNorth American model: NTSC Other models: PAL/
8、Auto Regional restriction codeUSA and Canadian area: 1 European area: 2 South-east Asian area: 3 Australian and South American area: 4 PRC: 6 LaserSemiconductor laser , wavelength DVD 650 nm CD 780nm Frequency response10 Hz to 44 kHz (96 kHz) Signal-to-noise ratio (digital audio)More than 100 dB Aud
9、io dynamic range (digital audio)More than 93 dB Harmonic distortion (digital audio)Less than 0.025% Wow and flutterBelow threshold of measurability Operating conditionsTemperature: 5 C to 35 C (41 F to 95 F), Operation status: Horizontal GENERAL Power Supply Rating (North American and South American
10、 models) and Power ConsumptionAC 120 V, 60Hz (Other models) AC 120V, 60Hz170 W AC 230-240 V, 50Hz170 W Specifications and features are subject to change without notice. LINE (VIDEO 1, VIDEO 2/CDR/PC, TV/LINE, TAPE/MD/HD) 200 mV/50 kohms Composite (VIDEO 1, VIDEO 2/CDR/PC)1 Vp-p, 75 ohms S-VIDEO (VID
11、EO 1, VIDEO 2/CDR/PC)Y: 1 Vp-p, 75 ohms C: 0.28 Vp-p, 75 ohms Output Level and Impedance DIGITAL OUTPUT (OPT)21 to 15 dBm REC OUT (TAPE/MD/HD, VIDEO 2/CDR/PC)200 mV, 2.2 kohms PRE OUT (SUBWOOFER)1 V, 470 ohms Composite (MON OUT , VIDEO 1)1 Vp-p, 75 ohms S-VIDEO (MON OUT , VIDEO 1)Y: 1 Vp-p, 75 ohms
12、C: 0.28 Vp-p, 75 ohms COMPONENT VIDEO OUTPUT Y: 1.0 Vp-p, 75 ohms (Except European model)PB/PR: 0.7 Vp-p, 75 ohms RGB (European model)0.7 Vp-p, 75 ohms Frequency Response20 to 30,000 Hz : +/ 0.8 dB Acoustic Control1: +9 dB at 120 Hz 2: +9 dB at 120 Hz +6 dB at 10,000 Hz Signal-to-noise Ratio100 dB (
13、0.5 V INPUT LINE) Muting50 dB Dimensions (W x H x D) Weight8.8 kg (19.4 lb.) (Other models) 522 to 1611 kHz (9 kHz steps) (Other models) 85 dB IF Rejection RatioFM:90 dB AM: 40 dB Signal-to-noise RatioFM:Mono73 dB, IHF Stereo67 dB, IHF AM: 40 dB Alternate Channel Att. (+/ 400 kHz)FM:Mono55 dB, IHF S
14、electivityFM:50 dB, DIN 55dB, IHF AM Suppression RatioFM:50 dB Harmonic DistortionFM: Mono0.2 % Stereo0.3 % AM:0.7 % Frequency responseFM: 30 to 15,000 Hz (+/ 1.0 dB) Stereo SeparationFM: 45 dB at 1,000 Hz 30 dB at 100 to 10,000 Hz Stereo ThresholdFM: 17.2 dBf, 20 V (75 ohms) Power Output 435 x 101
15、x 428 mm (17 1/8 x 4 x 16 13/16ins.) 2.0 A Page 2 RadioFans.CN 收音机爱 好者资料库 DR-S2.2 SERVICE PROCEDURES-1 PROTECTION OF EYES FROM LASER BEAM DURING SERVICING This set employs two lasers. Therefore, be sure to follow carefully the instructions below when servicing. WARNING! SERVICE WARNING : DO NOT APPR
16、OACH THE LASER EXIT WITH THE EYE TOO CLOSELY. IN CASE IT IS NECESSARY TO CONFIRM LASER BEAM EMISSION, BE SURE TO OBSERVE FROM A DISTANCE OF MORE THAN 30cm FROM THE SURFACE OF THE OBJECTIVE LENS ON THE OPTICAL PICKUP BLOCK. Laser Diode Properties 780 nm 0.43 mW LASER WARNING Wavelength: Laser output:
17、 650 nm 0.6 mW Wavelength: Laser output: CD DVD WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVIC
18、E PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated dangerous voltage within the products enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation
19、point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. WARNING RISK OF ELECTRIC SHOCK DO NOT OPEN RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR AVIS WARNING This unit c
20、ontains a semiconductor laser system and is classified as a CLASS 1 LASER PRODUCT . So, to use this model properly , read this Instruction Manual carefully. In case of any trouble, please contact the store where you purchased the unit. To prevent being exposed to the laser beam, do not try to open t
21、he enclosure. VISIBLE LASER RADIATION WHEN OPEN AND INTERLOCK FAILED OR DEFEATED. DO NOT STARE INTO BEAM. THIS PRODUCT UTILIZES TWO LASERS. USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. The label on the right
22、 is applied on the rear panel except for USA and Canadian models. 1.This unit is a CLASS 1 LASER PRODUCT and employs two lasers inside the cabinet. 2.To prevent the laser from being exposed, do not remove the cover . Refer servicing to qualified personnel. CLASS 1 LASER PRODUCT CAUTION: CAUTION: LAS
23、ER BEAM CAUTION LABEL Page 3 DR-S2.2 SERVICE PROCEDURES-2 FL display cl ear The memory of unit is initialized. (The shipment state of the product) SERVICE PROCEDURE 1. Replacing the fuses This symbol located near the fuse indicates that the fuse used is show operating type, For continued protection
24、against fire hazard, replace with same type fuse , For fuse rating, refer to the marking adjest to the symbol. Ce symbole indique que le fusible utilise est e lent. Pour une protection permanente, nutiliser que des fusibles de meme type. Ce demier est indique la qu le present symbol est apposre. 2.
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- Onkyo DRS2 rec sm 维修 电路 原理图