Yamaha-RXV-367-Service-Manual电路原理图.pdf

1 0 11 6 7 SERVICE MANUAL IMPORTANT NOTICE This manual has been provided for the use of authorized YAMAHA Retailers and their service personnel. It has been assumed that basic service procedures inherent to the industry, and more specifi cally YAMAHA Products, are already known and understood by the users, and have therefore not been restated. WARNING: Failure to follow appropriate service and safety procedures when servicing this product may result in personal injury, destruction of expensive components, and failure of the product to perform as specifi ed. For these reasons, we advise all YAMAHA product owners that any service required should be performed by an authorized YAMAHA Retailer or the appointed service representative. IMPORTANT: The presentation or sale of this manual to any individual or fi rm does not constitute authorization, certifi cation or recognition of any applicable technical capabilities, or establish a principle-agent relationship of any form. The data provided is believed to be accurate and applicable to the unit(s) indicated on the cover. The research, engineering, and service departments of YAMAHA are continually striving to improve YAMAHA products. Modifications are, therefore, inevitable and specifi cations are subject to change without notice or obligation to retrofi t. Should any discrepancy appear to exist, please contact the distributors Service Division. WARNING: Static discharges can destroy expensive components. Discharge any static electricity your body may have accumulated by grounding yourself to the ground buss in the unit (heavy gauge black wires connect to this buss). IMPORTANT: Turn the unit OFF during disassembly and part replacement. Recheck all work before you apply power to the unit. CONTENTS TO SERVICE PERSONNEL .2 FRONT PANELS .34 REAR PANELS .510 REMOTE CONTROL PANELS .11 SPECIFICATIONS .1216 INTERNAL VIEW .17 DISASSEMBLY PROCEDURES .1820 UPDATING FIRMWARE .2123 SELF-DIAGNOSTIC FUNCTION .2448 DISPLAY DATA .4950 IC DATA .5162 BLOCK DIAGRAM .63 PRINTED CIRCUIT BOARDS .6477 PIN CONNECTION DIAGRAMS .78 SCHEMATIC DIAGRAMS .7987 REPLACEMENT PARTS LIST .8997 REMOTE CONTROL .98102 ADVANCED SETUP . 103104 AV RECEIVER 10.03 RX-V367/HTR-3063 Copyright 2010 All rights reserved. This manual is copyrighted by YAMAHA and may not be copied or redistributed either in print or electronically without permission. When the following parts are replaced, the model name and the destination MUST be written to the back-up IC (EEPROM: IC222 of the DIGITAL P.C.B.) to have proper operation. (See No. 22 SOFT SWITCH menu of the self- diagnostic function.) EEPROM (IC222) of DIGITAL P.C.B. DIGITAL P.C.B. P.O.Box 1, Hamamatsu, Japan RX-V367/HTR-3063 This product contains chemicals known to the State of California to cause cancer, or birth defects or other reproductive harm. DO NOT PLACE SOLDER, ELECTRICAL/ELECTRONIC OR PLASTIC COMPONENTS IN YOUR MOUTH FOR ANY REASON WHATSOEVER! Avoid prolonged, unprotected contact between solder and your skin! When soldering, do not inhale solder fumes or expose eyes to solder/flux vapor! If you come in contact with solder or components located inside the enclosure of this product, wash your hands before handling food. 1. Critical Components Information Components having special characteristics are marked and must be replaced with parts having specifications equal to those originally installed. 2. Leakage Current Measurement (For 120V Models Only) When service has been completed, it is imperative to verify that all exposed conductive surfaces are properly insulated from supply circuits. Meter impedance should be equivalent to 1500 ohms shunted by 0.15 F. All of the P.C.B.s installed in this unit and solder joints are soldered using the lead free solder. Among some types of lead free solder currently available, it is recommended to use one of the following types for the repair work. Sn + Ag + Cu (tin + silver + copper) Sn + Cu (tin + copper) Sn + Zn + Bi (tin + zinc + bismuth) Caution: As the melting point temperature of the lead free solder is about 30C to 40C (50F to 70F) higher than that of the lead solder, be sure to use a soldering iron suitable to each solder. TO SERVICE PERSONNEL Leakage current must not exceed 0.5mA. Be sure to test for leakage with the AC plug in both polarities. WARNING: CHEMICAL CONTENT NOTICE! About lead free solder For U model “CAUTION” “F1501: FOR CONTINUED PROTECTION AGAINST RISK OF FIRE, REPLACE ONLY WITH SAME TYPE 6A, 125V FUSE.” For C model CAUTION F1501: REPLACE WITH SAME TYPE 6A, 125V FUSE. ATTENTION F1501: UTILISER UN FUSIBLE DE RECHANGE DE MME TYPE DE 6A, 125V. WALL OUTLET EQUIPMENT UNDER TEST AC LEAKAGE TESTER OR EQUIVALENT INSULATING TABLE 2 RX-V367/HTR-3063 RX-V367/HTR-3063 FRONT PANELS 3 RX-V367/HTR-3063 RX-V367/HTR-3063 Top view Front view RX-V367 (R, K, A, B, G, F, L models) RX-V367 (U, C, T models) RX-V367 / HTR-3063 4 RX-V367/HTR-3063 RX-V367/HTR-3063 HTR-3063 (U, C, T models) HTR-3063 (R, K, A, G, F, L models) REAR PANELS 5 RX-V367/HTR-3063 RX-V367/HTR-3063 RX-V367 (U model) RX-V367 (C model) RX-V367 (R model) 6 RX-V367/HTR-3063 RX-V367/HTR-3063 RX-V367 (T model) RX-V367 (K model) RX-V367 (A model) 7 RX-V367/HTR-3063 RX-V367/HTR-3063 RX-V367 (B, G, F models) RX-V367 (L model) HTR-3063 (U model) 8 RX-V367/HTR-3063 RX-V367/HTR-3063 HTR-3063 (T model) HTR-3063 (C model) HTR-3063 (R model) 9 RX-V367/HTR-3063 RX-V367/HTR-3063 HTR-3063 (K model) HTR-3063 (A model) HTR-3063 (G, E, F models) 10 RX-V367/HTR-3063 RX-V367/HTR-3063 HTR-3063 (L model) REMOTE CONTROL PANELS Sheet (T model) 11 RX-V367/HTR-3063 RX-V367/HTR-3063 RAV331 (U, C models) RAV332 (R, T, K, A, L models) RAV333 (B, G, E, F models) SPECIFICATIONS Audio Section Minimum RMS Output Power (Power Amp. Section) (1 kHz, 0.9 % THD) U, C models (8 ohms) FRONT L/R .100 W/ch CENTER .100 W SURROUND L/R .100 W/ch R, T, K, A, B, G, F, L models (6 ohms) FRONT L/R .100 W/ch CENTER .100 W SURROUND L/R .100 W/ch Maximum Power (JEITA) (1 kHz, 10 % THD, 6 ohms) R, T, K, L models FRONT L/R .135 W/ch CENTER .135 W SURROUND L/R .135 W/ch Max. Power Per Channel (1 kHz, 0.7 % THD, 4 ohms) B, G, F, L models FRONT L/R .120 W/ch CENTER .120 W SURROUND L/R .120 W/ch IEC Power (1 kHz, 0.9 % THD, 8 ohms) B, G, F, L models FRONT L/R .95 W/ch Dynamic Power Per Channel (IHF) (FRONT L/R drive) U, C models (8/6/4/2 ohms) .110/130/160/180 W R, T, K, A, B, G, F, L models (6/4/2 ohms) .105/130/150 W Dynamic Headroom U, C models (8 ohms) .0.23 dB Input Sensitivity/Input Impedance AV5, etc. . 200 mV / 47 k-ohms Maximum Input Signal (1 kHz, 0.5 % THD, Effect on) AV5, etc. .2.3 V or more Output Level/Output Impedance AUDIO OUT (REC) . 200 mV / 1.2 k-ohms SUBWOOFER (2 ch STEREO and FRONT SP: Small) . 1 V / 1.2 k-ohms Headphone Jack Rated Output/Impedance AV5, etc. (1 kHz, 50 mV, 8 ohms) . 100 mV / 470 ohms Frequency Response (10 Hz to 100 kHz) AV5, etc. to FRONT L/R .0 / -3.0 dB Total Harmonic Distortion (1 kHz, 50 W) AV5, etc. (straight) to FRONT L/R SP OUT U, C models (8 ohms) .0.06 % or less R, T, K, A, B, G, F, L models (6 ohms) .0.06 % or less Signal to Noise Ratio (IHF-A Network) AV5, etc. (STEREO) (Input shorted) to SP OUT 250 mV . 98 dB or more Residual Noise (IHF-A Network) FRONT L/R SP OUT .150 V or less Channel Separation AV5, etc. (Input 5.1 k-ohms shorted, 1 kHz / 10 kHz) . 60 dB or more / 45 dB or more Volume Control .MUTE / -80 dB to +16.5 dB / 0.5 dB step Tone Control Characteristics BASS Boost/Cut . 10 dB / 2 dB step / 50 Hz Turnover frequency .350 Hz TREBLE Boost/Cut .10 dB / 2 dB step / 20 kHz Turnover frequency .3.5 kHz Filter Characteristics FRONT, CENTER, SURROUND (H.P.F.) .fc=40/60/80/90/100/110/120/160/200 Hz, 12 dB/oct. SUBWOOFER (L.P.F.) .fc=40/60/80/90/100/110/120/160/200 Hz, 24 dB/oct. Video Section Composite Video Signal Level .1 Vp-p / 75 ohms Component Signal Level Y .1 Vp-p / 75 ohms PB/PR .0.7 Vp-p / 75 ohms Video Maximum Input Level (VIDEO COMV. OFF) .1.5 Vp-p or more Signal to Noise Ratio (IHF) . 50 dB or more Monitor Out Frequency Response Component video signal .5 Hz to 60 MHz, 3 dB FM Section Tuning Range U, C models .87.5 to 107.9 MHz R, L models .87.5 to 108.0 / 87.50 to 108.00 MHz T, K, A, B, G, F models .87.50 to 108.00 MHz 50 dB Quieting Sensitivity (IHF) (1 kHz, 100 % Mod.) Mono .3 V (20.8 dBf) Signal to Noise Ratio (IHF) Mono .74 dB Stereo .69 dB Harmonic Distortion (1 kHz) Mono .0.3 % Stereo .0.3 % Antenna Input . 75 ohms unbalanced 12 RX-V367/HTR-3063 RX-V367/HTR-3063 Front view Top view 435 (17-1/8) 315 (12-3/8) 274 (10-3/4) 170 (6-5/8)59 (2-3/8) 45 (1-3/4) 23 (7/8) 18 (3/4) 130 (5-1/8)21 (7/8) 151 (5-7/8) 335 (13-1/4) 60 50 (2) DIMENSIONS Unit: mm (inch) Manufactured under license from Dolby Laboratories. “Dolby”, “Pro Logic”, and the double-D symbol are trademarks of Dolby Laboratories. “SILENT CINEMA” is a trademark of Yamaha Corporation. “HDMI”, the “HDMI” logo and “High-Definition Multimedia Interface” are trademarks, or registered trademarks of HDMI Licensing LLC. “iPod” is a trademark of Apple Inc., registered in the U.S. and other countries. “iPhone” is a trademark of Apple Inc. Bluetooth is a registered trademark of the Bluetooth SIG and is used by Yamaha in accordance with a license agreement. DTS and DTS Digital Surround are registered trademarks and the DTS logos and Symbol are trademarks of DTS, Inc. U .U.S.A. model C .Canadian model R .General model T.Chinese model K .Korean model A .Australian model B .British model G .European model F. Russian model L.Singapore model AM Section Tuning Range U, C models .530 to 1,710 kHz R, L models .530 to 1,710 / 531 to 1,611 kHz T, K, A, B, G, F models .531 to 1,611 kHz Antenna Input .Loop antenna General Power Supply U, C models .AC 120 V, 60 Hz R model .AC 110-120/220-240 V, 50/60 Hz T model .AC 220 V, 50 Hz K model .AC 220 V, 60 Hz A model .AC 240 V, 50 Hz B, G, F models .AC 230 V, 50 Hz L model .AC 220-240 V, 50/60 Hz Power Consumption U, C models .250 W / 320 VA R, T, K, A, B, G, F, L models .250 W Standby Power Consumption U, C, T, K, A, B, G, F models .0.5 W or less R model .1.0 W or less Maximum Power Consumption .440 W Dimensions (W x H x D) .435 x 151 x 315 mm (17-1/8 x 5-7/8 x 12-3/8) Weight .7.5 kg (16.5 lbs.) Finish RX-V367 T model .Gold color U, C, R, T, K, A, B, G, F, L models . Black color R, G, F, L models .Titanium color Silver color HTR-3063 T model .Gold color U, C, R, T, K, A, G, F, L models . Black color R, G models .Silver color Accessories Remote cont