Philips-DVP-3320-Service-Manual电路原理图.pdf
TABLE OF CONTENTS Page Version 1.0 Service Manual . Technical Specifications.1-2 . Safety Instruction, Warning 4Hz -44kHz(9 6kHz ) SV CD:4Hz-20kHz( 44. 1kHz );4 Hz-22kHz( 48kHz ) CD/V CD:4Hz-20kHz( 44. 1kHz ) Signal-Noise( 1kHz ):>90dB( A- weighted) Dynamicrange( 1kHz ):>80dB( A- weighted) Crosstalk( 1kHz ):>90dB Distortion/ noise( 1kHz ):>65dB MPEG MP3: MPEG Audio L3 Audio format Digital: MPEG/AC-3/PCM: Compressed digital( 1 6,20,2 4bitsfs,44. 1 ,48,9 6 kHz) MP3(ISO9 660 ):9 6,1 1 2,1 28,25 6 kbpsIEC6 1 9 3 7forMPEG1 /2, DolbyDigital Main unit Dimensions( wxhxd):360x3 7x209 (mm) Net Weight: approximately 1.3 kg Specification Note without notice. Accessories supplied Remote control and batteries Audio/video cables Power cable Playback media DVD-Video, Video CD/SVCD, Audio CD, CD-R/CD-RW, DVD+R/+RW, DVD-R/- R W ,PictureCD ,MP3-CD ,WMA-CD , USB Compatibility: USB Class support: UMS (USB Mass Storage Class) TV standard Number of lines: 6 25(P AL/50Hz );5 25(NTSC/ 60Hz ) Playback: Multi-standard (PAL/NTSC) Video performance VideoD A C:1 4bits,1 08MHz YPbPr:0.7V pp75ohm Videooutput:1V pp75ohm Video format Digital compression: MPEG 2: DVD/SVCD MPEG 1: VCD Horizontal resolution: D VD:720pixels(50Hz );720pixels (60 Hz) V CD:35 2pixels(50Hz );35 2pixels (60 Hz) Vertical resolution: D VD:5 7 6pixels(50Hz );480pixels (60 Hz) V CD:2 88lines(50Hz );2 40lines (60 Hz) Power P owersupplyrating:1 1 0V-2 40V ;50/ 60 Hz P owerc onsumption: button to confirm, then screen will display : Firmware Upgrade Programming, Please Wait. Do not Switch the Player Off ! 4) The upgraded disc will automatically out when files coping complete, then take out the disc. 5) About 1 minute later, the tray will automatically close when upgrading complete. B. Read out the Firmware version to confirm the upgrading 1) Power on the set and Open the tray door. 2) Press button to check the software information. The software version and other information are display on the TV screen as follows: BE Version: DVP33XX_XX.XX FE Version: XXXX.XXXXXX DSP Version: DSP.XX Region Code: X 4-1 Caution: The set must not be power off during upgrading, Otherwise the Main board will be damaged entirely. OK Cancel Region Code Change 1) Power on the set and open the tray door; 2) Press “9“ “8“ “7“ “9“ and press the regioncode number (0-6) on the remote control.Notes:restart after above steps.
