Yamaha-HTR-6260-Service-Manual电路原理图.pdf

AV RECEIVER RX-V665/HTR-6260 IMPORTANT NOTICE This manual has been provided for the use of authorized YAMAHA Retailers and their service personnel. It has been assumed that basic service procedures inherent to the industry, and more specifi cally YAMAHA Products, are already known and understood by the users, and have therefore not been restated. WARNING: Failure to follow appropriate service and safety procedures when servicing this product may result in personal injury, destruction of expensive components, and failure of the product to perform as specifi ed. For these reasons, we advise all YAMAHA product owners that any service required should be performed by an authorized YAMAHA Retailer or the appointed service representative. IMPORTANT: The presentation or sale of this manual to any individual or fi rm does not constitute authorization, certifi cation or recognition of any applicable technical capabilities, or establish a principle-agent relationship of any form. The data provided is believed to be accurate and applicable to the unit(s) indicated on the cover. The research, engineering, and service departments of YAMAHA are continually striving to improve YAMAHA products. Modifications are, therefore, inevitable and specifi cations are subject to change without notice or obligation to retrofi t. Should any discrepancy appear to exist, please contact the distributors Service Division. WARNING: Static discharges can destroy expensive components. Discharge any static electricity your body may have accumulated by grounding yourself to the ground buss in the unit (heavy gauge black wires connect to this buss). IMPORTANT: Turn the unit OFF during disassembly and part replacement. Recheck all work before you apply power to the unit. 1 0 11 3 2 animate 09.03 P.O.Box 1, Hamamatsu, Japan Copyright 2009 All rights reserved. This manual is copyrighted by YAMAHA and may not be copied or redistributed either in print or electronically without permission. SERVICE MANUAL RX-V665/HTR-6260 CONTENTS TO SERVICE PERSONNEL .2 FRONT PANELS .34 REAR PANELS .57 REMOTE CONTROL PANELS .8 SPECIFICATIONS .915 INTERNAL VIEW .16 SERVICE PRECAUTIONS .16 DISASSEMBLY PROCEDURES .1719 UPDATING FIRMWARE .2030 SELF-DIAGNOSTIC FUNCTION .3162 DISPLAY DATA .6364 IC DATA .6583 PIN CONNECTION DIAGRAMS .8485 BLOCK DIAGRAMS .8689 PRINTED CIRCUIT BOARDS .90107 SCHEMATIC DIAGRAMS .109120 REPLACEMENT PARTS LIST .121133 REMOTE CONTROL .134136 ADVANCED SETUP .137 RadioFans.CN 收音机爱 好者资料库 2 RX-V665/HTR-6260 RX-V665/HTR-6260 This product contains chemicals known to the State of California to cause cancer, or birth defects or other reproductive harm. DO NOT PLACE SOLDER, ELECTRICAL/ELECTRONIC OR PLASTIC COMPONENTS IN YOUR MOUTH FOR ANY REASON WHATSOEVER! Avoid prolonged, unprotected contact between solder and your skin! When soldering, do not inhale solder fumes or expose eyes to solder/flux vapor! If you come in contact with solder or components located inside the enclosure of this product, wash your hands before handling food. 1. Critical Components Information Components having special characteristics are marked and must be replaced with parts having specifications equal to those originally installed. 2. Leakage Current Measurement (For 120V Models Only) When service has been completed, it is imperative to verify that all exposed conductive surfaces are properly insulated from supply circuits. Meter impedance should be equivalent to 1500 ohms shunted by 0.15 F. For U model “CAUTION” “F3701: FOR CONTINUED PROTECTION AGAINST RISK OF FIRE, REPLACE ONLY WITH SAME TYPE 6A, 125V FUSE.” For C model CAUTION F3701: REPLACE WITH SAME TYPE 6A, 125V FUSE. ATTENTION F3701: UTILISER UN FUSIBLE DE RECHANGE DE MME TYPE DE 6A, 125V. All of the P.C.B.s installed in this unit and solder joints are soldered using the lead free solder. Among some types of lead free solder currently available, it is recommended to use one of the following types for the repair work. Sn + Ag + Cu (tin + silver + copper) Sn + Cu (tin + copper) Sn + Zn + Bi (tin + zinc + bismuth) Caution: As the melting point temperature of the lead free solder is about 30C to 40C (50F to 70F) higher than that of the lead solder, be sure to use a soldering iron suitable to each solder. TO SERVICE PERSONNEL Leakage current must not exceed 0.5mA. Be sure to test for leakage with the AC plug in both polarities. WALL OUTLET EQUIPMENT UNDER TEST AC LEAKAGE TESTER OR EQUIVALENT INSULATING TABLE WARNING: CHEMICAL CONTENT NOTICE! About lead free solder RadioFans.CN 收音机爱 好者资料库 3 RX-V665/HTR-6260 RX-V665/HTR-6260 Top view Front view FRONT PANELS U model RX-V665 (U model) RX-V665 (C, R, A, F, L models) C, R, A, F, L models 4 RX-V665/HTR-6260 RX-V665/HTR-6260 HTR-6260 (U model) HTR-6260 (C model) 5 RX-V665/HTR-6260 RX-V665/HTR-6260 RX-V665 (U model) RX-V665 (C model) RX-V665 (R model) REAR PANELS 6 RX-V665/HTR-6260 RX-V665/HTR-6260 RX-V665 (A model) RX-V665 (F model) RX-V665 (L model) 7 RX-V665/HTR-6260 RX-V665/HTR-6260 HTR-6260 (U model) HTR-6260 (C model) 8 RX-V665/HTR-6260 RX-V665/HTR-6260 REMOTE CONTROL PANELS RAV290 (U model) RAV291 (C model) RAV292 (R, A, L models) RAV295 (F model) 9 RX-V665/HTR-6260 RX-V665/HTR-6260 SPECIFICATIONS Audio Section Minimum RMS Output Power (Power Amp. Section) (1 kHz, 0.9 % THD) FRONT L/R, CENTER, SURROUND L/R, SURROUND BACK L/R U, C models (8 ohms) .90 W/ch R, A, F, L models (6 ohms) .90 W/ch Maximum Power (JEITA) (1 kHz, 10 % THD, 6 ohms) R, A, L models FRONT L/R, CENTER, SURROUND L/R, SURROUND BACK L/R .115 W/ch MAX. Power Per Channel (1 kHz, 0.7 % THD, 4 ohms) F, L models FRONT L/R, CENTER, SURROUND L/R, SURROUND BACK L/R .105 W/ch IEC Power (1 kHz, 0.9 % THD, 6 ohms) F, L models FRONT L/R .90 W/ch Dynamic Power Per Channel (IHF) FRONT L/R drive U, C models (8 / 6 / 4 / 2 ohms) .95 / 110 / 130 / 150 W R, A, F, L models ( / 6 / 4 / 2 ohms) . / 100 / 110 / 125 W Dynamic Headroom U, C models 8 ohms .0.23 dB Input Sensitivity/Input Impedance (1 kHz, 100 W/6 ohms) PHONO (MM) (R, A, F, L models) . 3.5 mV / 47 k-ohms AV5 etc. . 200 mV / 47 k-ohms MULTI CH INPUT FRONT L/R, CENTER, SURROUND L/R, SURROUND BACK L/R, SUBWOOFER . 200 mV / 47 k-ohms Maximum Input Signal (1 kHz) PHONO (MM) (0.1 % THD) (R, A, F, L models) .60 mV or more AV5 etc. (effect ON) (0.5 % THD) .2.0 V or more Output Level/Output Impedance REC OUT . 200 mV/1.2 k-ohms PRE OUT . 1 V/1.2 k-ohms SUBWOOFER (2 ch stereo and FRONT SP: small) . 1 V/1.2 k-ohms ZONE2 OUT . 200 mV/1.2 k-ohms Headphone Jack Rated Output/Output Impedance AV5 etc. input (1 kHz, 50 mV, 8 ohms) . 100 mV/470 ohms Frequency Response AV5 etc., FRONT (10 Hz to 100 kHz) .0/-3 dB RIAA Equalization Deviation R, A, F, L models PHONO (MM) . 0 0.5 dB Total Harmonic Distortion PHONO (MM) to REC OUT (20 Hz to 20 kHz, 1 V) (R, A, F, L models) .0.02 % or less AV5 etc. (Pure Direct) to FRONT SP OUT (1 kHz, 50 W) 8 ohms (U, C models) .0.06 % or less 6 ohms (R, A, F, L models) .0.06 % or less Signal to Noise Ratio (IHF-A network) PHONO (MM) to REC OUT (Input shorted 2.5 mV) R model . 86 dB or more A, F, L models . 81 dB or more AV5, etc. (effect OFF) to SP OUT (Input shorted 250 mV) . 100 dB or more Residual Noise (IHF-A Network) FRONT L/R to SP OUT .150 V or less Channel Separation (1 kHz / 10 kHz) PHONO (Input shorted) . 60 dB or more / 55 dB or more AV5, etc. (Input 5.1 k-ohms shorted) . 60 dB or more / 45 dB or more Volume Control .MUTE / -80 dB to +16.5 dB / 0.5 dB step Tone Control Characteristics Bass Boost/Cut . 10 dB/2 dB, step 50 Hz Turnover frequency .350 Hz Treble Boost/Cut .10 dB/2 dB, step 20 kHz Turnover frequency .3.5 kHz Filter Characteristics FRONT, CENTER, SURROUND, SURROUND BACK small (H.P.F.) .fc=40/60/80/90/100/110/120/160/200 Hz, 12 dB/oct. SUBWOOFER small (L.P.F.) .fc=40/60/80/90/100/110/120/160/200 Hz, 24 dB/oct. Video Section Video Signal Type Gray back U, C, R models .NTSC A, F, L models .PAL Video conversion .NTSC/PAL Composite Video Signal Level .1 Vp-p / 75 ohms S-Video Signal Level F model Y .1 Vp-p / 75 ohms C .0.286 Vp-p / 75 ohms Component Video Signal Level Y .1 Vp-p / 75 ohms Cb/Cr .0.7 Vp-p / 75 ohms Video Maximum Input Level .1.5 Vp-p or more Video Signal to Noise Ratio . 50 dB or more Monitor Out Frequency Response (VIDEO CONV. OFF) Component video signal level .5 Hz to 60 MHz, -3 dB FM Section Tuning Range U, C models .87.5 to 107.9 MHz R, L models .87.5 to 108.0 MHz / 87.50 to 108.00 MHz A, F models .87.50 to 108.00 MHz 50 dB Quieting Sensitivity (IHF) (1 kHz, 100 % MOD.) MONO/STEREO. .3 V (20.8 dBf) Signal to Noise Ratio (IHF) Mono .74 dB Stereo .69 dB Harmonic Distortion (1 kHz) Mono .0.3 % Stereo .0.3 % Antenna Input . 75 ohms unbalanced AM Section Tuning Range U, C models .530 to 1,710 kHz R, L models .530 to 1,710 kHz / 531 to 1,611 kHz A, F models .531 to 1,611 kHz Antenna .Loop antenna 10 RX-V665/HTR-6260 RX-V665/HTR-6260 Manufactured under license from Dolby Laboratories. Dolby, Pro Logic and the double-D symbol are trademarks of Dolby Laboratories. DTS is a registered trademark and the DTS logos, Symbol, DTS-HD and DTSHD Master Audio are trademark of DTS, Inc. 1996-2007 DTS, Inc. All Rights Reserved. “iPod” is a trademark of Apple Inc., registered in the U.S. and other countries. Bluetooth is a registered trademark of Bluetooth SIG and is used by Yamaha in accordance with a license agreement. SIRIUS, XM and all related marks and logos are trademarks of Sirius XM Radio Inc. and its subsidiaries. All rights reserved. Service not available in Alaska and Hawaii. “HDMI,” the “HDMI” logo and “High-Definition Multimedia Interface” are trademarks, or registered trademarks of HDMI Licensing LLC. “x.v.Color” is a trademark of Sony Corporation. “SILENT CINEMA” is a trademark of Yamaha Corporation. “SILENT CINEMA” is a trademark of Yamaha Corporation. Neural Surround name and related logos are trademarks owned by Neural Audio Corporation. General Power Supply U, C models .AC 120 V, 60 Hz R model . AC 110/120/220/230240 V, 50/60 Hz A model .AC 240 V, 50 Hz F model .AC 230 V, 50 Hz L model . AC 220/230240 V, 50/60 Hz Power Consumption U, C models .270 W / 320 VA R, A, F, L models .280 W Standby Power Consumption (reference data) HDMI control: OFF / Standby through: OFF .0.2 W or less HDMI control: ON / Standby through: ON / Repeat .3 W or less HDMI co