Classe-CDP1.5-cd-sm维修电路原理图.pdf

《Classe-CDP1.5-cd-sm维修电路原理图.pdf》由会员分享，可在线阅读，更多相关《Classe-CDP1.5-cd-sm维修电路原理图.pdf（9页珍藏版）》请在收音机爱好者资料库上搜索。

1、RadioFans.CN 收音机爱 好者资料库 RadioFans.CN 收音机爱 好者资料库 Procedure for CDP- 1.5 Parts: 1. Chassis (includes) a) rubber base or feet b) 1 RCA jack red and 2 RCA jack white. c) Mechanism brass stand off. 2. Supply, output board with A.C receptacle socket and Neutrik socket. 3. Display board with 6 pin connecto

2、r. 4. Servo board with 6 pin connector. 5. CDP 1.5 mechanism kit. 6. Wires:(descriptions connections) a) 4 pin terminal (both end) 18” wire from output board CN111 to servo CN111 b) 5 pin terminal (both end) 13” wire output board J102 to servo CN101 c) 4 pin terminal (both end) 9” wire output board

3、J302 to display J201 d) 2” wire chassis ground to ac term. e) 8 pin terminal (both side) 12” wire display J203 to servo CN110 f) 10 pin terminal (both side) 12” wire display J204 to servo CN108 g) 14” black & orange connected servo JK101 to RCA jack terminal COAXIAL output (black for chassis grd) (o

4、range for RCA jack) + bass wire * from servo 6 pin to output J301 7. Cover Procedures of assembly: Chassis preparation: Same as the CDP.3 Step 1: A) Supply & output Board, install by using silver socket drive crew w/lock washer, but before fixing be sure that the wires are properly installed to thei

5、r respective terminals, as per instructed B) The wires connection & description (see part 6) ac receptacle & Neutrik socket are properly fixed to the hole & using the black socket drive screw. Then put the bass wire from output board J501A & J601A to the RCA jack RED & RCA jack WHITE. Bass wire GREE

6、N from J501B & J601B to gold contact connector. Step 2: a) Display board W/ the switch board after fixing supply, output board next is the display board, but first you must be sure that the 10 pin & 8 pin connector terminals are properly installed the terminal the display board. (See parts 6 for des

7、cription) use silver socket screw W/lock washes. Step 3: a) Servo board installed by using silver socket screw W/lock washer. Please see pig 1 wire connection on (parts 6) Step 4: a) CDP1.5 mechanism procedure: Same as CDP.3 b) Wire connection: same as the CDP.3 c) See fig .3 pad Step 5: a) Testing, cover Q.C.