Philips-DVD-963-SA-Service-Manual电路原理图.pdf

Published by MW 0268 Service PaC©Copyright 2002 Philips Consumer EAll rights reserved. No part of this publretrieval system or transmitted, in anymechanical, photocopying, or otherwDVD-Video Player DVD963SADVD963SA /001 /171 /6917 Electrical Diagrams and Print-Layouts Diagram PWBPower Supply Unit 46AV Board: SYS Clk & Control (Diagram A1) 47 53-56AV Board: Upsampling DAC (Diagram A2) 48 53-56AV Board: Audio DAC (Diagram A3) 49 53-56AV Board: Curr to Volt. Converter(Diagram A4) 50 53-56AV Board: Audio (Diagram A5) 51 53-56AV Board: Video & SCARTFront Board: DisplayP-Scan Board: Line DoublerP-Scan Board: EncoderP-Scan Board: Video OutputStandby BoardE Printed in the Netherlands Subject to modification EN 3122 785 12330lectronics B.V. Eindhoven, The Netherlands. ication may be reproduced, stored in a form or by any means, electronic, ise without the prior permission of Philips.(Diagram A6) 52 53-56(Diagram D) 57 58-61(Diagram P1) 62 65-70(Diagram P2) 63 65-70(Diagram P3) 64 65-70(Diagram S) 71 712 Safety Instructions, Warnings, and Notes 33 Directions for Use 44 Mechanical-, Dismantling Instructions, and Service Hints 185 Diagnostic Software, Trouble Shooting and Test Instructions 216 Block-, Wiring Diagram and Testpoint OverviewBlock Diagram 41Wiring Diagram 42Testpoint Overviews 439 Circuit Descriptions 73List of Abbreviations 82IC Data 8310 Spare Parts List 87CL 26532105_000.eps280802Contents Page Contents Page1 Technical Specs and Connection Facilities 2 8 Alignments(Not Applicable) 73Technical Specifications and Connection FacilitiesEN 2 DVD963SA1.1. Technical Specifications and Connection FacilitiesPLAYBACK SYSTEMDVD VideoSACD multi channel and SACD stereoVideo CD & SVCDCD (CD-Recordable and CD-Rewritable)MP3 CDTV STANDARD (PAL/50Hz) (NTSC/60Hz)Number of lines 625 525Playback Multistandard (PAL/NTSC)VIDEO PERFORMANCERGB output 0.7 Vpp into 75 ohmYUV output Y: 1Vpp into 75 ohmPr/Cr Pb/Cb: 0.7Vpp into 75 ohmS-Video output Y: 1Vpp into 75 ohmC: 0.3Vpp into 75 ohmVideo output 1 Vpp into 75 ohmBlack Level Shift On/OffVideo Shift Left/RightAUDIO FORMATDSD Multichannel and StereoMPEG/ Compressed DigitalDolby Digital 16, 20, 24 bitsDTS/PCM fs, 44.1, 48, 96 kHzMP3 96, 112, 128, 256 kbps and(ISO 9660) variable bit rate fs 32, 44.1, 48kHzFull decoding of Dolby Digital and DTS multi channel soundAnalogue Stereo SoundDolby Surround-compatible downmix from Dolby Digitalmulti-channel sound3D Sound for virtual 5.1 channel sound on 2 speakersSACD AUDIO PERFORMANCED/A Converter DSDSACD fs 2.8224MHz DC - 100kHzMax. output voltage (0dB) 2V rmsChannel unbalance <0.5 dBCut-off frequency 50kHz (Front)40kHz (Surround, Centre,Subwoofer)Signal-Noise (1kHz) -125 dBDynamic Range (1kHz) -105 dBCrosstalk (1kHz) -120 dBTotal Harmonic Distortion (1kHz) -100 dBAUDIO PERFORMANCE (Without upsampling)DA Converter 24 bitsDVD fs 96 kHz 4 Hz - 44 kHzCD/Video CD fs 44.1 kHz 4 Hz - 20 kHzS-Video CD fs 48 kHz 4 Hz - 22 kHzfs 44.1 kHz 4 Hz - 20 kHzSignal-Noise (1kHz) < -120 dBDynamic Range (1kHz) < -95 dBCrosstalk (1kHz) < -110 dBTotal Harmonic Distortion (1kHz) < -95 dBMPEG MP3 MPEG Audio L3CONNECTIONSSCART 2x EuroconnectorY Pb/Cb Pr/Cr (480i/p) Cinch 3x (green, blue, red)S-Video Output Mini DIN, 4 pinsVideo Output Cinch (yellow) 2xAudio L+R output Cinch (white/red)Digital Output 1 coaxial, 1 opticalIEC958 for CDDA / LPCMIEC1937 for MPEG1/2, DolbyDigital, DTS6 channel analogue outputAudio Front L/R Cinch (white/red)Audio Surround L/R Cinch (white/red)Audio Centre Cinch (blue)Audio Subwoofer Cinch (black)CABINETDimensions (w x h x d) 435 x 101 x 315 mmWeight Approximately 4.6 KgPOWER SUPPLYPower inlet 110-240V, 50/60HzPower usage Approx. 30WPower usage standby < 1W* typical playing time for movie with 2 spoken languages and3 subtitle languagesSpecifications subject to change without prior noticeSpecificationsCL 26532105_050.pdf280802Safety Instructions, Warnings and Notes EN 3DVD963SA 2.2. Safety Instructions, Warnings and Notes2.1 Safety Instructions2.1.1 General SafetySafety regulations require that during a repair: Connect the unit to the mains via an isolation transformer.Replace safety components, indicated by the symbol g19, only by components identical to the original ones. Any other component substitution (other than original type) may increase risk of fire or electrical shock hazard.Safety regulations require that after a repair, you must return the unit in its original condition. Pay, in particular, attention to the following points:Route the wires/cables correctly, and fix them with the mounted cable clamps.Check the insulation of the mains lead for external damage.Check the electrical DC resistance between the mains plug and the secondary side:1. Unplug the mains cord, and connect a wire between the two pins of the mains plug.2. Set the mains switch to the 'on' position (keep the mains cord unplugged!).3. Measure the resistance value between the mains plug and the front panel, controls, and chassis bottom. 4. Repair or correct unit when the resistance measurement is less than 1 M. 5. Verify this, before you return the unit to the customer/user (ref. UL-standard no. 1492).6. Switch the unit off, and remove the wire between the two pins of the mains plug.2.1.2 Laser SafetyThis unit employs a laser. Only qualified service personnel may remove the cover, or attempt to service this device (due to possible eye injury).Laser Device UnitType : Semiconductor laser GaAlAsWavelength : 650 nm (DVD): 780 nm (VCD/CD)Output Power : 20 mW (DVD+RW writing): 0.8 mW (DVD reading): 0.3 mW (VCD/CD reading)Beam divergence : 60 degreeFigure 2-1 Class 1 Laser ProductNote: Use of controls or adjustments or performance of procedure other than those specified herein, may result in hazardous radiation exposure. Avoid direct exposure to beam.2.2 Warnings2.2.1 GeneralAll ICs and many other semiconductors are susceptible to electrostatic discharges (ESD, symbol g34). Careless handling during repair can reduce life drastically. Make sure that, during repair, you are at the same potential as the mass of the set by a wristband with resistance. Keep components and tools at this same potential. Available ESD protection equipment: Complete kit ESD3 (small tablemat, wristband, connection box, extension cable and earth cable) 4822 310 10671. Wristband tester 4822 344 13999.Be careful during measurements in the live voltage section. The primary side of the power supply (pos. 1005), including the heatsink, carries live mains voltage when you connect the player to the mains (even when the player is 'off'!). It is possible to touch copper tracks and/or components in this unshielded primary area, when you service the player. Service personnel must take precautions to prevent touching this area or components in this area. A 'lightning stroke' and a stripe-marked printing on the printed wiring board, indicate the primary side of the power supply.Never replace modules, or components, while the unit is on.2.2.2 LaserThe use of optical instruments with this product, will increase eye hazard.Only qualified service personnel may remove the cover or attempt to service this device, due to possible eye injury.Repair handling should take place as much as possible with a disc loaded inside the player.Text below is placed inside the unit, on the laser cover shield:Figure 2-2 Warning text2.2.3 NotesDolbyManufactered under licence from Dolby Laboratories. “Dolby”, “Pro Logic” and the double-D symbol are trademarks of Dolby Laboratories. Confidential Unpublished Works. ©1992-1997 Dolby Laboratories, Inc. All rights reserved.Figure 2-3 TrusurroundTRUSURROUND, SRS and symbol (fig 2-4) are trademarks of SRS Labs, Inc. TRUSURROUND technology is manufactured under licence frm SRS labs, Inc.Figure 2-4 CAUTION VISIBLE AND INVISIBLE LASER RADIATION WHEN OPEN AVOID EXPOSURE TO BEAM ADVARSEL SYNLIG OG USYNLIG LASERSTRÅLING VED ÅBNING UNDGÅ UDSÆTTELSE FOR STRÅLINGADVARSEL SYNLIG OG USYNLIG LASERSTRÅLING NÅR DEKSEL ÅPNES UNNGÅ EKSPONERING FOR STRÅLEN VARNING SYNLIG OCH OSYNLIG LASERSTRÅLNING NÄR DENNA DEL ÄR ÖPPNAD BETRAKTA EJ STRÅLENVARO! AVATT AESSA OLET ALTTIINA NÄKYVÄLLE JA NÄKYMÄTTÖMÄLLE LASER SÄTEILYLLE. ÄLÄ KATSO SÄTEESEEN VORSICHT SICHTBARE UND UNSICHTBARE LASERSTRAHLUNG WENN ABDECKUNG GEÖFFNET NICHT DEM STRAHL AUSSETSENDANGER VISIBLE AND INVISIBLE LASER RADIATION WHEN OPEN AVOID DIRECT EXPOSURE TO BEAM ATTENTION RAYO NNEMENT LASER VISIBLE ET INVISIBLE EN CAS D'OUVERTURE EXPOSITION DANGEREUSE AU FAISCEAU!Directions for UseEN 4 DVD963SA3.3. Directions for UseDirections for Use EN 5DVD963SA 3.Directions for UseEN 6 DVD963SA3.Directions for Use EN 7DVD963SA 3.Directions for UseEN 8 DVD963SA3.Directions for Use EN 9DVD963SA 3.Directions for UseEN 10 DVD963SA3.