Denon-AVR1603-avr-sm维修电路原理图.pdf
《Denon-AVR1603-avr-sm维修电路原理图.pdf》由会员分享,可在线阅读,更多相关《Denon-AVR1603-avr-sm维修电路原理图.pdf(101页珍藏版)》请在收音机爱好者资料库上搜索。
1、Hi-Fi Component SERVICE MANUAL MODEL AVR-1603/683 AV SURROUND RECEIVER X0152 NC 0209 For U.S.A., Canada, Europe, U.K., Australia, Asia, China, Hong Kong, Taiwan R.O.C. & Korea model ?Some illustrations using in this service manual are slightly different from the actual set. 16-11, YUSHIMA 3-CHOME, B
2、UNKYOU-KU, TOKYO 113-0034 JAPAN Telephone: 03 (3837) 5321 RadioFans.CN 收音机爱 好者资料库 2 AVR-1603/683 SPECIFICATIONS SAFETY PRECAUTIONS The following check should be performed for the continued protection of the customer and service technician. LEAKAGE CURRENT CHECK Before returning the unit to the custo
3、mer, make sure you make either (1) a leakage current check or (2) a line to chassis resistance check. If the leakage current exceeds 0.5 milliamps, or if the resistance from chassis to either side of the power cord is less than 460 kohms, the unit is defective. ? Audio Section Power Amplifier Rated
4、output:Front:80W+80W(8/ohms, 20Hz20kHz with 0.08% T.H.D ) (U.S.A., & Canada Models) 70W+70W(8/ohms, 20Hz20kHz with 0.08% T.H.D ) (Europe, U.K., Australia & Asia) 110W+110W(6/ohms, 1kHz with 0.7% T.H.D ) (U.S.A., & Canada Models) 100W+100W(6/ohms, 1kHz with 0.7% T.H.D ) (Europe, U.K. & Australia Mode
5、ls) 110W+110W(6/ohms, EIAJ ) (Asia Model) Center:80W(8/ohms, 20Hz20kHz with 0.08% T.H.D ) (U.S.A., & Canada Models) 70W(8/ohms, 20Hz20kHz with 0.08% T.H.D ) (Europe, U.K. & Australia & Asia) 110W(6/ohms, 1kHz with 0.7% T.H.D ) (U.S.A., & Canada Models) 100W(6/ohms, 1kHz with 0.7% T.H.D ) (Europe, U.
6、K. & Australia Models) 110W(6/ohms, EIAJ ) (Asia Model) Surround: 80W+80W(8/ohms, 20Hz20kHz with 0.08% T.H.D ) (U.S.A., & Canada Models) 70W+70W(8/ohms, 20Hz20kHz with 0.08% T.H.D ) (Europe, U.K. & Australia & Asia) 110W+110W(6/ohms, 1kHz with 0.7% T.H.D ) (U.S.A., & Canada Models) 100W+100W(6/ohms,
7、 1kHz with 0.7% T.H.D ) (Europe, U.K. & Australia Models) 110W+110W(6/ohms, EIAJ ) (Asia Model) Output terminals:Front:A or B6 to 16/ohms A+B12 to 16/ohms Center/Surround:6 to 16/ohms LINE input - SPEAKER OUT Input sensitivity/input impedance:200mV/47k/kohms Frequency response:10Hz100kHz: +1, 3dB(TO
8、NE DEFEAT ON) S/N ratio:98dB (IHF-A weighted)(TONE DEFEAT ON) ? Video Section Standard video jacks Input/output level and impedance:1Vp-p,75/ohms Frequency response:5Hz10MHz +1, 3dB S-video jacks Input/output level and impedance:Y(brightness)signal 1Vp-p, 75/ohms C(color)signal 0.286Vp-p, 75/ohms Fr
9、equency response:5Hz10MHz: +1, 3dB Color component video jacks (U.S.A. & Canada Models) Input/output level and impedance:Y(brightness)signal 1Vp-p, 75/ohms PB/CB(blue)signal 0.7Vp-p, 75/ohms PR/CR(red)signal 0.7Vp-p, 75/ohms Frequency response:5Hz27MHz: +0, 3dB ? Tuner section Receiving range:FM (no
10、te: V at 75/ohms, 0dBf =110-15W)AM U.S.A., & Canada Models:87.50MHz107.90MHz520kHz1710kHz Europe U.K. & Australia Models:87.50MHz108.00MHz522kHz1611kHz Asia Model:87.50MHz107.90MHz (0.2MHz steps)520kHz1710kHz (10kHz steps) 87.50MHz108.00MHz (0.05MHz steps)522kHz1611kHz (9kHz steps) Usable sensitivit
11、y:1.0V (11.2dBf)18V 50 dB quieting sensitivity:MONO1.6V (15.3dBf) STEREO23V (38.5dBf) S/N ratio:MONO80dB (IHF-A weighted) STEREO75dB (IHF-A weighted) Total harmonic distortion:MONO0.15% (1kHz) STEREO0.3% (1kHz) RadioFans.CN 收音机爱 好者资料库 3 AVR-1603/683 ? General Power supply:AC120V, 60Hz (U.S.A. & Cana
12、da Models) AC230V, 50Hz (Europe, U.K. & Australia Models) AC115/230V, 50/60Hz (Asia Model) Power consumption:4.0A (USA & Canada model) 210W (Europe, U.K., Australia & Asia models) Maximum external dimensions:434 (W) 147 (H) 417 (D) mm (17-3/32 5-25/32 1-23/64) Mass:10.4kg (22 lbs 14.9 oz) ? Remote c
13、ontrol unit (RC-920) Batteries:R6P/AA Type (two batteries) External dimensions:55 (W) 225 (H) 34.5 (D) mm (2-11/64 8-55/64 1-9/64) Mass:165g (Approx. 5.8 oz) (including batteries) * For purposes of improvement, specifications and design are subject to change without notice. 4 AVR-1603/683 DISASSEMBL
14、Y (Follow the procedure below in the reverse order when reassembling) 1. Top Cover Remove 6 screws 1 and 3 screws 2, then detach the Top Cover to the arrow direction. 1 2. Front Panel (1) Remove 4 screws 3 and 3 screws 4. (2) Disconnect 3 connectors and FFC coming from the Front Panel side. (3) Disc
15、onnect the connector coming from the Trans., and detach the Front Panel to the arrow direction. 1 2 Top Cover 3 4 Connector Connector FFC Front Panel 6 Rear Panel 6 6 6 5 (U.S.A. & Canada models) 6 3. Rear Panel (1) Take off the AC cord 5 . (2) Remove 32 screws 6 (36 pieces for U.S.A. & Canada model
16、s). (3) Detach the Rear Panel to the arrow direction. 4 4 LEVEL DIAGRAMS 87654321 A B C D E AVR-1603/683 5 FRONT/CENTER/SURROUND 87654321 A B C D E AVR-1603/683 6 SUB WOOFER BLOCK DIAGRAM 87654321 A B C D E AVR-1603/683 7 8 AVR-1603/683 ADJUSTMENT Tuner Section CONNECTION DIAGRAM OF MEASURING INSTRU
17、MENTS ? FM STEREO MODULATOR FM SSG Digital Voltmeter 75ohm T402T403 IC402 VR402 TUNER BD R471 20+14 10dB ? AM T402T403 IC402 TUNER BD R471 VR401 FM ALIGNMENT InputOutputAdjustment Step Alignment Item Tuning Frequency Setting TypeFrequency Input Level ModulationCouplingTypeConnect toPointsAdjust to 1
18、 Center Adjustment 98.1MHz (98.0MHz) FM SSG98.1MHz60dB Mono 1kHz 100% Antenna Terminal Digital Voltmeter R471T402 50mV 2Distortion 98.1MHz (98.0MHz) FM SSG98.1MHz60dB Mono 1kHz 100% Antenna Terminal Distortion Meter Output Terminal (L) T403 Minimum Distortion 3Repeat Steps 1 and 2 4Signal Level 98.1
19、MHz (98.0MHz) FM SSG98.1MHz20dBOFF Antenna Terminal Light “TUNED” on FL Display VR402 AM ALIGNMENT OutputAdjustment Step Alignment Item FrequencyInput TypeConnect toPointsAdjust to Remarks 1Signal Level 999 (1000) kHz AM SSGVR401 Light “TUNED” on FL Display SSG OUTPUT 74dB (EMF) 9 AVR-1603/683 Audio
20、 Section Idling Current Required measurement equipment : DC Voltmeter Preparation (1)Avoid direct blow from an air conditioner or an electric fan, and adjust the unit at normal room tempereture 15 C 30 C (59 F 86 F). (2)Presetting POWER (Power sourse switch)OFF SPEAKER (Speaker terminal)No load (Do
21、not connect speaker, dummy resistor, etc.) Adjustment (1)Remove top cover and set VR101, VR102, VR103, VR104, VR105 on Amp. Unit at full counterclockwise ( ) position. (2)Connect DC Voltmeter to test points (FRONT-Lch: TP104, FRONT-Rch: TP105, CENTER ch: TP103, SURROUND-Lch: TP101, SURROUND-Rch: TP1
22、02). (3)Connect power cord to AC Line, and turn power switch ON. (4)Presetting.MASTER VOLUME : - counterclockwise ( min.) MODE: 5CH STEREO FUNCTION: CD (5)Within 2 minutes after the power on, turn VR101 clockwise ( ) to adjust the TEST POINT voltage to 1.5 mV 0.5 mV DC. (6)After 10 minutes from the
23、preset above, turn VR101 to set the voltage to 2.5 mV 0.5 mV DC. (7)Adjust the Variable Resistors of other channels in the same way. 10 AVR-1603/683 SEMICONDUCTORS ? ? ? ? ? ICs CXP740096 (IC201) PH7 PH6 PH5 PH4 PH3 PH2 PH1 PH0 PK7/TO1 RST VSS XTAL EXTAL PK6/CS0 PK5/SI0 PK4/SO0 PK3/SCK0 PF7/AN11 PF6
24、/AN10 PF5/AN9 PC6 PC7 PA0 PA1 PA2 PA3 PA4 PA5 PA6 PA7 NC VDD VSS PK1/TX PK2/TEX PI1/RMC PI2/NMI PI3/TO0/ADJ PI4/INT1/CS1 PI5/SCK1 PC5 PC4 PC3 PC2 PC1 PC0 PB7/SI2 PB6/SO2 PB5/SCK2 PB4/TO2 PB3 PB2 PB1 PB0 PJ7 PJ6 PJ5 PJ4 PJ3 PJ2 PJ1 PJ0 PD7 PD6 PD5 PD4 PD3 PD2 PD1 PD0 PI6/SO1 PI7/SI1 PE0/INT0 PE1/INT2
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- Denon AVR1603 avr sm 维修 电路 原理图